Noise Meters
A noise meter, also known as a "sound level meter", is designed to accurately measure the "noise" or unwanted component of a signal or variable.
-
product
LUX Meter & RPM Meter
This instrument is a non-contact rotational speed meter.The meter measures the rotational speed in RPM(Revolutions Per Minute) and RPS (Revolu-tions PerSecond) with reflective markers stuck on the rotating objectto be measured.
-
product
Intelligent Digital Gauss Meter / Tesla Meter
DX-150
DX-150 Full-Digital Gauss/Tesla Meter is designed for applications requiring high precision, high-resolution magnetic field measurement. It is an intelligent solution against the traditional analog, digital table header type Gauss / Tesla meter.
-
product
Gloss Meters
Small, lightweight and durable the gloss meter can be used in production and laboratory environments. The high specifications, including statistical analysis, graphical analysis and software-free PC down load facility make it the ideal gloss meter for matt to mirror surface finishes
-
product
Vibration Meters
Portable vibration analyzer for equipment diagnosis and on-site measurements. Vibration meter with FFT analysis function.
-
product
Ultra Low Noise Preamp
J2180A
The J2180A low noise preamplifier provides a fixed, AC coupled 20dB gain while converting a 1 MOhm input impedance to a 50 Ohm output impedance. With a 3dB bandwidth of 0.1Hz to 100MHz, the preamplifier improves the sensitivity of oscilloscopes, network analyzers and spectrum analyzers while reducing the effective noise floor and spurious response. The preamplifier can also serve as a low frequency DC blocker for a spectrum analyzer or you can use it to connect a high input impedance oscilloscope probe to 50 Ohm equipment.
-
product
UV Meters
USHIO developed a UV meter series to measure intensities of UV radiation. As an add-on, the temperature is also registered. You can decide between the high-end UV meter UIT-250, and UIT-201. The former has a wider measurement range, allows the measurement of energy doses and has the capability to transfer the data via a serial communication protocol to a PC. Various sensors are available. The most popular sensors have center wavelengths at 254 nm, 365 nm or 410 nm.
-
product
Voltage Meter
МН4В
М-module МН4В is a mezzanine module designed to measure the voltage value of signals through four galvanically isolated channels (four-channel high-speed digitizer).
-
product
Voltage Meter
МН32С
The mezzanine module (mezzanine) МН32С is designed to measure instantaneous voltage values over thirty-two differential channels.
-
product
Clamp-on Meter
SAC80
Analog AC clamp on meter. Color-coded scale plate. Fuse protected ohms circuit. Hold critical or hard-to-read measurements with point lock switch
-
product
Survey Meter
ND-2200
Three Ranges 0-1000, 0-100, 0-10 mR/hr or 0-10,000, 0-1000, 0-100 uSv/hr, Rugged Dustproof Radiographic Survey Meter
-
product
Low Noise Amplifier (DC Powered)
RF Lambda’s DC low noise amplifiers (LNA) are broadband and offer low noise figure high IP3. Hermetically sealed options are available upon request.
-
product
Sound Meters
Sper Scientific sound meters include all the features and functions needed for basic noise level surveys or to meet the requirements for OSHA compliance, community noise ordinances or machine noise evaluation. These sound meters are used by: Industrial Hygienists, Sound Engineers, Construction Engineers, Municipal Code Enforcement officials, Industrial Quality Control, Environmental Scientists, and many more.
-
product
Digital Flux Meters
Digital Fluxmeter is instrument made by electronic integration principle and displays the magnetic flux digitally. It can test magnetic materials. It not only measures flux but also directly tests magnetic performance for the purpose of quality control. With the features of legible display and convenient operation, it is an ideal device for flux measurement.
-
product
Winding Resistance Meter
TRM 104
TRM104 is a portable winding resistance meter, designed to work in live EHV switchyards. Winding resistance values of large transformers up to 500 MVA and rotating machines are directly displayed. The meter is protected against the back emf offered by large inductive winding. A back-lit 4 line LCD with a user-friendly menu sets up the instrument for the test. Winding resistances and safety messages are also shown on this display. It is possible to measure the resistance of two windings simultaneously.The meter contains a special power source for rapid stabilization of test results.
-
product
100Hz-50kHz LCR Meter
Chroma 11021/11021-L
Chroma Systems Solutions, Inc.
The Chroma 11021/11021-L are the most cost-effective digital LCR Meters, providing 100Hz, 120Hz, 1kHz, and 10kHz test frequencies for the 11021 and 1kHz, 10kHz, 40kHz, 50kHz test frequencies for the 11021-L. Standard RS232 interface, optional GPIB & Handler interface, high speed and stable measurement capabilities enable the Chroma 11021/11021-L can be used for both component evaluation on the production line and fundamental impedance testing for bench-top applications.
-
product
Electronic Brake Meter
BrakeCheck
The Bowmonk BrakeCheck is a fully self-contained, portable, battery-powered brake meter that can be used by workshops, government traffic authorities, testing and inspection stations etc. to test and report on vehicle brake efficiency. The unit is MOT approved.
-
product
Humidity Meter
Shenzhen UYIGAO Electronic Technology Co., Ltd
Psychrometer Thermo Hygrometer Moisture Meter Digital Temperature and Humidity Meter with Dew Point Wet Bulb Temperature tester.
-
product
RF Milliwatt Meters
Type NDB-2 and NDB-3
National RF’s Type NDB-2 and NDB-3 RF Milliwatt Meters are affordable pieces of test equipment for both the RF laboratory and the home experimenter. Both provide a digital reading of RF power in dB reference 1 milliwatt of power into a 50 ohm load (i.e. 0 dBm). The circuitry consists of a low noise logarithmic amplifier that drives a digital A/D converting meter circuit. The lowest power levels that can be read are about –73 dBm (approximately 40 microvolts or .00000003 milliwatts). The maximum power input should not exceed 10 milliwatts (+10 dBm or .010 watts) when inputed without attenuation. An internal attenuator is provided and described in the next section.
-
product
Digital Panel Meter
DC
Laureate DC voltage and current panel meters with a DC signal conditioner board combine high accuracy with high read rate and a wide range of isolated output options for computer interface and control. Accuracy is 99.99% of full scale 1 count. Used as a direct-reading DC voltmeter, the Laureate provides a full-scale readout of 20,000 counts and six full-scale voltage ranges from 200.00 mV with 10 mV resolution to 600.0 V with 100 mV resolution.
-
product
Power Quality Meter
PQMII
The PQM II is an ideal choice when continuous monitoring of a three phase system is required. It provides metering for current, voltage, real and reactive power, energy use, cost of power, power factor and frequency. Programmable setpoints and 4 assignable output relays allow control functions to be added for specific applications.
-
product
Heat Flow Meters
Fox Series
Fox Series Heat Flow Meters are reliable, easy-to-use, and durable thermal conductivity measurement instruments. Each of our FOX heat flow meters combines advanced technology with over 20 years of superior engineering. Explore our lineup of thermal conductivity instruments.
-
product
H.V. Probe Meter
PD-40AM
Standard Electric Works Co., Ltd
● Measures positive polarity DC voltages up to 40kV.● Lightweight and rugged.● 2 available contact tips: round needle tip for normal use and a special flat spring-type for CRT anode.● Are typically used to measure high voltages in TV sets, power supplies and instruments in laboratories.
-
product
Air Velocity Meters
PCE Instruments (PCE) offers a variety of air velocity meter products to meet the air flow and wind speed measurement needs of professionals in industries such as heating, ventilation and air conditioning (HVAC), construction, marine and wind power and energy, including hot-wire air velocity meters, thermo-air velocity meters, pitot tube air velocity meters, cup air velocity meters, rotating vane air velocity meters and impeller air velocity meters with capture hoods. Plus, hobbyists such as boating, sailing and water sports enthusiasts utilize PCE's accurate and affordable digital handheld air velocity meter and portable mini air velocity meter product offerings to evaluate outdoor wind conditions. For meteorological measurements, please see PCE's weather station products.
-
product
Digital Torsion Meter
Shenzhen Chuangxin Instruments Co., Ltd.
Digital Torsion Meter: Fixed with clamp, rotation the lamp the positive and negative torque rate will be record Torque range: 0-10N.m
-
product
Clamp on Meters
2000 counts LCD displayData hold for easy readingAuto-power offSafety as per IEC1010-1, Cat.II 1000V
-
product
Moisture Meter
MMC 210 Digital Proline
This meter is designed for domestic woods. One of the features of this meter that makes it great for measuring MC in hard-to-get-to places is the Press and Hold feature. This allows the user to take a reading in a place they cannot see, such as behind a toilet, refrigerator, etc. When using the hold feature, the user can remove the meter from the item being measured and it will display the MC measured.
-
product
Advanced Panel Meter
APM
Every member of the APM meter family has unique dynamic backlighting and starburst messaging to instantly alert operators to problem conditions. We offer both DC and AC panel meter options. And the alerts, scale and range are fully customizable through the plug-and-play software.
-
product
Coating Thickness Meters
PCE Instruments' accurate, affordable coating thickness gauge, thickness meter, surface testing and film gauge devices are used for material testing, manufacturing quality control and automotive paint inspection applications. Choose from a variety of coating thickness gauge, mil gage or paint meter products used for the non-destructive measurement of nonmagnetic coating, insulating layer and dry film thickness (DFT) on ferrous and / or non-ferrous metal substrates such as steel and aluminum.
-
-
product
Protable Frequency Meter
ST-2000 Hz
Standard Electric Works Co., Ltd
● Principle : Frequency sensing transducer● Accuracy : ±0.5% of full scale value on 45 to 65 Hz range ±0.5% of full scale value on 0 to 100Hz range ±0.5% of full scale value on 0 to 500Hz range● Scale Length : Approx. 135mm (5-3/8”)● Case Material : Bakelite with glass window
