Product

Noise Source, 10 MHz to 26.5 GHz, nominal ENR 15 dB

346C

-

Keysight Technologies

346C - Keysight Technologies

The Keysight 346C noise source is the ideal companion to Keysight's noise figure solutions. Since it is broadband (10 MHz to 26.5 GHz), it eliminates the necessity for several sources at different frequency bands. The low SWR of the noise source reduces a major source of measurement uncertainty; reflections of test signals. Option K01 is a coaxial noise source and features coverage from 1 to 50 GHz with a 2.4 mm coaxial connector.

Product

IR Sensor

-

JonDeTech

JonDeTech

The sensor measures a very useful 0.17 mm in thickness and is made of plastic. Essentially it is a piece of robust plastic that can be used “bare” – without protective housing, such as a metal casing commonly used by other producers. The sensor it is less than 0.2 mm. thin and it is made using plastic membrane. This configuration makes the sensor so robust it can be used “bare” – without protective housing such as a metal container. Due to the fact thatSince the sensor chip can be used applied bare, means it can be used in a totally new ways, which can re-defines todays the current view on application design and reduces the cost of the entire system, and not just the sensor-element as such.

Product

Thermitest

THW-L2

-

Thermtest Instruments

THW-L2 - Thermtest Instruments

Designed with speed and operational simplicity in mind, the Transient Hot Wire (THW-L2) Liquid Thermal Conductivity Meter is an advanced measurement system for direct determination of the thermal conductivity of liquids and pastes in accordance with ASTM D7896-19. In less than 2 seconds, a single measurement of small volumes of liquids and pastes can be accurately and precisely measured for thermal conductivity. Using a non-stationary measurement approach, the THW-L2 uses rapid test times to limit convective effects for samples with a wide range of viscosities. The THW sensor consists of a 60 mm heating wire that is fully inserted into an isothermal sample. A constant current source (q) is used to heat the sensor wire and the temperature rise is recorded by monitoring the change in electrical resistance of the wire. The slope (m) is determined from the plot of temperature rise vs. logarithm of time and is used in the calculation of thermal conductivity (λ). Liquid samples of high thermal conductivity will have a lower slope, while liquid samples with low thermal conductivity will have a higher slope.

Product

High Quality UCI - And Leeb-measuring Technology

SONODUR Product Family

-

Foerster Instruments, Incorporated

SONODUR Product Family - Foerster Instruments, Incorporated

The non-destructive UCI test method (Ultrasonic Contact Impedance) as well as the Leeb test method enable fast and mobile measurement as a supplement to the classical hardness test. Due to the compact measuring probes and sensors of the SONO series, the devices can also be used in difficult test positions and with complex component geometries. Fields of application are e.g. incoming goods inspection, mix-up testing, production control, quality assurance, weld seam testing, cut edge testing, maintenance on installed components as well as the replacement of dynamic hardness testers for small material thicknesses (below 50 mm, e.g. boilers, tubes).

Product

311 HP Eddy Current Chassis Dynamometer

CM-51SR-EC

-

Taylor Dynamometer, Inc.

CM-51SR-EC - Taylor Dynamometer, Inc.

Weight Capacity: 25,000 lb (11,340 kg) per axleRoll Brakes: pneumatically-actuated discShipping Weight: 5,100 lb (2,312 kg)Capacity: 311 hp at 45 mph (232 kW at 72 kph)Rolls: 20 by 36 in. (508 by 915 mm) long, 2 fixedPit Required Depth: 25 in. (635 mm)

Product

Digital Input/Output Cards

PCI-DIO Series 24 and 48

-

Acces I/O Products, Inc.

PCI-DIO Series 24 and 48 - Acces I/O Products, Inc.

The PCI-DIO-48/48S, PCI-DIO-48JP/JPS, PCI-DIO-48JPL/JPLS, PCI-DIO-48H/HS and PCI-DIO-24S are 24- and 48-bit parallel digital input/output cards designed for use in PCI-Bus computers. The card is 6.9 inches (175 mm) long and may be installed in any 5-volt PCI slot in IBM and compatible computers.

Product

0 Hz/DC to 14 GHz, Single-Pole, Four-Throw MEMS Switch With Integrated Driver

ADGM1304

-

Analog Devices Inc.

ADGM1304 - Analog Devices Inc.

The ADGM1304 is a wideband, single-pole, four-throw (SP4T) switch, fabricated using Analog Devices, Inc., microelectro-mechanical system (MEMS) switch technology. This technology enables a small, wide bandwidth, highly linear, low insertion loss switch that is operational down to 0 Hz/dc, making it an ideal switching solution for a wide range of RF applications. An integrated control chip generates the high voltage necessary to electrostatically actuate the switch via a complementary metal-oxide semiconductor (CMOS)-/low voltage transistor-transistor logic (LVTTL)-compatible parallel interface. All four switches are independently controllable. The ADGM1304 is packaged in a 24-lead, 5 mm × 4 mm × 0.95 mm lead frame chip-scale package (LFCSP).

Product

Subminiature USB Cameras 5 Mpix Or 18 Mpix

-

XIMEA GmbH

XIMEA GmbH

*Smallest dimensions: 15 x 15 x 8 mm, 5 grams*5 Mpix,*New model with 18 Mpix*Minimal power consumption (under 1 Watt) beneficial for UAV / UAS*USB flat ribbon flex cables ideal for Embedded vision systems*GenICam/GenTL, C/C++, Python, .NET*Windows, macOS, Linux, ARM - NVIDIA Jetson TX2 and AGX Xavier*Board level available for OEM and customization

Product

Electronic Calibration Module (ECal), 50 GHz, 2.4 Mm, 2-port

N4693D

-

Keysight Technologies

N4693D - Keysight Technologies

The Keysight N4693D microwave electronic calibration (ECal) module makes calibration of Keysight vector network analyzers fast, easy, and accurate. The N4693D is a precision 2-port ECal module that supports 2.4 mm connectors up to 50 GHz. Select either female-female, male-male, or female-male connectors. The plastic storage case for the N4693D is included for securing your ECal module and accessories.

Product

PS/2 Type; ATX 400W

PS400-XP2

-

Axiomtek Co., Ltd.

PS400-XP2 - Axiomtek Co., Ltd.

*Input Range: 90 ~ 264VAC Full Range*Output Voltage:**+5V, 20A (0.5A min)**+3.3V, 20A (0.3A min)**+12V1, 16A (1A min)**+12V2, 16A (1A min)**-12V, 0.5A**+5Vsb, 2.5A (1A min)*MTBF(hours): At 25°C, 100,000h*Safety: TUV, CS22.2 NO.60950-1, IEC, UL, NEMKO+CB, CE*Dimensions: 150 x 140 x 74 mm*Compatible with Axiomtek products: AX61221/AX61222/AX60501/AX60551/AX60552/AX61400/AX6145/AX6156/AX61492/AX61220

Product

Luminescence sensors

-

Leuze electronic GmbH + Co. KG

Leuze electronic GmbH + Co. KG

Luminescence sensors detect both visible as well as invisible luminescent markings. They send the result as switching output or analog value and are used primarily for sorting and inspection tasks in areas in which other detection methods fail to supply reliable results or where the markings should not or must not be visible. Luminescence sensors are available for various luminescence colors and feature operating ranges up to 200 mm and have a very compact metal construction. The sensitivity adjustment is performed via potentiometer. Turnable M12 connector.

Product

Industrial Gas Springs – Pull Type

-

ACE Controls Inc.

ACE Controls Inc.

If ACE gas push type springs cannot be used due to a lack of space, ACE's industrial gas pull type springs come into their own. These compact assistants with body diameters of 0.59“ to 1.57“ (15 to 40 mm) are effective in the direction of traction and work in the opposite way to the principle of gas push type springs.

Product

Versatile Test Stand

VTS-2100

-

Applied Scientific Instrumentation

VTS-2100 - Applied Scientific Instrumentation

*Base is a Breadboard on 25 mm centers tapped for M6 screws with threaded holes for risers for TE/TI-2000, TE-300, IX-71/81, DMI, and MS-2000 stages.*Base feet provide vibration isolation.*Z riser is adjustable on pillar blocks.*Z motion from LS-50, LS-100, or LS-150 linear stage.*Z illumination can use LED, LED and a Condenser (from below), or fiber illumination (from above).*Observation is with a Modular Infinity Microscope.

Product

Full-Size PCI Express Mini Module With CAN Bus

AX92903

-

Axiomtek Co., Ltd.

AX92903 - Axiomtek Co., Ltd.

*USB to 1 channel CANBus port*Support CANOpen*51 x 30 mm