Filter Results By:
Products
Applications
Manufacturers
Polarization Mode Dispersion
Polarization Mode Dispersion
-
product
Measurement System
2800
The 2800 Chromatic Dispersion Measurement System provides fast, accurate measurements of chromatic dispersion and length of all types of single-mode optical fibers. Easy to use Windows-based software provides all industry standard calculation techniques for the determination of zero dispersion wavelength and dispersion slope. Options are available for the measurement of Polarization Mode Dispersion (PMD) and Fiber Strain.
-
product
Polarization Conditioners
High-speed software controlled polarization control and polarization scrambling with broad wavelength coverage, low insertion loss and back reflection.
-
product
Polarization Maintaining Fiber Components
OZ Optics offers a broad range of polarization maintaining components, patchcords, and connectors designed to resolve polarization problems, which are becoming increasingly important in today's higher speed and more complex mesh optical networks. By maintaining the polarization of the signal at its source, our polarization maintaining components minimize polarization mode dispersion and eliminate the effect of polarization dependent loss thereby increasing the quality of the signal that is transmitted throughout the network.
-
product
Dispersion
Dispersions are often used in latex wall paints, which can thus be diluted with water. The homogenity of a dispersion depends on size and weight of particles. To determine the size of particles the use of a Fineness of Grind gauge or grindometer is needed. For proper mixing and / or stirring a variety of laboratory and industrial tools are available depending on volume or capacity.
-
product
Dual Polarized Horn
ZLB7-SJ18-40G-833
Dual Polarized Horn, Frequency 18~40GHz, Gain12dBi, VSWR 2.0, Dual Polarization, 2.92mm-Female
-
product
Polarization Series
Shanghai Joinwit Optoelectronic Tech,co.,Ltd
Joinwit Polarization Series
-
product
Common Mode Chokes
Common Mode Chokes, as the name implies, are designed to attenuate and filter common mode noise within an electric system. The key parameters for a common mode choke are the current rating (to ensure the part does not overheat within the application), the impedance versus frequency (to ensure it is optimized to attenuate the desired frequencies), the isolation voltage (to ensure it meets board level requirements between the line and neutral phases) and safety isolation (to ensure it meets the safety requirements of the end-application). It is important to remember that common mode chokes cannot saturate in the application (under normal use) as they are designed to ensure that the line and return currents are balanced.
-
product
Polarity Test Sensors
P-FINN
The P-FINN is a cost effective method of identifying object presence and/or orientation, and/or color. The key to the design is simplicity.
-
product
Dual-USB3 Polarization Cameras
Celera P Series
Standard digital monochrome sensors capture light intensity and wavelength for each pixel: however, some applications require the inspection of polarized light to get relevant information.Instead of using external polarizing filters, Alkeria developed CELERA P, a new camera model featuring a special polarization image sensor.Thanks to its unique array of polarizer filters overlaid on top of the sensor's pixel array, CELERA P gets rid of all the external polarizing filters, combining the ease-of-use of the Alkeria USB3 cameras with the advanced capabilities of polarization imaging and unique FusionView feature.
-
product
Mixed Mode Testing
The Mixed Mode add-on modules for the Random Vibration Control Software allow tests to run with sine tones and/or narrowband random signals superimposed on a random background. Mixed mode testing is a complex control task, and m+p VibControl supports three modes: Sine-on-Random (SoR), Random-on-Random (RoR) and Sine-on-Random-on-Random (SoRoR). Gunfire burst control can also be superimposed in each case.
-
product
High Speed Polarization Controller
JW8601
Shanghai Joinwit Optoelectronic Tech,co.,Ltd
In order to satisfy the demand of system integration, Joinwit design the 3rd generation polarization controller PolaRITEIII. PolaRITEIII has lower thickness and smaller size and it plays an important role in the integration of testing instruments, optical fiber sensors, fiber lasers and optical modules. The device has a special temperature characteristic. This device can be integrated, and required output polarization state can be obtained by digital or analog signal control.
-
product
Polarity Tester
PT5
PT5 Polarity Tester supporting testing of up to 24 single-mode or multimode fiber MPO or ribbon cables.
-
product
Polarity Indicator Circuit Tester
CT8007
No ground wire means no wire tangles nor time lost searching for grounding points. High Impedance electronic circuitry. Negligible current draw ( 1 microampere) is 30,000 times less than regular lamp type testers. This gives complete safety when working around sensitive electronic control modules and sensors. Operating range between 6 and 28 Volt DC in battery powered systems
-
product
Polarization Lambda Scan Software License
N7700100C
Enables polarization-dependent swept-wavelength multichannel measurements with the PAS LS engine and PAS IL/PDL engine, as well as measurements without varying polarization with the PAS LS engine and PAS FSIL engine.
-
-
product
Energy Dispersive X-ray Fluorescence Spectroscopy Consumables
Energy Dispersive X-ray Fluorescence Spectroscopy Consumables
-
product
Loudspeaker Polar Measurements
Polar Test Chamber
For accurate and repeatable polar measurements of loudspeaker drive units, smart speakers, soundbars and active systems
-
product
Dispersive X-ray Fluorescence Spectrometer
SPECTRO MIDEX
SPECTRO Analytical Instruments GmbH
The SPECTRO MIDEX is known to be an all-round talent for the fast, non-destructive analysis of small spots and the rapid mapping of large surfaces (up 233x160 mm, 9.2x6.3’’) in research and development as well is in compliance screening applications as many elemental analysis tasks in industry, research and the sciences require a non-destructive measuring system that is extremely sensitive and offers a small measuring spot.
-
product
Tube-Above Wavelength Dispersive X-ray Fluorescence Spectrometer
ZSX Primus IV
As a tube-above sequential wavelength dispersive X-ray fluorescence spectrometer, the new Rigaku ZSX Primus IV delivers rapid quantitative determination of major and minor atomic elements, from beryllium (Be) through uranium (U), in a wide variety of sample types — with minimal standards. ZSX Guidance supports you in all aspects of measurement and data analysis. Can accurate analysis only be performed by experts ? No — that is in the past. ZSX Guidance software, with the built-in XRF expertise and know-how of skilled experts, takes care of sophisticated settings. Operators simply input basic information about samples, analysis components and standard composition. Measured lines with the least overlap, optimum backgrounds and correction parameters (including line overlaps) are automatically set with aid of qualitative spectra.
-
product
Polarization Controller
Shenzhen Golight Technology Co.,Ltd
Polarization controller integrates an all-fiber dynamic polarization controller and a mini piezoelectric ceramic actuator. As a polarization controller, it can convert any input polarization state to the desired polarization state output. As a polarization scrambler, it can effectively disrupt the output polarization state.
-
product
Transformer Polarity Tester
PMT20030
Power Measurement Technologies Inc.
A hand held instrument for polarity identification of current, voltage and power transformers with an operable ratio range from 1:1 to greater than 5000:1.
-
product
Polarization Maintaining Fused Wavelength Division Multiplexer (
Zhongke Rayzer Optical Technology Co.,Ltd
Polarization Maintaining Fused WavelengthDivision Multiplexer product, has thecharacteristics of low insertion loss, high handing power, high extinction ratio and double-axis operation. It is mainly used in the fields of polarization-maintaining fiber laser, polarization-maintaining amplifier, polarization-maintainingsensing system and scientific research application.
-
product
Energy Dispersive X-ray Fluorescence Spectrometer
EDX-LE
EDX-LE is an X-ray fluorescence spectrometer designed specifically for screening elements regulated by RoHS/ELV directives. The model uses a detector (Si-PIN semiconductor detector) that does not require liquid nitrogen, thereby achieving lower operation cost and easier maintenance. Automated analysis functions improve operability without sacrificing its high level of inspection reliability. The time required from start of measurement to judgment is as short as one minute for some samples, which is very helpful in screening inspections for elements regulated by the RoHS directive.
-
product
Energy Dispersive Spectroscopy (EDS) Detector Technology
EDS
The Element SDD is a solutions based detector, which excels at basic analysis. Focused primarily on serving the needs of the industrial market segment, it provides application specific software and analysis that can quickly provide answers in the industrial environment.
-
product
Polarization Extinction Ratio Measurement
Rapid & Accurate measurement for PER, Angle, and Power. The most suitable light source for PER measurement.
-
product
Linear Polarization Resistance (LPR) Monitoring
The electrochemical technique, commonly referred to as Linear Polarization Resistance, is the only corrosion monitoring method that allows corrosion rates to be measured directly, in real time. Although limited to electrolytically conducting liquids, the response time and data quality of this technique make it clearly superior, where applicable, to all other forms of corrosion monitoring.
-
product
Polarization Maintaining Circulator(PMCIR)
Zhongke Rayzer Optical Technology Co.,Ltd
non-reciprocating, one-directional, three port deviceswhich are great for bi-directional propagation of light in a Polarization Maintaining fiber. These optical circulators are ideal for advanced communication systems, fiber sensor and fiber laser applications.
-
product
Firmware for High-speed HDLC Mode
OP-FW10G
OP-FW10G is an expansion firmware to upgrade LE-3500 measuring Bit-Synch (HDLC/SDLC/X.25/CC-Link) and SPI communications up to 10Mbps. Hardware processing by FPGA built in the analyzer makes it possible to capture data with time stamp at micro second. It is useful to analyze SPI communications and High-speed HDLC communications such as RS-485 multi-drop CC-LINK and TTL signal level on the printed-circuit board.
-
product
Polarity & Burn in Test Systems
Our polarity and burn-in test systems are available for components such as multilayer, disc type or hollow ceramics.
-
product
Polarizing Beamsplitter (PBS)
Polarizing beamssplitters split randomly polarized beams into two orthogonal, linearly polarized components. S-polarized light is reflected at a 90 degree angle while P-polarized light is transmitted. Polarizing beamsplitters come in cube form, but custom geometries are available.
