Product

Multi-Band Quad-Channel Receiver/Combiner, 4U Rack Mount System with Integral Tracking Receivers and Bit Syncs

LS-28-QRS

-

Lumistar Inc.

LS-28-QRS - Lumistar Inc.

Lumistar offers the LS-28 series of high performance multi-band multi-mode RF Receiver/Combiners in several different versions including rack mount, portable and modular formats. Complete solutions from RF to bits and/or RF to UDP data broadcast in Chapter 10 format are available. Available at any frequency range from 215 MHz to 6000 MHz, data rates to 50 Mbps.

Product

Software-Defined Radio (SDR)

Fobos

-

Rig Expert Ukraine Ltd.

Fobos - Rig Expert Ukraine Ltd.

The Fobos SDR is a high-performance SDR receiver with a 100 kHz to 6 GHz range, 14-bit sampling, and 50 MHz bandwidth, with dual conversion and two HF channels.

Product

2-Port Optical Tunable Filter

-

Optoplex Corporation

Optoplex Corporation

Optoplex's Tunable Optical Filter, also known as Optical Tunable Filter or Tunable Bandpass Filter, is an integrated module, consisting of micro optics and electronics. When receiving a stream of optical signals of a plurality of wavelengths from the Input-Port (IN), the 2-port tunable optical filter directs a selected channel to the Output-Port (OUT). The selected channel can be varied (tuned) within the operating wavelength (frequency) range by a remote command sent through the built-in control PCB and firmware.

Product

Two-Way Time Transfer (SWSTFT) Satellite Time and Ranting Equipment (SATRE)

TWSTFT

-

TimeTech GmbH

TWSTFT - TimeTech GmbH

- 1 – 3 receiver channels- Automated measurements- Operates unmanned, 24 / 7- Remote control over TCP/IP- Data transfer via TWSTFT link from remote site- Sub-nanosecond precision TWSTFT with real time results- Internal measurement database for the last three months on a one minute basis

Product

PCIe Basic Protocol Tx and Bus Monitor

Sy629PCIe-BPM

-

Sycos AES

Sy629PCIe-BPM - Sycos AES

The Sy629PCIe-BPM card provides a convenient means for transmitting and receiving data over an ARINC 629 bus in accordance with the transmit and receive programme defined by data written into the XPP and RPP memory.

Product

RX Pre-Amplifier System

RAM-34

-

Array Solutions

RAM-34 - Array Solutions

The RAM-34 is a complete pre-amplifier system designed primarily for the low bands 160M thru 40M. It has inputs for four receive antennas and internal 3-pole bandpass filters for 160M, 80M and 40M. In addition to the pre-amplifier, it has a step attenuator that togetherwith the amplifier stage provides gains from -20 dB to +20 dB in 5 dB steps. This allows equalizing the signal levels between the antenna inputs. Gain settings are memorized for each antenna on each band. Different types of receive antennas have different signal levels and the gain memories eliminate the need to adjust the receiver or pre-amplifier when switching between the antennas.

Product

Cable Assemblies

-

VPC

VPC

VPC Cable Assemblies provide a reliable interconnect between the instrument and receiver interfaces. Connector‑to‑connector cable assemblies are also available.

Product

Antenna, Omni-Directional Wideband Discone

EM-6105 | 10 KHz – 2 GHz

-

Electro-Metrics Corp.

EM-6105 | 10 KHz – 2 GHz - Electro-Metrics Corp.

The EM-6105 is a broad band collinear array allowing very wide Omni-Directional frequency coverage in a single package. Below approximately 100 MHz, the EM-6105 acts as an active vertical rod which offers 10 to 12 dB more signal handling capability than competitive antennas (overload field strength: 2 V/meter) which greatly reduces intermodulation generated signals in a typical read world RF environment. In the congested spectrum above 100 MHz the antenna is passive and contributes no intermodulation products so the overload point is determined solely by the receiving instrument. This immunity to overload can often make the difference between useful signal output and an indecipherable jumble of spurious products and is accomplished without compromising sensitivity. The antenna collapses for convenient storage and transport. The EM-6105 is supplied with an EM-6106 Battery Pack.

Product

Wireless Transmission

-

Aguard Electronics Co., Ltd

Aguard Electronics Co., Ltd

Wireless transmission is a form of unguided media. Wireless communication involves no physical link established between two or more devices, communicating wirelessly. Wireless signals are spread over in the air and are received and interpreted by appropriate antennas.

Product

Test Antennas

-

Lumistar Inc.

Lumistar Inc.

Lumistar provides small, lightweight portable fixed antennas for Test applications. They are available in lower L thru S bands for transmit and receive applications.

Product

FlexRay Communications Expansion Kit

OP-SB88

-

LINEEYE Co., Ltd.

OP-SB88 - LINEEYE Co., Ltd.

The FlexRay communication is anticipated as a next-generation high-speed in-vehicle network.The OP-SB88 is an expansion kit that allows monitoring of FlexRay communications on up to two channels in real time. The kit incorporates a monitor function that does not require complicated parameter settings, and a simulation function with which the OP-SB88 works as a FlexRay communications node to transmit and receive data, thus powerfully supporting the initial development. The filter function and high-capacity memory greatly shorten the analysis time of trouble.

Product

"Signal Transporter"

LTX-5525

-

Scitec Instruments Ltd

LTX-5525 - Scitec Instruments Ltd

The LTX-5525 conveys sixteen independent channels of digital information over a fibre optic link ranging from metres to more than 10 kilometres. Each of the 16 incoming TTL channels is sampled 100 million times per second, multiplexed and transmitted serially over an optical fiber at two gigabits per second. The receiver acquires this digital data and de-multiplexes it to 16 separate output ports.

Product

Optical Probes - Low Bandwidth

-

Tektronix, Inc.

Tektronix, Inc.

Depend on Tektronix to provide you with performance you can count on, and industry-leading service and support.*Broad Wavelength Response 500 to 950 nm or 1100 to 1700 nm*High-bandwidth DC up to 1.2 GHz*High Gain 1 V/mW*Low Noise <11 pW/√Hz*Probe Connects to DPO7000*1 and DPO/DSA/MSO70000*2Series*SONET/SDH and Fibre Channel Reference Receiver Performance

Product

PMC-Serial

-

Dynamic Engineering

Dynamic Engineering

The PMC-Serial is capable of providing multiple serial protocols, both synchronous and asynchronous with a wide range of baud rates. The PMC-Serial has up to 8 UART channels, and two SCC channels. The protocol processors are complemented with a variety of IO which can be selected as a build option. RS-232, RS-485, RS-422, and RS-423 are supported. Two enhanced hysteresis MIL STD 188-114A receivers, and two open drain active low output drivers are also provided. 

Product

Bluetooth Vibration Sensors / Bluetooth Accelerometers

-

Erbessd Instruments, LLC

Erbessd Instruments, LLC

A Bluetooth Vibration Sensor is an Accelerometer capable of recording vibration data and transfer it to a receiver using Bluetooth standard protocol. These sensors usually integrate an accelerometer and a bluetooth transmitter to establish wireless connectivity. Hence having the capability to connect via peer to peer or mesh network.

Product

PXI Switching Instrumentation

-

Marvin Test Solutions, Inc.

Marvin Test Solutions, Inc.

Marvin Test Solutions’ switch card portfolio includes matrix, multiplexer, and RF multiplexer configurations. 3U and 6U PXI switch cards feature easy to use, reliable, and integration-friendly D-sub style interface connectors – a feature unique to Marvin Test Solutions PXI switch cards. GENASYS switch cards are compatible with MTS’s family of GENASYS Switching and Switching/Digital Subsystems, featuring integrated MAC Panel SCOUT receivers.

Product

Signaling Control and Monitor Equipment

MS 1303

-

Meltronics Systemtech

MS 1303 - Meltronics Systemtech

The Railway signaling unit is used to receive the input signals from the field for validating and clearing route for trains. After receiving the signals, signals are isolated and various tests are done inside the system to ensure the received signals reliability and produce clearance signal to railway line. For security reasons card signature has been given to each card in the system. System consists of digital input modules, digital output module, digital read back module, RS232 interface with 80486 processor board. It is an ISA Bus Back plane based system.

Product

Receiving Amplifiers

-

Kuhne electronic GmbH

Kuhne electronic GmbH

he products from Kuhne electronic from the category "Receiving Amplifiers for Professional Use" are designed for the following applications: Radio Link Systems, Satellite Receivers as well as Scientific and Measurement Instrumentation.These amplifiers stand out due to outstanding Noise Figures as well as a very good Large Signal Stability and small Housing Sizes.

Product

USRP Software Defined Radio Reconfigurable Device

-

NI

NI

The USRP Software Defined Radio Reconfigurable Device is built on the LabVIEW reconfigurable I/O (RIO) and universal software radio peripheral (USRP) architectures. It includes a powerful FPGA for advanced DSP that you can program with the LabVIEW FPGA Module. The device includes 2x2 MIMO transceivers or four-channel superheterodyne receivers, supporting center frequencies from 10 MHz to 6 GHz, with up to 160 MHz of instantaneous bandwidth. The USRP Software Defined Radio Reconfigurable Device also optionally includes a GPS‐disciplined oven-controlled crystal oscillator (GPSDO), which provides greater frequency accuracy than temperature- compensated crystal oscillators. Prototyping applications include LTE and 802.11 prototyping, spectrum monitoring, signals intelligence, military communications, radar, direction finding, and wireless research.