Product

16 Channel Precision High Voltage (420VMAX) Isolated Instrument

EX1402

-

AMETEK VTI Instruments

EX1402 - AMETEK VTI Instruments

The VTI Instruments EX1402 adds isolation and high-speed measurement capability to the popular EX1400 Series of instruments, an advanced, full-featured data acquisition family designed to acquire precision data from voltage sensors. The EX1402 delivers accurate and highly repeatable voltage measurements by implementing fully integrated signal conditioning, 24-bit ADC’s, on a per-channel basis.

Product

Voltage Tester, 12V to 1000V, Light

72-2980

-

Tenma

72-2980 - Tenma

Non-Contact Voltage Detector Handy accessory detects presence of AC voltage from 12V ~ 1KV, providing clear audio and visual indication. Five segment bargraph display shows relative voltage level. Built in LED flashlight provides added convenience in poorly lit environments.

Product

Voltage Controlled Phase Shifters To 3200 MHz

-

Pulsar Microwave Corporation

Pulsar Microwave Corporation

Pulsar's Voltage Controlled Phase shifters utilize a DC voltage to control the phase of the RF signal applied. These phase shifters utilize varactor diodes to produce the necessary phase requirements. Phase of the 180 and 360 degree designs are available, and phase can be controlled with a DC voltage 0-20 Vdc. Modulation of these phase shifters is typically 100 kHz, and maximum input power is +5 dBm.A wide variety of package styles are available, such as plug-in, flatpack, TO-cans, and connectorized housings, though the most popular are the miniature surface mount packages. Surface mount packages are available on tape and reel, for automated assembly techniques.

Product

1 MHz Bandwidth Voltage Preamplifier with Bandpass Filter

EC6081 mk2 - preamplifier

-

Teledyne Marine RESON B.V.

EC6081 mk2 - preamplifier - Teledyne Marine RESON B.V.

The EC6081 mk2​ (VP2000) is a 1MHz bandwidth voltage preamplifier with bandpass filter that is designed for uses in conjunction with piezoelectric hydrophones. VP2000 offers excellent low-noise performance over the entire frequency range; and adjustable gain selection. A range of 12 high-pass and 12 low-pass filters are available, these allow ideal band pass filter settings.

Product

JFET Voltage Preamplifier

SIM910

-

Stanford Research Systems, Inc.

SIM910 - Stanford Research Systems, Inc.

The SIM910 and SIM911 are low-noise, programmable preamplifiers which are ideal for a wide range of small signal applications. The primary differences between the two models are their input impedance and input noise. 

Product

High Voltage Thick Film Chip Resistors

HVTK (HVR)

-

RARA Electronics Corporation

HVTK (HVR) - RARA Electronics Corporation

*Highly reliable multilayer electrode construction*Higher component and equipment reliability*Excellent performance at high voltage*Reduced size of final equipment

Product

Low Voltage Products and Systems

-

ABB Ltd.

ABB Ltd.

ABB provides a full range of low voltage solutions to connect, protect, control and measure a wide range of electrical installations, enclosures, switchboards, electronics and electromechanical devices. The business improves the reliability and efficiency of its customers’ activities across all major industries including the residential sector.

Product

2.5 GHz, 0.9 pF, 1 MOhm Active Voltage Probe

ZS2500

-

Teledyne LeCroy

ZS2500 - Teledyne LeCroy

Engineers must commonly probe high frequency signals with high signal fidelity. Typical passive probes with high input R and C provide good response at lower frequencies, but inappropriately load the circuit, and distort signals, at higher frequencies. The ZS Series features both high input R (1 MΩ) and low input C (0.9 pF) to reduce circuit Loading across the entire probe/oscilloscope bandwidth. The ZS2500 is ideal for 2.5 GHz and lower oscilloscopes.

Product

Non-Contact Voltage Tester

1AC II

-

Fluke Corporation

1AC II - Fluke Corporation

The portable 1AC II non-contact voltage tester from Fluke are easy to use – just touch the tip to a terminal strip, outlet, or supply cord. When the tip glows red and the unit beeps, you know there's voltage present. Electricians, maintenance, service, safety personnel, and homeowners can quickly test for energized circuits in the workplace or at home and even detect miswires of an electrical outlet.

Product

High Voltage 37 Pin D-Type Cables - Connector to Unterminated for Pickering Products

-

Pickering Interfaces Inc.

Pickering Interfaces Inc.

The connector to unterminated cable assemblies below are suitable to use with Pickering cards and modules that utilize a high voltage 37-pin D-type connector.

Product

Dielectric Withstanding Voltage Test

-

Aero Nav Laboratories, Inc.

Aero Nav Laboratories, Inc.

The dielectric withstanding voltage test (also called high-potential, over-potential voltage-breakdown, or dielectric-strength test) consists of the application of a voltage significantly higher than rated voltage for a specific time, between mutually insulated portions of a component part or between insulated portions and ground. This is used to prove that the component part can operate safely at its rated voltage and withstand momentary over-potentials due to switching, surges, and other similar phenomena.

Product

AC Voltage Sensors

-

DARE Electronics

DARE Electronics

Continuously monitor single or three-phase power lines for over or under voltage conditions with DARE?s AC voltage sensors, voltage monitors, and voltage sensing relays. DARE?s complete line of AC Voltage Sensors will protect system equipment and circuitry from voltage that is hazardous or unsuitable for operation.

Product

Acute High Voltage Differential Probe, 50x/500x, 25MHz, 3500V

ADP5025

-

TEAM SOLUTIONS, INC.

ADP5025 - TEAM SOLUTIONS, INC.

*USB Powered (or Power Bank)*Bandwidth up to 25 MHz*Overrange Indicator*Audible Overrange Alarm*Bandwidth Limit : 5 MHz / Full*Can be used by any DSO which has the USB port(s).*EC Declaration: EN 61010-031:2002 +A1:2008*Double-layer wire for power insulation

Product

Linear Power Supplies Voltage Stabilizer/Current Limiting, Ultra Low Ripple/Noise

Series JQE

-

Kepco, Inc.

Series JQE - Kepco, Inc.

Series JQE power supplies are systems-type voltage stabilizers with current limiting. They are available in a variety of ratings: 100 watts in a 1/4-rack package, 250-500 watts in a 1/2-rack package, and 1000 watts in a full-rack package. These power supplies offer ultra low noise and ultra low ripple at the output. They are MIL-STD-461 compliant.The traditional analog meters (M Models) have been replaced by digital meters on DM models. Availability of models with analog meters is limited and they will be discontinued in the future.

Product

High Voltage 50 Ω Pulse Generator

TLP-8010A

-

High Power Pulse Instruments GmbH

TLP-8010A - High Power Pulse Instruments GmbH

*Wafer and package level TLP/HMM testing*Fast 50 Ω high voltage pulse output with typical 300 ps rise time*Up to 80 kW peak output power into 50 Ω load*Built-in HMM pulse up to ±15 kV with 50 Ω-configuration*High pulse output current up to ±80 A (short circuit) with 6 dB reflection suppression*High speed 50 Ω trigger output for oscilloscopes (synchronous to high voltage pulse output)*6 GPIB programmable pulse rise times: 300 ps to 50 ns*1 built-in pulse width: 100 ns*Optional external pulse width extensions 5/10/50/100/200/500 ns using an external pulse width extender TLP-8012A5*Fast measurement time, typically 0.2 s per pulse including one-point DC measurement between pulses*Efficient software for system control and waveform data management*The software can control automatic probers for fast measurements of complete wafers*High performance and high quality components

Product

Lock-In Voltage Preamplifier

SR552

-

Stanford Research Systems, Inc.

SR552 - Stanford Research Systems, Inc.

The SR552 Voltage Preamplifier is designed to work with SRS lock-in amplifiers, providing gain where it is needed most?right at the experiment. The preamplifier minimizes noise and pickup in the connecting lines and can reduce measurement time in noise-limited experiments. 

Product

Acute High Voltage Differential Probe, 20x/200x, 25MHz, 1400V

ADP2025

-

TEAM SOLUTIONS, INC.

ADP2025 - TEAM SOLUTIONS, INC.

*USB Powered (or Power Bank)*Bandwidth up to 25 MHz*Overrange Indicator*Audible Overrange Alarm*Bandwidth Limit : 5 MHz / Full*Can be used by any DSO which has the USB port(s).*EC Declaration: EN 61010-031:2002 +A1:2008*Double-layer wire for power insulation

Product

AC VOLTAGE MEASUREMENT (AC or AC + DC TrueRMS) Digital Multimeter

1320

-

Topward

1320 - Topward

± 199.9mV, ± 1.999V, ± 19.99V, ± 199.9V, ± 1200V, 5 Ranges, AC VOLTAGE MEASUREMENT (AC or AC + DC TrueRMS)

Product

High Voltage Film Capacitors (Axial Leads)

STVHF/STVHE-A

-

HK Film Capacitor Ltd

STVHF/STVHE-A - HK Film Capacitor Ltd

For High Pulse / High Energy Discharge applications with low discharge repetition rate, please tell more about your application. We might have a suggestion.

Product

Third Rail Voltage Tester

4E2-1

-

TESCO

4E2-1 - TESCO

The Knopp 4E2-1 Voltage Tester is designed to detect electrical potential (voltage) between the third rail and ground on high voltage electrified transit systems. Two, redundant neon bulbs are used to indicate the presence of voltage. The prod handle and the tester housing are both made from moisture- and oil-resistant laminated phenolic. The prod tips are made from stainless steel. The tester housing includes a rubber hand guard to guide the operator in proper placement of his or her hand. There are no exposed metal parts other than to the two prod tips. All internal connections are soldered.