Optical Choppers
Intercept current or beams of radiation on a periodic basis.
See Also: Lock-in Amplifiers
-
product
Advanced Automated Optical Inspection (AOI)
V510i Optimus 3D
V510 has high productivity, the superior detection capability and inductory fastest inspection speed. It is by High Speed Multi Frequency Phase Shift Profile technology and simultaneous inspection method of 2D/3D. V510 can inspect that without influencing the surface condition and the warp of the board by unique lighting technology.By much algorithm, inspevtion of the component smoothness and the very small component is possible.
-
product
Optical Oxygen Sensors
The analyzer is suitable for direct field installation (NEMA 4X) in hazardous area (Class I, Division 2). The optical fiber sensor platform allows small inline sensors to be installed into sample tubing lines (1/4”), flow cells using NPT fittings, or directly into tanks or process lines using our retractable “hot tap” sensor design. BOS optical oxygen sensors are impervious to typical O2 poisons (H2S) and interferences (combustibles, magnetic, CO2 and H2) with high accuracy and long-term stability measurements without the need for complex or advanced sample conditioning systems. The threaded version of the optical sensor has optional Dual Seal (ANSI/ISA 12.27.01) classification for high pressure applications up to 1200 PSIG (82.7 BAR).
-
product
Outdoor AGC Optical Node
SR812B
Hangzhou Softel Optic Co., Ltd.
SR812B optical receiver is our new development products that especially used in CATV network. The pre-amp adopts GaAs MMIC amplify module and the post-amp adopts GaAs power doubler amplify module .Support specifical attenuation and equalization inserts if you want.Or as per customer, adopts other module.With optimization design and plentiful technical experience that made this equipment with high performance specification. It is a ideal model for CATV network.
-
product
FTTB Out-door AGC Optical Receiver
BG9244x-LE
Hangzhou Huatai Optic Tech. Co., Ltd.
Huatai BG9244 is a type of out-door optical receiver . The product builds-in RF interstage gain adjustment and equalization. Users can choose one-way or two-way high output level with the insert. The product is used in FTTB, FTTN, FTTC and used as a Rx unit of CATV. It is a type of receiver with high flexibility, excellent performance and P/P ratio.
-
product
PXI/PXIe MEMS Optical MUX, 4-Channel, Multi-Mode, 62.5/125 Fiber
40-850A-214-M62.5-HI
The 40/42-850A-214-M62.5-HI is a PXI/PXIe 4-channel multiplexer with SC/PC connectors, includes hardware interlock and is part of Pickering's range of PXI Fiber Optic MEMS Switching modules. They are available in many high density formats with a choice of different connector styles to suit most applications: FC/APC (for optimal performance), FC/PC and SC/PC for general applications and LC and MU for high density applications.
-
product
Special Fiber Optics
Shanghai Tarluz Telecom Tech Co., LTD
Optical fibers which have at least one special property, distinguishing them from standard fibers.
-
product
Optics Test Systems
Contract Measurements And Services
Optik Elektronik Gerätetechnik GmbH
Thanks to our very good laboratory equipment, we offer contract measurements for numerous measuring tasks. In the field of optics, measurement and testing technology, these are, for example, the parameters MTF, focal length, radius, contact dimension, focal length, geometric and optical parameters of cylindrical lenses. Others on request.
-
product
Optical Fiber 16×1 Switch
OFSW - 16 × 1
Hangzhou Huatai Optic Tech. Co., Ltd.
OFSW- 16×1 is a 16×1 prism optical switch. It can support 16 optical fibers input and 1 fiber output, channel switch. Wide operating wavelength range, low insertion loss and speedy switching rate, can use network trends configuration, network monitor and lab application.
-
product
LXI Optical Switching
LXI is an ideal platform for supporting optical switching systems; the use of Ethernet control makes it easy to provide optical switching within the network that is easy to control via a programmatic or web based interface. MEMS switch technology offers higher performance and longer operational life compared to conventional prism based optical switching.
-
product
Optical Laser Source Products
Tunable Laser Source, Compact Tunable Laser Source, Fabry-Perot Laser Source Modules and Distributed Feedback Laser Source Modules.
-
product
Optical Fiber Identifiers
Shanghai Joinwit Optoelectronic Tech,co.,Ltd
Joinwit Optical Fiber Identifiers
-
product
Low Power SNMP AGC FTTB Optical Receiver
BGL2000
Hangzhou Huatai Optic Tech. Co., Ltd.
Huatai BGL2000 product series, is a low power consumption, high index, with SNMP network management, AGC, full function FTTB optical receiver. 2000 series' shells are structure compact aluminum wall hung ( without rain-proof ), RF interface horizontal output, Nixie tube displaying parameters. RF Overlay interface can be optional for IP/QAM and EOC insert, also can used for local program insert.
-
product
Optics Test Systems
Scientific Instrument Engineering
Optik Elektronik Gerätetechnik GmbH
Development, design, manufacture and assembly of opto-mechanical assemblies and complete devices, including software.
-
product
PXI/PXIe MEMS Optical MUX, 4-Channel, Multi-Mode, 50/125 Fiber, FC/APC Connectors
42-850A-014-M50
The 40/42-850A-014-M50 is a PXI/PXIe 4-channel multiplexer with FC/APC connectors and is part of Pickering's range of PXI Fiber Optic MEMS Switching modules.
-
product
Optical Noise Analyzer
A0040A
Optical Noise Analyzer is the industry first solution for evaluation of optical frequency noise of lasers as power spectrum density.
-
product
Fiber Optic Sensor & Amplifier
FG-1300 | FS-5500/FS-540
The FG-1300 is a non-contact type high-performance amplifier that emits red light from LED to a rotating object, and detects the variation of the reflected red light amount.This amplifier is used in combination with an exclusive detector FS-5500*/FS-540 Fiber Optic Sensors which has adopted environment resistant design. The glass fibers are covered with flexible stainless steel tube for rotation measurement in limited space.
-
product
FTTH Optical Node
SRXG-2020AW
Hangzhou Softel Optic Co., Ltd.
SRXG-2020AW, the operating bandwidth of 47~1000MHz, is a low power, high performance, cost-effective triple play, FTTH CATV optical receiver, Whether used in analog television or digital television. Products with high sensitivity optical receiver tube and special low noise matching circuit. Receiving at high optical power can be adjusted by PAD level, played limiting output, so SRXG-2020AW within a large dynamic range of the received optical power of +2 dBm ~-21dBm, have excellent characteristics.
-
product
4-Port Serial Interface, Modular, With/Without Optical Isolation, 3.3V
CPCI-7500
*This Model has a 37-pin D-Sub male connector*RS232, RS422, RS485, 20 mA Current Loop*Modular structure through SI modules*With or without optical isolation*Mode configuration free for each port*128-byte FIFO-buffer, common interrupt*Transfer rate programmable up to 115,200 Baud*Option: up to 1 MBaud for RS485 and RS422*Automatic direction recognition for RS48*Mode: configurable RS232, RS422, RS485, 20 mA Current Loop (active, passive) with or without isolation (SI modules)*Transmission mode asynchronous, full, half duplex*Transfer rate: progr. up to 115.2 kBaud up to 1 MBaud on request*Protocol: 5, 6, 7 or 8-bit character 1, 1? or 2 stop bits*Parity: even, odd, none, mark or space*Interrupt lines: automatic through BIOS
-
product
32 Channel Optically Isolated Digital Card
104-IDIO-16
The Model 104-IDIO-16 is a 32-channel PC/104 utility board featuring 16 optically isolated inputs and 16 optically isolated solid state outputs. The isolated, non polarized inputs may be driven by either DC sources of 3-31V (or higher by special order) or AC sources at frequencies of 40Hz to 10KHz
-
product
Optical Talk Set
TM4103N
TM4103N Optical Talk Set is an intelligent and efficient instrument that combines in one set the functions of both a digital optical phone and a stabilized light source. It is widely used in operations of installation, optical testing, maintenance and fiber attenuation value testing in data network, CATV and Telecommunication network. The TM4103 Talk Set can carry out full-duplex communication with high quality connection and not be affected by distance.
-
product
Field-of-View Systems - VisionGauge Digital Optical Comparators
300 Series
The 300-Series VisionGauge Digital Optical Comparator Field-of-View Systems are extremely cost-effective systems that are ideal for smaller parts. Automatically compare parts to their CAD data with our proprietary CAD Auto-Align and CAD Auto Pass/Fail tools, in seconds. Instantly computes and displays deviations-from-nominal and out-of-tolerance areas. No operator-to-operator variation. Extremely fast & easy-to-use! Needs no overlays, templates or Mylars. Full automated measurement capability
-
product
Optical Emission Spectrometers
Optical emission spectrometers (OES) and the measuring principle of the atomic emission are the ideal method and provide the perfect instrumentation for metal analysis in all different industrial businesses and environments.
-
product
Optical Emission Spectrometer
PDA-7000
Emission spectrometry provides rapid and accurate simultaneous determination of many elements in metals. This technique has been adopted as standard method for metal analysis. The Shimadzu PDA-7000 is high performance optical emission spectrometers, utilizing the PDA method as standard, which enhances the accuracy and reliability of analysis. The PDA method, combined with excellent hardware quality, make the PDA-7000 suitable for any application in metal analysis. They enhance analysis productivity in quality control and process control in the ferrous and non-ferrous metal industries.
-
product
EPON OLT ( Optical Line Termination )
OLT-1840
Hangzhou Huatai Optic Tech. Co., Ltd.
OLT-1840's Optical Line Terminal (OLT) adopts GiGA Ethernet Passive Optical Network (EPON) technology. It is a compact chassis with L2/L3 GiGA switching and routing function. All the functional components are modularized design and it supports hot-plugging with plugging and playing. 1~8 pieces of GiGA optical port or electrical port are optional in the uplink port, which provides a direct optical interface for the Ethernet/IP network core. 40 pieces of EPON optical port are optional in the down link port. Through a passive optical Network (PON), an optical Network unit link (ONU),it can provide final transmission with bandwidth up to 1Gbps for the user.
-
product
PXIe Optical Test Modules
Coherent Solutions’ expanding portfolio of PXIe optical test modules bring a wide range of new mixed-signal test capabilities to the PXI platform. The new modules offer seamless integration with PXI Platform and deliver reliable and repeatable results across a wide range of optical and mixed-signal test applications.
-
product
Ethernet To Fiber Optic Converters (Point To Point)
Our rugged, industrial-grade, point-to-point Fast and Gigabit Ethernet to fiber optic converters work in pairs to extend 10/100/1000M Ethernet signals over long distance. These Fast and Gigabit Ethernet to fiber optic converters have been designed for harsh industrial environments and withstand a wide temperature of -40°F to 185°F (-40°C to 85°C), and they come with the options of multi-mode and single-mode, and ST, SC, FC, and SFP connectors.
-
product
Dual 2 X 2 Channel Optic Mux 850nm Multi
40-810-124-M
Pickering PXI Fiber Optic Multiplexers connect a single channel to one of two or four channels. They are available in single or dual multiplexer configurations supporting single-mode or mult- mode fiber.A wide choice of connectors types is available. The 40-810 multiplexer connects the optical channel by redirecting the optical signal into a selected output fiber.
-
product
Automated Optical Inspection System
506
We are proud to introduce the latest member of our model 505 AOI product family, the 506. This system was developed to provide a high coverage, easy to program AOI system for the larger backplanes / backpanels being produced today.
-
product
Handheld Optical Power Meter
JW3233
Shanghai Joinwit Optoelectronic Tech,co.,Ltd
Handheld Plastic Optical Power meter is the newest product of our copmany, which is used for testing the Optical power with the wavelength range 600-1000nm, the unit is w, dBm, with high resolution.There are 5 calibration wavelengths 635nm、650nm、780nm、850nm、980nm, both Linearity or nonlinearity could show the optical power, it can be used for testing Optical power of short wavelenght.
-
product
1.6T Optical Receiver Test Application
N4917DJCA
Offers fully automated stress eye calibration and receiver testing for 800G and 1.6T modules with 100G and 200G / λ optical interfaces.
