Filter Results By:
Products
Applications
Manufacturers
Liquid Level
the height a liquid in relation to it's container.
See Also: Level, Signal Level Meters, Level Transmitters, Liquid
- Applied Instruments, Inc.
product
Satellite Signal Level Meter
Super Buddy 29
The Super Buddy 29 satellite meter has all of the great features of the standard Super Buddy satellite meter plus an internal combo 21 volt / 29 volt module to power the new DIRECTV SWM LNBs and the WildBlue / Telesat / Xplornet TRIAs! Be "sure of your bird" with the positive ID feature or use the automatic scan to identify the unknown satellite.
-
product
Level Measurement
As a market leader in level detection with the largest selection of agency approved level switch technologies, the K-TEK level products line has the proven technology to provide solutions for the most difficult liquids and solids level applications.
-
product
Pressure/ Vacuum Sensors
There are three different types of pressures that can be measured using Premier Electrosystems' Pressure Sensors: Gauge, Absolute, and Differential. Gauge pressure is the pressure measured relative to the ambient atmospheric pressure.A typical application for a gauge pressure sensor is to measure liquid levels in a vented tank using the difference in hydrostatic pressure and ambient atmospheric pressure. Absolute pressure sensors will give the result relative to zero (a perfect vacuum). This is useful in applications where there is a direct effect of altitude on the pressure being measured. Differential pressure sensors measure the difference in pressure between two points. Differential pressure sensors are often used to monitor airflow in HVAC applications.
-
product
Non-Contact Level Sensors
Omega's Non-Contact Level Sensors include Pulse Radar and Ultrasonic Transmitters for liquids, and Pulse Radar Transmitters for solids. Pulse Radar are available in intrinsically safe designs.
-
product
Vibrating Level Switch
TF 100 Series
TF-100 Series is a vibrating level switch with TF-L relay output and TF-P transistor output or with TF-T current output.This level switch is designed for reliable indication of clean liquids and light slurries. It is available with Relay, Current, and PNP outputs that can be set to indicate alarm on either high level for spill prevention, or low level for run-dry protection.
-
product
Vibration Level Measurement
Vibration technology is an excellent choice for most high or low-level liquid level measurement requirements. These products require no calibration and are not affected by changes in electrical properties of the material being measured.
-
product
Level System
Universal II
The Universal II level transmitter offers increased reliability, low maintenance and an intrinsically safe design for dependable level measurements in all kinds of process liquids, slurries, granulars and interfaces.Universal IIThe Universal II is a two wire level transmitter that eliminates the need for line power in the field and saves costs for additional hardware. It provides reliable level measurements in all kinds of process liquids, slurries, granulars and interfaces.When powered from an approved source this level transmitter can be made intrinsically safe. Its rugged contruction resists corrosion and abraision. The no moving parts design eliminates break downs.The Universal II level transmitter utilizes RF Admittance technology with manual calibration and a 4 – 20 mA output signal. The patented Cote-Shield circuitry ensures accuracy and reliability regardless of product build-up on the level transmitter.This level system is unaffected by changes in the process material density, pressure, or temperature variations.
-
product
Manometers
GAOTek has developed advanced manometers that are high quality, affordable, and accurate. They are versatile instruments designed for the measurement of different pressure levels. We have a wide variety of manometers available for measuring the pressure of both liquids and gases whilst maintaining ease of use. Manometers are used as a pressure instrument and for calibration of other instruments. They can be used to measure gauge pressure, differential pressure, and absolute pressure and are generally used to measure pressures as high as 100 inches of 2.95 Red Fluid (10.65 PSI). Our products are designed to bring users the best experience when it comes to measurement, emphasizing effectiveness and efficiency above all else, and are for sale to the United States, Canada and globally.
-
product
Sanitary Magnostrictive Level Transmitter
DM330S
The Drexelbrook DM330S is a sanitary magnetostrictive level transmitter providing Triclover fittings as standard mountings. It is authorized by 3A Sanitary Standards Council for level applications in the food and beverage industries.The DM330S takes field proven sensing technology and incorporates intrinsic safety with a field programmable zero and span.The two wire loop powered level transmitter is configurable with a 4-20 mA span and is not affected by changes in electrical characteristics.It uses proven machine tool positioning accuracy combined with a process compatible float to offer a liquid level, and interface measurement system for the process industry.
-
product
Magnetostrictive Level Measurement
Drexelbrook’s line of magnetostrictive level probes utilizes proven machine tool positioning accuracy combined with process compatible floats to offer liquid level, interface level and temperature measurements with no requirements for maintenance or calibration.
-
product
Universal OTP Functional Test System for the Production of Level and Fluid Sensors
Multifunctional function tester with parallel test function based on the LXinstruments OTP2 system platform. The system is used for assembly, final test and calibration of liquid and level sensors for commercial vehicles, construction machinery and shipbuilding in a high mix / medium volume environment.
-
product
Transmitter
5081
The Model 5081 family of transmitters can be used to measure pH, ORP, conductivity (using either contacting or toroidal sensors), resistivity, oxygen (ppm and ppb level), free chlorine, total chlorine, and ozone in a variety of process liquids.
-
product
Oil Tan Delta Test Set
The Oil Tan Delta (OTD) is a laboratory instrument, which measures the Tan Delta, Resistivity and Relative Permittivity of insulating liquids. These tests give a wider picture of the overall quality of the insulating oil, and will indicate if there is any contamination. Megger has developed features of the OTD to ensure that productivity levels within laboratories are maximised. OTD test sets are supplied with sixteen standard test sequences pre-installed, to support a set of international standards.
-
product
Liquid Level Sensors & Gauges
Model 5000
High quality liquid-level determination system intended for hydrographic, hydrologic, and industrial tank gauging applications. These gauges have earned a worldwide reputation as the most accurate and reliable instruments for long-term measurements of waves and sea states. Additional applications include boundary determination, drainage surveying, and maintenance of dam and chemical tank safety. For measurements of tide and sea state, groundwater, river stage, tank ullage and more, Aquatrak gauges provide performance unequalled in the industry.
-
product
Ultrasonic Gap Switch
2284
The Ultrasonic Gap Switch consists of Polyphenylene Sulphide (PPS) and is high corrosion resistant in most liquids. The gap switch is designed for high or low level alarm in different tank applications as well as pump control. However, if there is a liquid present, the signal will be transmitted across the gap and the integral electronics will switch the output circuitry to signal the presence of a liquid.
-
product
Flash Chromatography System for Operation up to 300 psi (20 bar)
CombiFlash NextGen 300
The CombiFlash® NextGen 300 is configurable to your needs. Like the CombiFlash NextGen 300+, active solvent and waste level sensing, along with column air purge, is standard. The system is designed for liquid injections, operating at up to 300 psi (20 bar). Similarly, RFID rack and column read can be added if desired. You determine what your needs are; don’t invest in unused or unwanted features.
-
product
Ultrasonic Liquid Level Difference Meter
HR9100L
HighReach Measuring & Controlling System Co.,Ltd
1. Stable and reliable / We select high-quality modules and key components from the power supply part to select high-stability and reliable devices, which can directly initiate imported instruments. 2, patented technology / one ring patented sound wave intelligent technology software can Carry out intelligent echo analysis without any debugging and other special steps, this technology has the function of dynamic thinking, dynamic analysis 3, high precision / sound wave intelligence owned by our company The patented technology makes the accuracy of TS-CJ ultrasonic level gauge greatly Improved, the liquid level precision reaches 0.3%, can resist various interference wavesThe instrument is a non-contact type. The meter does not directly contact the liquid, so the fault rate is lower. The meter provides a variety of installation methods, and The user can use this manual to calibrate the meter. 5. The protection level of multiple protection/instrument reaches IP65; all output and input lines have lightning protection and short circuit protection.
-
product
Liquid Level Switch
CL-10GH
The Dynatrol® CL-10GH Liquid Level Detector and EC-501A(G) Control Unit is used for high, intermediate or low point level detection of liquids and slurries. A unique vibrating principle permits design and operation features not available with other types of liquid level detectors.
-
product
Vapor Concentration Monitor
IR-300 Series
Metal-Organic Chemical Vapor Deposition (MOCVD) is widely used in the manufacture of LEDs, optical devices and other components. Liquid and solid precursors are delivered to the reaction chamber by controlling the temperature, pressure and the carrier gas flow rate (bubbling method). Process results can be affected by changes especially in temperature and liquid level. The in-line IR-300 Series measures and reports the precursor concentration in real time.
-
product
Buoyancy Level Sensors and Switches
ABB offers a complete line of buoyancy point level switches for just about any chemical, petroleum or general process application. This family of products include horizontal floats, vertical floats, and displacer switches of all kinds. ABB's simple and reliable design offers great flexibility with custom insertion lengths, temperature ratings to 1000ºF/ 38ºC. Pressure ratings to 5000 psig/345 bar, and a wide selection of alloys. The ABB buoyancy switches are the highest quality and cost efficient solution to industrial liquid level point sensing.
-
product
Capacitive Sensors
Capacitive proximity switches detect conductive and non-conductive materials that can be in a solid or liquid state. They serve the purpose of monitoring product levels in containers, checking contents in filling and packaging systems as well as detecting, positioning, monitoring and counting objects, e.g. in sequence control systems, conveyor belts.
-
product
Integrated/Separated Explosion-Proof Ultrasonic Level Gauge
HR9100E
HighReach Measuring & Controlling System Co.,Ltd
1. Safety / use of die-cast aluminum alloy waterproof, explosion-proof shell; the explosion-proof grade of the instrument reaches Exd (ia) IIBT4 2. stable and reliable / we choose high-quality module key components from the power supply Part of The Circuit Design Stable and Reliable Devices CAN Completely Replace imported Instruments. 3. Patented Technology / Ultrasonic Intelligent Software CAN with Carry OUT Intelligent echo Analysis, the without the any the debugging and OTHER Special Steps, the this Technology has The function of Dynamic Thinking, Dynamic Analysis 4. High precision / sound wave intelligent patent technology owned by our company, so that The accuracy of the ultrasonic level gauge is greatly improved, the liquid level accuracy reaches 0.3%, it can resist various interference waves, the failure rate is low, the installation is easy, and the maintenance is easy. The instrument is a non-contact instrument and does not directly contact with liquid. Users can use this manual to calibrate the instrument. 6. The protection level of multiple protection/instrument reaches IP65; all output and input lines have lightning protection and short circuit protection.
-
product
Dynatrol® Liquid Level Switch
CL-10RH
The Dynatrol® Type CL-10RH Liquid Level Detector and EC-102B or EC-103C Control Unit is used for high, intermediate or low point level detection of liquids and slurries. This is typically a replacement unit for existing CL-10RH units in the field. The CL-10GH is phasing out the older style liquid level detector.
-
product
L31 Series Heavy Duty Vertical Multi-Station Stainless Steel Liquid Level Switch
L31
As many as six level control points and up to 72” in overall length. Mount at the top or bottom of a tank. It can be fully customized. Typically found in potable water, hot water, acids, and various solvent applications.
-
product
Coupled Cavity TWTs
Communications & Power Industries
• Frequencies from 2.7 to 37.5 GHz• Peak levels: 500 W to 180 kW• Cooling type: air, liquid, conduction• Depressed or grounded collectors• CW (Continuous Wave) and Pulsed
-
product
Water Detection Sensor
EZ-10
Panasonic Industrial Devices Sales Company of America
The EX-10 is a special Thru-Beam Sensor that was designed for two purposes; to check fluid levels and to detect the level of liquids containing water. The emitter on the EX-10 Sensor uses a particularly strong IR beam to not only penetrate transparent, but also semitransparent or colored containers such as PFA packages or shampoo bottles. Also, the sensitivity of the Sensor is adjustable to allow it to focus on a target, such as distinguishing foam from liquid in drinks, as an example.
-
product
Liquid Level Switches
L70 Series
Miniature in size, allowing for use across a wide range of industrial applications. Highly compatible with numerous liquids.
-
product
Capacitance Sensors
Designed for continuous level measurement of conductive, non-conductive liquids and other fluid types. Available in many sizes and with a variety of features.
-
product
Digital Stik Liquid Level Sensor
7250
The 7250 Series digital stiks take field proven magnetostrictive sensing technology and packages it for greater reliability and easier installation. This liquid level sensor is ideal for liquid level monitoring, interface level and leak detection in a variety of liquid media in above ground and underground storage tanks. It was designed to meet EPA Leak Detection and API Inventory Monitoring requirements and has been approved for use in hazardous environments.The 7250 Series is series has an inherently lower cost design which results in savings. It provides the same performance and reliability as sensors that consume more power.
-
product
Cryogenic Probe Station
CryoPro
Materials Development Corporation
The MDC Model 441 Cryogenic Probe Station is a cost effective alternative to high-priced vacuum based cryogenic probe stations. With up to five probes available and sample diameters up to six inches, the MDC Cryogenic Probe Station allows for electrical measurements at temperatures near liquid nitrogen levels (77K).
-
product
Radar Level Transmitter
DR5400
DR5400, FMCW 24 GHz open air radar is a market entry level transmitter for liquids in basic process applications. This model has proven PP Drop antenna design which is insensitive to condensation.
