EMI Receivers
measure conducted and radiated emissions for compliance to EMC standards.
See Also: EMI, RFI, Near Field Probes
-
product
Receiver, G20, Slide Mount, with Mounting Flanges for Pickering Chassis
310120143
Receiver, G20, Slide Mount, with Mounting Flanges for Pickering Chassis (40-908, 40-914, 40-918)
-
product
ARINC 429 Receiver
9429 RX
In addition to its wide supply voltage range from 18 V – 36 V the 9429RX module is characterized by its electrical isolation between the cRIO rack and the ARINC interface.
-
product
Receiver, G12, 12 Module, With 20" Platform, For Tabletop
310104409
Receiver, G12, 12 Module, with 20" Platform, for Tabletop
-
product
Mini Coax, Module, Receiver, 90 Series, 19 Position
510104120
Primary mating module 510108111. (May mate with other ITA modules, as well.)
-
product
Signal / Micro Power/ Micro Coax, Module, Receiver, QuadraPaddle, iCon Series, 100/15 Position, loaded w/twin female contacts
510160112
This module comes fully loaded with twin female contacts (p/n 610138200), iCon modules mount from the rear of the iCon/i1 receiver allowing installation and removal of pre-wired cable blocks. Primary mating module 510161107. (May mate with other ITA modules, as well.)
-
product
Module, Receiver, RTCASS, Signal, 210 Position Right Angle PCB Mount
510113144
Module, Receiver, RTCASS, Signal, 210 Position Right Angle PCB Mount.
-
product
Signal, Contact, Receiver, TriPaddle, 10 Amp, 14-18 AWG
610110177
Primary mating contact 610110113. (May mate with other ITA contacts, as well.)Specifications Operating Voltage & Current 10 Amps Max. Continuous (14 AWG)600 Volt Max. use of wire Mil-W-16878/4Contact Resistance 4 mOhms Max.Measured at 50 mV @ 100 mADielectric WithstandingVoltage (DWV) 1500 VDC Min.Insulation Resistance 4000 MOhms Min.Contact Body BeCuContact Plating 30µ” Au over 100µ” NiContact Termination Crimp/SolderCycle Life 20,000 CyclesRoHS Directive 2011/65/EU Status CompliantREACH Article 33 Status CompliantECHA Article 59 of Reach Regulation CompliantAVG Mating Force (lbs.) 0.41
-
product
Receiver, 9050, 50 Module, for 36" Slide Mounting Kits only
310104483
This 50 module receiver is equipped with a locking handle to ensure proper ITA engagement. A standard integrated microswitch shuts off power when the ITA disengages from the receiver. This receiver is specially designed to work with the 36" slide kit p/n 310113500 (which is required, but not included) through the use of a longer instrument bracket.
-
product
Receiver, 9075, 75 Module, Triple Tier
310104307
The 75 Module Receiver has the highest I/O mass interface available. All three tiers accommodate discrete wiring for any application. This Receiver also accepts the standard 9025, 9050 and 9075 ITAs.
-
product
Signal Module, Receiver, QuadraPaddle, 90 Series, 480 Position, Fully Loaded with Twin Female Contacts and Square Posts for Wire Wrap (610 138 200 and 610 138 118)
510150147
Primary mating module 510151106. (May mate with other ITA modules, as well.)
-
product
Coax, Module, Receiver, 40 GHz, 90 Series, 8 Position
510104224
Primary mating module 510108169.
-
-
product
Receiver, G10X, 15 Module, For Slide Mounting (requires Slide Kit)
310120208
The adaptable G10x receiver integrates a wide variety of I/O options in various module configurations of up to 15. The G10x also works with G10 ITAs and the G10x ITA for increased functionality.
-
product
Mini 4 Block Desktop Receiver
VGR4
VG Mass Interconnect products provide a common Universal interface for your custom test rack and simplifies functional test across your product line. Mass interconnect bench-top and rack mount receiver Plug and play interface blocks for signal, coax, high current, pneumatic controls, and more Stable proven products with 25 years in service Best cost of ownership Fast delivery next day on key products! Compatible to currently available test instrumentation and platformsThere are a number of different block types: Coax up to 26 GHz Power up to 150 Amps Coax and power combined Signal: up to 170 pins, @250VAC/5Amps Pneumatic: up to 13 fittings Vacuum: port modules High speed: USB 3.0, HDMI, RJ45
-
product
Signal, Contact, Receiver, QuadraPaddle, 5 Amp, 22-28 AWG, Crimp, 30µ" Au
610138216
*Please note: The difference between this p/n and 610138116 is the amount of gold plating. See below.P/n 610138116- 50µ" AuP/n 610138216- 30µ" AuPrimary mating contact 610138109. (May mate with other ITA contacts, as well.)Specifications Operating Voltage & Current 5 Amps Max. Continuous; 600 volt Max. use of wire Mil-W-16878/4Contact Resistance 25 mOhms Max.Measured at 50 mV @ 100 mADielectric WithstandingVoltage (DWV) 1500 VDC Min.Insulation Resistance 5000 MOhms Min.Contact Body BeCuContact Plating 30µ" Au over 100µ" NiContact Termination CrimpCycle Life 20,000 CyclesRoHS Directive 2011/65/EU Status CompliantREACH Article 33 Status CompliantECHA Article 59 of Reach Regulation CompliantAVG Mating Force(lbs) 0.24
-
product
EMI Testing
Independent Testing Laboratories
ITL offers compliance and qualification testing for virtually any type of electronic product or system.
-
product
Signal/Micro Power/ Micro Coax, Module Insert, Receiver, TriPaddle, i2 MX, 9/9 Position
510143004
Signal/Micro Power/ Micro Coax, Module Insert, Receiver, i2 MX, TriPaddle ,9/9 Position.
-
product
EMI Amplifiers
Overvoltage protection,shuts off above 29VOver-temperature protection,shut off above +100°CExcellent IP3 Class A amplifierVSWR Short and Open circuit protection
-
product
Signal, Contact, Receiver, TriPaddle, 10 Amp, 14-18 AWG
610110128
Primary mating contact 610110129. (May mate with other ITA contacts, as well.)Specifications Operating Voltage & Current 10 Amps Max. Continuous (14 AWG)600 Volt Max. use of wire Mil-W-16878/4Contact Resistance 4 mOhms Max.Measured at 50 mV @ 100 mAContact Body BeCuContact Plating 50µ” Au over 100µ” NiContact Termination Crimp/SolderCycle Life 20,000 CyclesRoHS Directive 2011/65/EU Status CompliantREACH Article 33 Status CompliantECHA Article 59 of Reach Regulation CompliantAVG Mating Force (lbs) 0.41
-
product
EMI Tester
The EMI tester automatically measures the noise distribution of the electric field and the magnetic field radiated from electronic equipment with high accuracy.・ Even if PCB and IC parts have complicated bumpy shape and surface. The movable assembly can automatically trace them.・ EMI noise distribution is expressed as a variety of maps, such as 4D/3D/2D graphics and cross section view.
-
-
product
Vacuum, Module, Receiver, 90 Series, 2 Port Positions w/ Filter
510104266
Primary mating module 510108242. (May mate with other ITA modules, as well.)
-
product
Mini Coax, Module, Receiver, 90 Series, 19 Positions, for use with right-angle contact (p/n 610104160)
510104319
Use with right-angle mini coax contact (p/n 610104160) for mounting to PCBs. Includes holes for PCB mounting.Primary mating module 510108111. (May mate with other ITA modules, as well.)
-
product
Signal / 20-26 GHz / 75 Ohm HD, Module, Receiver, TriPaddle, iCon Series, 64/8 Position
510160115
iCon modules mount from the rear of the iCon receiver and ITA and allow installation and removal of pre-wired cable blocks. Primary mating module 510161115. (May mate with other ITA modules, as well.)
-
product
Receiver, G20x, 28 Module, For Slide Mount, Interchangeable Handle (L Or R)
310120186
Receiver, G20x, 28 Module, for Slide Mount, Interchangeable Handle (L or R)
-
product
Receiver, G20, 20 Module, 6.75" Series Adapters, EMI
310120193
Receiver, G20, 20 Module, 6.75" Series Adapters, EMI
-
product
EMI Test System
TS9975
The R&S®TS9975 is the base system for conducted and radiated EMI measurements. Due to its modular design, it covers a wide range of applications and can be very easily adapted to the measurement task at hand. Any configuration is possible – from conducted measurements and the small precompliance system with a compact test cell to the accredited test system for large equipment under test. Combinations of different applications or incremental expansion are easily possible.
-
product
Receiver, G12, 12 Module, With 15" Platform, For Tabletop
310104408
Receiver, G12, 12 Module, with 15" Platform, for Tabletop
-
product
9050, 50 Module, Receiver, VXI and Discrete Wiring, Double Tier
310104248
This 50 module receiver is rugged and designed to accommodate high I/O. With high contact point availability, the 9050 receiver is suited for larger test and measurement systems. The top tier accommodates VXI instruments and accepts VPC's interconnect adapters with the bottom tier for discrete wiring.
-
product
Receiver, G20, 20 Module, with Mounting Flanges for Pickering Chassis
310120149
Receiver, G20, 20 Module, with Mounting Flanges for Pickering Chassis, with 20" Platform, Slide Mount
