Ratio Meters
measure power's peak-to-average ratio level.
-
Product
Power Quality Meter
EPM 9650
-
The EPM 9650 is GE's most advanced 9000 meter with advanced power quality capability and waveform recording functions. The unit utilizes ACCU-Measure(R) Technology to provide highly accurate revenue grade readings coupled with advanced data analysis.
-
Product
Humidity Temperature Meters
-
TES Electrical Electronic Corp.
Triple LCD displays barometric pressure.Temperature and relative humidity.Dew point and wet bulb temperature reading.Absolute humidity, mixing ratio and enthaply reading.Water vapor pressure and water saturation pressure reading.
-
Product
Sound Level Meter
831-LOWN
-
Easily make low noise measurements to 6.5 dB A-weighted using the Model 831-LOWN sound level meter paired with the 378A04 low noise microphone and preamplifier. Due to the innovative design of the 378A04 which uses a prepolarized microphone and ICP (constant current) interface, the combination produces a highly portable system that is battery powered and intuitive to use for measuring low noise levels.
-
Product
Digital Ohm Meter
5601
-
‧Maximum Display of 33000‧Power Supply AC90V～260V, 50/60Hz‧Wide Measurement range: From 10μΩ resolution to 30MΩ full scale‧High accuracy ±0.05%‧Auto/Manual Function‧RS-232 Interface standard‧Measurement Speed 10 samples/sec.‧HOLD, REL Function
-
Product
LCR Meters
-
Sanwa Electric Instrument Co., Ltd
LCR meter is a type of electronic test equipment used to measure the inductance (L), capacitance (C), and resistance (R) of an electronic component. In the simpler versions of this instrument the impedance was measured internally and converted for display to the corresponding capacitance or inductance value.
-
Product
BOD Meter
LD-LBOD-A10
-
BOD MeterLD-LBOD-A10is a benchtop unit designed to automatically measure B.O.D. (biological oxygen demand) with 0 to 4000 mg/ L measurement range. Simple and safe mercury pressure difference measurement method is applied to prevent poisoning caused by the leakage of the mercury column. Equipped with high end brand mini thermal printer, quickly prints measurement process data, result data. Automatically saves test data on power failure and executes experimental process once power supply is on.
-
Product
Oxygen Meters
-
In the diverse PCE range you will find an oxygen meter for water and gases. We have available an oxygen meter for water for both pure oxygen content and for oxygen concentration. The oxygen meter for water and gases has a water resistant design, interface and internal data memory as well as the classical version for laboratories. The oxygen meter for gases follows the security norms and is used for detection and measurement of methane, hydrogen sulfide, carbon monoxide and oxygen (as well as 50 more gases).
-
Product
Field Meters
DG-OHM Compact
-
The DG-OHM Compact is the UNAOHM model that best responds to installers' requests regarding size, weight, ease of use, all of which, however, faithfully maintaining UNAOHM performance.
-
Product
Meters
-
Get a precision DMM, a touchscreen display, and fast, accurate digitizer: the Keithley DMM7510 7½-Digit Multimeter.
-
Product
Wireless Temperature Meter
WTM-100
-
●Measure accuracy:±1℃●Display range: -50.0~150.0℃●RS485 Modbus RTU communication port●Up to 12 channels wireless sensor connection●High stability and low cost●CE Approved
-
Product
Field Meter
AP 01 HD
-
The AP01-HD is a field meter with total coverage of the terrestrial TV bands, cable TV (CATV), 1st IF satellite and, if the relative option is inserted, the return channel 5-65 MHz.
-
Product
Automated Meter Test Set
Model 2130
-
The TransData Model 2130 is a fully automated, computer controlled electricity meter test set designed for on-site accuracy testing and revenue certification of high-accuracy, multi-function energy meters to meet rigorous PUC, Sarbanes Oxley and ISO testing requirements.
-
Product
Ultrasonic Clamp-On Flow Meter
SONOFLOW CO.55
-
The ultrasonic clamp-on flow meter SONOFLOW CO.55 detects the flow rate of liquids in flexible plastic tubes quickly and reliably. The non-invasive sensor has no contact to the medium and is particularly suited for applications with strict hygienic standards. The clamp-on mounting concept eliminates any risk of contamination or leaking.
-
Product
Micro Ohm Meter
-
TES Electrical Electronic Corp.
Best resolution. Accuracy 0.05%. 5A max test current. Manual or Auto Range. Measurement of resistive and inductive materials.
-
Product
Clamp Meters
-
Clamp meters are handheld devices with multimeter functions and able to measure AC/DC current directly without breaking the electrical conductor. Today’s clamp meters are multi-functional designed and used in HVAC/R, electrical vehicles, electrical installation, motor inspection, engineering, and many other applications. UNI-T clamp meters are well known for its performance, practicality, and reliability.
-
Product
FET DIP Meter
-
* 1.3 to 30 MHz coverage* Small 350 uA meter movement* Five coils covers HF HAM band*95 turn #36 AWG coil comes pre-assembled* Measures 5.5 x 2.5 x 1.1 inch* 9 volt battery operation
-
Product
Meter test station
TS23
-
Calmet Smart Calibration Devices
Three phase reference standard of accuracy 0.02% (or 0.04%). It makes possible electricity meters testing on the site or in the laboratory up to 3x120A/600V
-
Product
Strain Meters
-
Omega offers a large selection of Strain Meters for all strain gauge and load cell applications. All of our Strain Meters are built to deliver exceptional and accurate performance over the long-term.
-
Product
Handheld Moisture Meters
-
Since water has a dielectric constant considerable higher than any other material, even a small amount of water in a product will cause the combination dielectric constant to increase substantially. Finna Sensors' capacitance meters can easily recognize this increase in water content and are programmed to display the result in direct reading percent moisture content.
-
-
Product
Field Intensity Meter
LM870-W
-
Sichuan Jiuzhou Electronic Technology Co.,Ltd
* Trunk-line AC voltage, V/A, C/N and TILT measurable* Automatic over-voltage shut-off protection* AC/DC optional (Ni-H/Li storage battery inside)* Full-digital key-board operation, direct freq. & channel input* Automatic scanning, Automatic channel-filtering, Automatic error-operation amending* All standard channels and subjoin channels pre-set inside* New channel-table setting according to user's special requirement* Spectrum displaying* English/Chinese operation interface* Audio output (speaker set-in)
-
Product
Portable Electricity Meter Testers
EE-120A-1S
-
The EE-120A-1S unit consists of a single-phase energy standard class 0.1 and current load up to 120A. The unit performs testing of all types single-phase electricity meters using the voltage of the site. The meter error can be measured for active, reactive or apparent energy, in Manual Mode or with predefined Test Plans using the keyboard and the LCD display on the panel. Register Test, Starting Current Test and No Load Test can be performed too. The energy standard of the system can be used without the phantom load to test meters with customer load and perform analysis of the site – with direct measurement or with optional current clamps.
-
Product
Moisture Meter Digital Shopline
MMC 205
-
This moisture meter is designed for a smaller budget. Though this meter maintains the same accuracy level as other Wagner moisture meters, there is less precision displayed since MC is displayed in whole numbers only. The single button control can be more challenging to use than the dual buttons found on other meters. This moisture meter can be adjusted to accommodate different specific gravity settings between .30-.70
-
Product
Energy Meter Test Bench
GF102
-
Beijing GFUVE Electronics Co.,Ltd.
The GF102 is used to test single phase energy meter error. Adopt mature signal synthetic and power amplifier technology, high precision 500V voltage and 120A current output, accuracy 0.05%, automatically test all kinds of single phase enegy meter.
-
Product
On-Board Flow Meter
DF-2200
-
The DF-2200 On-Board Flow Meter is a compact on-board fuel flow meter developed for our FP series Volumetric Flow Detector*. The compact body is equipped with functions such as flow rate/temperature/pressure measurement and CAN communication required for fuel consumption measurement. Adopting the same size as our CT-6700 Engine Tachometer, it can be used by stacking two units in a limited space. In addition to 12 to 24VDC of power source, an AC adapter is available as an option, which is sufficient for not only on-board measurement but also engine bench evaluation.
-
Product
Clamp-On Meters
-
Rugged and professional, our complete line of clamp-on meters offer full functions including: AAC, ADC, VAC, Ohms, Continuity, Frequency, Diode Test, TRMS, %THD, %DF, CF and Peak. Varying in size, our clamp-on meters provide a solution to all power quality measurement needs.
-
Product
Moisture Meters
-
Precision Mastech Enterprises Co.
A handheld tool that measures the water content in materials like wood, drywall, concrete, and soil, typically as a percentage, to help detect hidden leaks, prevent mold, and ensure proper drying for quality control in construction, woodworking, and other industries.
-
Product
Clip-on Power Factor Meter & Watt Meter
-
Cambridge Instruments & Engineering Co.
Measurement of power factor in AC system on L.T. Circuits having higher current load without interrupting circuit.
-
Product
Acceleration Meter (Top/Side Output)
BC 111
-
*General-purpose acceleration meters with integrated electronics;*Sensitivity: 10 mV/g;*Frequency band: 1 ~15 000 Hz.
-
Product
Single-Phase Power Meters
-
Shenzhen Everbest Machinery Industry Co.,Ltd.
An electricity meter, electric meter, electrical meter, or energy meter is a device that measures the amount of electric energy consumed by a residence, a business, or an electrically powered device.
