Product

Precision Resistance Meter

IC4

-

Holding Informtest

IC4 - Holding Informtest

Precision digital resistance meter IS4 is intended for use in an upgraded version of the TEST-9110 installation quality control system and testing on-board cable networks. The IC4 module can also be successfully used in other control and measurement systems based on the open international VXI standard.

Product

Thermo-Hygrometer

C3121P

-

COMET SYSTEM, s.r.o.

C3121P - COMET SYSTEM, s.r.o.

Thermometer, hygrometer is designed for direct measurement of temperature, relative humidity for compressed air up to 25 bars with 1m cable. Audio and optical alarm of measured values. Memory of minimum and maximum measured values. Function Hold - manual storing of actual values for later displaying.

Product

Vigilant Aircraft Hygrometer

137

-

Edgetech Instruments

137 - Edgetech Instruments

The Edgetech Instruments Model 137 Vigilant Aircraft Hygrometer is a rugged, shock mounted military qualified instrument used for the primary measurement of dew point in flight or in installations with existing flow, such as wind tunnels.It features a miniature remote dew point sensor employing a platinum resistance thermometer, and has 15 feet of interconnecting cable to the control unit. Precision calibration units for the linear analog outputs are included.

Product

Online PD Spot Tester

Liona

-

BAUR

Liona - BAUR

Cable testing and diagnostics with the BAUR liona. Liona is a portable online PD spot tester for measuring and locating partial discharges in cables and switchgear during normal mains operation. Liona lets you test cable systems and electrical equipment online without switching off partial discharge activities, and then generate trend analyses. Even a PD spot test (duration: 5-10 minutes) is capable of reliably assessing the current status of your system.* Automatic PD detection during normal mains operation (without switching off the cable route)* With DeCIFer technology: PD identification based on 500 million measurement results* Precise online PD mapping with PD transponder

Product

General Purpose Vibration Sensors

AC102

-

Semapi Corp

AC102 - Semapi Corp

Multi-Purpose Accelerometer, Top Exit Connector / Cable, 100 mV/g.

Product

RS232/422 Strobe Mux III Card & Panel

9565-32

-

Strobe Data Inc.

9565-32 - Strobe Data Inc.

32 serial port ISA compatible card connected by 4.8 ft (1.5m) cable and terminated as male DB25 connectors on external panel 14.5" high x 13" wide x 1" deep (645 x 330 x 25 mm).

Product

Overmolded Cable Harnesses

-

Teledyne Marine Cable Solutions

Teledyne Marine Cable Solutions

TCS has the ability to provide fully sealed, overmolded harnesses and harness elements as the ultimate connection for severe use, extreme weather, or resistance to water, fuels, solvents and UV rays.

Product

Advanced Ethernet Tester

LinkRunner® 10G

-

NetAlly, LLC

LinkRunner® 10G - NetAlly, LLC

Quickly test, verify, and troubleshoot 1Gig, Multi-Gig and 10Gig Ethernet (copper, fiber) including line-rate performance testing and packet captureLayer 1-7 AutoTest enables any technician to find network problemsMonitor networks for intermittent issues, every minute for up to 24 hours AllyCare-enables in-depth network discovery features and web remote controlLANBERT™ Media Qualification app tests the capability of premise cabling and media components for carrying Multi-Gig and 10Gig EthernetTwo LinkRunner 10G units can be used for line-rate performance testing to verify network capacity, performance and QoS, as well as service provider SLAs between sites

Product

System Grounding & Earthing Analysis

-

ETAP

ETAP

ETAP's system grounding & earthing foundation automatically detects the system earthing configuration based on source and transformer grounding or earthing type selection. The resulting earthing types are displayed both on the one line diagram and for the various connected cables.

Product

Cable and Harness Tester

CHT

-

Get Control, Inc.

CHT - Get Control, Inc.

The Cable and Harness Tester (CHT) provides multiple testing capabilities for up to 300 connector/harness test points. Test capabilities include DC Insulation Resistance (IR), DC and AC Dielectric Withstanding Voltage (DWV), and 2-Wire and 4-Wire Continuity.

Product

Cable Test Van

BAUR Transcable 4000/S 70-3

-

BAUR

BAUR Transcable 4000/S 70-3 - BAUR

Transcable 4000/S 70-3. The transcable 4000 70 kV 3/S cable test van varies in comparison with the transcable 32 kV - 3S in the 70 kV voltage level. The system is controlled with the MGS semi-automatic control unit. The high voltage switch unit is 3-phase, air and solid matter insulated and safe to touch.

Product

Multiplexers (MUX)

WDM

-

IXI Technology

WDM - IXI Technology

It is highly desirable to reduce the number of cables required to communicate between spaces on Navy ships due to increased weight, cost and maintenance concerns. To reduce weight and expense, copper-based NTDS parallel and serial type cables can be converted to fiber optic and multiplexed using Wavelength Division Multiplexing (WDM) technology. WDM technology allows for multiple fiber optic wavelengths to be combined in a single fiber and then separated back to individual fibers at the distant end. Using Coarse WDM (CWDM) which utilizes wavelengths 20nm apart ranging from 1271 nm to 1611 nm, provides for up to 18 optical wavelengths to be combined into a single fiber. Optionally Dense WDM (DWDM) can be used allowing for up to 160 optical wavelengths.

Product

K Thermocouple Surface Probe

TP647

-

Senseca

TP647 - Senseca

Surface thermocouple Type “K” probe. Fiberglass cable. Tolerance according to IEC 60584-2 standard.

Product

Semi-Rigid Cable, 3.5 Mm (Test Port) To 3.5 Mm

85131G

-

Keysight Technologies

85131G - Keysight Technologies

The Keysight 85131G is a 53 cm (21 in) long1 semi-rigid cable with a 3.5 mm female2 to 3.5 mm male connector. Cable frequency range is dc to 26.5 GHz with a return loss of 16 dB or better. Insertion loss is 0.3 * sqrt (f) + 0.2 dB (where f is frequency is GHz) for the test port connector, and 1.8 dB at maximum frequency for the device connector. Phase stability of semi-rigid/flexible cables is characterized with a 90 degree bend using a 4 inch radius. Stability1 of the Keysight 85131G is 0.06 dB and phase is 0.16o * f + 0.5o (where f is frequency in GHz).

Product

Fiber Assembly Eccentricity Measurement Instrument

KONCENTRIK V2

-

Seikoh Giken Co., Ltd.

KONCENTRIK V2 - Seikoh Giken Co., Ltd.

Multi-functional system for test and measurement of fiber optic ferrules & cable assemblies. Fast and automated measurements of eccentricity.

Product

50 Ohm SMB to SMA Cable Adaptor Assemblies - 3GHz

-

Pickering Interfaces Inc.

Pickering Interfaces Inc.

Pickering Interfaces offer a range of RF cable assemblies to complement our extensive range of PXI, LXI, PCI, VXI and GPIB switching products. All cable assemblies are made from high quality materials and use best practice assembly methods to ensure the cabling matches the performance of the switching modules they support.

Product

Additional Products: High Voltage 9 Pin D-Type Cables - Connector to Unterminated

-

Pickering Interfaces Inc.

Pickering Interfaces Inc.

The connector to unterminated cable assemblies below are not compatible with Pickering products, however, are offered for developing a connection solution for use with other products.

Product

Hydrophone

RESON TC 4033

-

Teledyne Marine RESON B.V.

RESON TC 4033 - Teledyne Marine RESON B.V.

​The TC4033 provides uniform omnidirectional characteristics within the full frequency range of 1Hz to 140kHz. The Typical sensitivity of -203dB re 1V/µPa and the capacitance of 7nF, ensure an excellent signal to noise ratio, thereby allowing TC4033 to be used with extension cables with only a limited reduction in sensitivity. The TC4033 offers excellent acoustic characteristics and durability, which makes it ideal for a wide range of applications and for calibration purposes.