Product

RF Detectors for Millimeter Wave

-

Marki Microwave

Marki Microwave

RF Detectors are essential microwave/millimeter wave products for most Tx (transmit sources). Transmitter output power measurement is the main application. It is essential to know the RF output power because the output power level must not go above values set by FCC regulations.The unit of power is the watt for RF detectors. But, most commonly used in most RF and wireless systems to express power is the terms of dBm or decibels related to 1 mW:View more RF Detector

Product

Millimeter Wave Antenna Testing

-

MilliBox Original

MilliBox Original

If you are involved in antenna or system level design using mmWave or THz frequencies, then you understand the importance of dependable testing equipment. It may be that you are designing passive phase array or that you are designing a mmWave radar sensor system, but when it comes to validation of your design, simulation can only bring you so far. Phased array antennas have to be measured over the air (OTA) to ensure the radiation pattern of your design efficiently conducts energy in the right direction which is where the MilliBox comes in.

Product

Millimeter Wave Converter

ZVA-Z Series

-

Radiometer Physics GmbH

ZVA-Z Series - Radiometer Physics GmbH

Millimeter-wave measurements in the V, E, W, F, D, G, J and Y band – network analysis in frequency ranges from 50 GHz to 500 GHz depending on the converter model. Featuring a wide dynamic range, the RPG converters offer high operating convenience and allow fast measurements. Two-port measurements can be performed using a four-port network analyzer and two converters; no external generator is required. When using a two-port network analyzer, an external generator is needed to supply the LO signals.

Product

Millimeter Wave Antennas

-

Ducommun Inc

Ducommun Inc

Ducommun millimeter wave products include ACH, ARH and ALC series circular, rectangular gain horn antennas and lens corrected horn antennas for system applications. Low side lobes, ridged configuration and low cost are the main features of these antennas. The standard gain value and half power beamwidth at mid-frequency point of each waveguide band are 23 dBi and 9 degrees, respectively. Other gain values are available as customer order. These antennas cover the frequency range of 18 to 110 GHz.

Product

​Millimeter-Wave Mixers

-

Teledyne Lincoln Microwave

Teledyne Lincoln Microwave

Teledyne Lincoln Microwave design and manufacture custom Single Balance Mixers for operation up to 110 GHz.

Product

Millimeter Wave Orthomode Transducers

-

Micro Harmonics

Micro Harmonics

We are developing a series of millimeter wave orthomode transducers. These orthomode transducers are fullband, compact components. They achieve astounding cross-polarization while maintaining Micro Harmonics’ impressively low insertion loss.

Product

Millimeter Wave Continuously Variable Waveguide Attenuators

-

Fairview Microwave Inc.

Fairview Microwave Inc.

Our millimeter wave variable waveguide attenuators allow designers and engineers to test their systems at various signal strengths and attenuation values to determine the optimum signal performance of the system. The key feature of these waveguide attenuators is that the attenuation level is adjusted using a built-in micrometer which enables repeatable and rapid re-setting to different attenuation levels without the need for additional external components. Our waveguide attenuators handle varying attenuation levels from 0 to 30 dB over the specified band allowing the designer to tune the attenuation level needed for the application. These continuously variable waveguide attenuators cover a broad frequency range of 33 to 110 GHz in five bands and also display flat performance across a wide band with low insertion loss.

Product

Millimeter-Wave Amplifiers

-

Mercury Systems, Inc.

Mercury Systems, Inc.

When your application requires operating at Ka-band and above, trust Mercury Systems’ millimeter wave amplifiers to perform. With standard designs up to 65GHz and custom products available, Mercury is ready to support your high frequency requirement.

Product

Millimeter Wave Control Devices

-

Ducommun Inc

Ducommun Inc

Ducommun millimeter wave products include various control devices for system integration. The CAE, CPS, CPD and CPM series control devices are discrete or MMIC based PIN diode attenuators and switches. The CAF, CAL, CAR and CPL series control devices are waveguide based mechanical tunable attenuators and phase shifters. These devices are offered to cover the frequency range from 18 GHz to 110 GHz.

Product

Millimeter-wave and Microwave GaAs Mixers

-

Keysight Technologies

Keysight Technologies

Keysight Technologies provides MMIC mixers ideal for microwave radio, aerospace and defense, and instrumentation applications.

Product

Millimeter-Wave Automated Accelerated Reliability Test Systems

nm-Wave AARTS System

-

Accel-RF Corporation

nm-Wave AARTS System - Accel-RF Corporation

AARTS fully integrated, automated, turnkey system provides flexibility and accuracy in determining RF and DC performance degradation with aging to predict life expectancy for compound semiconductor devices. Our millimeter-wave Automated Accelerated Reliability Test Systems (AARTS) and fixture solutions are available in standard frequency ranges from 26.5 to 67 GHz.

Product

Radar Systems / Millimeter Wave Radar / Micro Wave Radar

-

KEYCOM Corp

KEYCOM Corp

KEYCOM develops various radars for versatile applications based on its knowledge and expertise on millimeter wave and microwave technologies. KEYCOM’s product line of radars includes Radar Test Systems (RTS) to evaluate distance accuracy or output, Radar Alignment Systems (RAS) to help you adjust the alignment of radars, and Radar Cross Section (RCS) measurement systems to measure RCS of such radar targets as aircraft, ships and automobiles.

Product

Millimeter-wave and Microwave GaAs Diodes

-

Keysight Technologies

Keysight Technologies

Keysight Technologies provides MMIC diodes ideal for microwave radio, aerospace and defense, and instrumentation applications.

Product

Cryogenic Millimeter-Wave / Microwave Test Fixtures and Calibration Kits

upj10

-

KEYCOM Corp

upj10 - KEYCOM Corp

KEYCOM''s cryogenic millimeter-wave / microwave test fixtures and calibration kits are specifically optimized for testing the performance of patterns between the edges of printed boards(edge type) and circuit testing on the printed boards(probe type). They are also designed to minimize heat capacity by miniaturizing their dimensions so they cool off efficiently, and materials with low coefficient of linear thermal expansion such as invar are used for major parts where high dimensional stability is required. Their operating frequency ranges from DC to 110GHz.

Product

Incremental Length Gauges For Measuring Stations And Multipoint Inspection Equipment

CERTO series

-

Heidenhain Corp.

CERTO series - Heidenhain Corp.

*Interferential scanning principle*Very high system accuracy of down to ±0.03 µm*Well-matched ball-bearing guide for very high quality*Defined thermal behavior*Large measuring ranges of up to 60 mm*Interface: 11 µAPP

Product

For AIM-65, AIM-68, AIM-75S And AIM-78S

70° Barcode Scanner

-

Advantech Co. Ltd.

70° Barcode Scanner - Advantech Co. Ltd.

Black130.2 x 38.7 x 32 mm (5.13 x 1.52 x 1.26 in)0.042 kg (0.092 lb)

Product

01 With Soldering Eyelets | 12 Positions | M10 | 2 Wafers

01-2xxx-00/30xx-12-N

-

ELMA Electronic, Inc.

01-2xxx-00/30xx-12-N - ELMA Electronic, Inc.

Multi wafer compact selector with 30° detent angle, 6 mm shaft diameter, 25'000 switching cycles and with up to 6 Ncm switching torque

Product

3 Mm Disc Electrodes – Multiple Materials Available

GE-1

-

PotentioLab

GE-1 - PotentioLab

Multi-material 3 mm disc electrodes for electrochemical research and materials characterization. Available in gold (Au), platinum (Pt), silver (Ag), palladium (Pd), titanium (Ti), copper (Cu), nickel (Ni), zinc (Zn), tungsten (W), graphite, stainless steel, aluminum, lead, iron, indium, cadmium, and custom materials.

Product

OTDR

OT700 series

-

Shanghai Tarluz Telecom Tech Co., LTD

OT700 series - Shanghai Tarluz Telecom Tech Co., LTD

SM OTDR, MM OTDR, visual fault locato), PON online test, Optical Power Meter, Optical Laser Source, Fiber Microscope, Ready for all kinds of environment.

Product

Multilingual MM Antenna Analyzer

MMANA-GAL

-

MM Hamsoft

MMANA-GAL - MM Hamsoft

MMANA-GAL is an antenna-analyzing tool based on the moment method, which was introduced in MININEC. The program provides ability for changing the language of signs and messages of the program.