Filter Results By:
Products
Applications
Manufacturers
- Taylor Dynamometer, Inc.
product
1100 HP Water Brake Chassis Dynamometer
TD-24
AC power, air and water required at one side wallas applicable.• Room length, and pit location within length,must be determined by user to fit maximumtruck length and rear overhang.• Provide at least one man door for fire escapenear rear of room, but not in rear wall becausesomeone entering during a test could be struckby a stone flung from a tire. Provide ample fireextinguishers at each door and near driver.• “Back-on, Drive-off” installation configurationpreferred
-
product
IPX9K Rain Spray Testing Chamber / Rain Resistant Test Machine
CX-IP9K
Shenzhen Chuangxin Instruments Co., Ltd.
Water Spray Test Equipment is used to test the water resistance; which is mainly for electronic and electrical products. It can also provide references for product design and quality control.
-
product
IEC60529 Ipx56 Water Spray Test Device
IPX56A
Shenzhen Chuangxin Instruments Co., Ltd.
The ipx5/6 rain testing machine is designed according to IEC60529 standard.
-
product
IEC60529 Ipx6 Water Spray Nozzle
CX-IPX5-6
Shenzhen Chuangxin Instruments Co., Ltd.
IPX5/IPX6 Jet Nozzle Test consists of a jet handle that is equipped with a pressure gauge and an easy-to-adjust flow valve.
-
product
Walk in chamber for Complex Salt Spray Test (Temperature controllable)
Guangdong Bell Experiment Equipment Co.,Ltd
Walk in chamber for Complex Salt Spray Test Relevant standards requirement1. Test Object: battery pack andsystem.2. Refer GB/T4 part 5.5.2 test method, test according to GT/T2423.17 test conditions.3. The salt solution was made up with sodium chloride (chemically pure and analytically pure) and distilled or deionized water，Its concentration is (5 + 1)% (mass fraction).4. (35 ± 2) ℃, the measured pH value is between 6.5-7.2.5. Placed the test objects in the salt spray chamber for cycling test. Each cycling duration for 24h. Spray salt solution to the test object for 8 hours under the temperature of (35± 2) ℃ , remain for 16 hours. Between the forth and the fifth hour in one cycles should be according to test requirement in GB/T 28046.1-2011, test mode with 3.2.6. Total 6 cycles testing.7. Salt spray test is not necessary for the test objects being installed in passenger, luggage or cargo compartments.
-
product
UL Rain Spray Test Device With Nozzle
CX-UL56
Shenzhen Chuangxin Instruments Co., Ltd.
UL rain spray test device with nozzle Size:500*800*2000mm((adjustable height 1000~2000mm)Nozzle water column intersection from the ground height 0-1400mm adjustable
-
product
IEC60529 IPX3/4 Oscillating Tube Spray Water Test Chamber
Shenzhen Chuangxin Instruments Co., Ltd.
IEC60529 IPX3/4 oscillating tube spray water test chamberWorkshop:60*60*60 cm / 100*100*100 cm
-
product
IPX3/4 Swing Pipe Rain/ Water Spray Chamber
Shenzhen Chuangxin Instruments Co., Ltd.
Ipx3/4 Swing Pipe Rain/ Water Spray Chamber 1. Item name: Ipx3/4 Swing Pipe Rain/ Water Spray Climatic Chamber
-
product
IPX3 IPX4 Rain Test System
CX-RIP3/4
Shenzhen Chuangxin Instruments Co., Ltd.
For checking the protection against water with spray nozzle of 0,4 mm bore are used to prove the degrees of protection for the second characteristic numerals 3 and 4 “Protection against Spraying Water” resp. “Protection against splashing Water”.
-
product
IP Waterproof Test Equipment
Shenzhen Bonad Instrument Co., Ltd.
BONAD’s IP waterproof test equipment is divided into nine common waterproof levels according to international and national standards, namely IPX1, IPX2, IPX3, IPX4, IPX5, IPX6, IPX7, IPX8 and IPX9. In addition, there are many different comprehensive rain test chambers, whether it is the common nine instruments or customized spray chambers, charging pile water spray tests or energy storage cabinet spray tests. For more information, please contact us, BONAD will provide you with professional technical advice and high-quality testing equipment.
-
product
Water Spray Tester
K10640
Chongqing Kailian Yongrun Industrial Co.,Ltd.
To evaluate the ability of a lubricating grease to adhere to a metal surface when subjected to direct water spray under controlled conditions;Conforms to SH/T0643, ASTM D4094
-
product
IPX5 IPX6 Water Spray Test Device
CX-IPX56B
Shenzhen Chuangxin Instruments Co., Ltd.
Drop rain rain chamber Uses: This equipment is main to test the physical and other related properties of the products in the environment of simulated rain, such as electronic and electrical products, lamps, electrical cabinets, electrical components, automobiles, motorcycles and their parts and components. After the test, through the test result to determine
-
product
IEC60529 IPX3 IPX4 Brass Water Spray Nozzle For Hand Sprayer
CX-IPX34
Shenzhen Chuangxin Instruments Co., Ltd.
The IPX3-4 Spray Nozzle is a hand-held test device to verify protection against spraying and splashing water.
-
product
Hydrogen Leak Tester
T8999
T8999 is a tool designed to meet the increasing need for easy and clean identification of the position of the leak on a piece being tested, therefore eliminating the need for methods such as water tank immersion or use of leak detecting sprays, which are harmful for the pieces which could develop rust or pieces that are difficult to accurately clean.
-
product
Environmental Simulation Testing
Innovative Testing Solutions, Inc.
We have multiple chamber capabilities of simulation most environmental conditions. Our chamber range in capacity from 1 ft3 to 64 ft3 volume. Specialty chambers include air-to-air thermal shock, inert gas injection oven, high/low pressure water spray and direct-injection LN2 chambers.
-
product
Rain Spray Test Environmental Chamber
Guangdong Bell Experiment Equipment Co.,Ltd
DGBell’s rain spray test environmental chamber is also known as rain spray test chamber, it is used to test the water resistance for electronic and electrical products, such as solar lights, garden lights, buried lights, tunnel lights, car lights, fountain lights, the display…etc. It can also provide references for product design and quality control.
-
product
Moisture Test Chamber
The chamber features a self-contained water recirculation system that eliminates the cost and inconvenience of plumbing in a facility water supply. Water is injected into the test enclosure through specifically-sized nozzles. Flow meters with adjustment valves supply the spray at specified flow parameters. A rotating test platform can be incorporated to promote even moisture distribution over the surface of the products under test.
-
product
IP66 Rated Mass Flow Controllers
I-Series
I-Series Thermal Mass Flow Controllers are designed specifically for mass flow controller applications in harsh environments to protect against water and dust. The IP66-rated enclosure for I-Series Mass Flow Controllers protect it from direct water spray as well as dusty environments.
-
product
IP X5, X6 - Walk-In Rain Test Chamber
WEIBER designs and manufactures standard as well as customized water spray test chamber for evaluating various automotive, electrical and electronics items under water, rain or shower conditions. The chamber interrogates the performance of parts when subjected to water droplets.The system is based on the IP X5, X6 specification requirements, and can also accomplish individual automaker’s tests, as well as electrical-enclosure tests.Our system uses multiple control solenoids to vary the water's spray volume/pressure. A holding tank prepares the water to the desired temperature, if required. A pump ensures the water is delivered in the proper pressure range.
-
product
IEC60529 IPX34 Hand Held Spray Nozzle
IPX34
Shenzhen Chuangxin Instruments Co., Ltd.
The Spray Tester IPX 3/4 is a hand-held test device to verify protection against spraying and splashing water. The water pressure can be adjusted using the flow control knob on the device to give the required flow rate.
-
product
Salt Water Spray Test Chamber
CX-H60L
Shenzhen Chuangxin Instruments Co., Ltd.
The salt water Spray Tester is used to create and maintain the salt spray (fog) test environment, and test the anti-corrosion quality of the materials surfaces, and is suitable for researching materials, light industry, electronic, instrumentation and other industries etc.
-
product
Salt Spray Tester
The Salt Spray Tester – Salt Spray Cabinet – Chamber – Fog Apparatus is used to create and maintain the salt spray (fog) test environment, and test the anti-corrosion quality of all the materials surfaces after the rust-proof of painting, coating, electroplating, anodizing and rust-proof of greasing. Our salt spray testers available in two capacities meet ASTM-B117, JIS-D0201, JIS-H8502, JIS-H8610, JIS-Z2371 and other International Standards test methods. Power supplied can be configured upon request.
-
product
Salt Spray Testing
Salt Spray testing (Also known as Salt Fog testing) is often used for testing the corrosion resistance of metallic products, or for testing the corrosion resistant coating applied to metallic products, in order to verify that they will function properly when exposed to salt corrosion. This specific type of testing is used as a means to accelerate the salt corrosion exposure in order to gather data on the long or short term effects of salt corrosion on the product or coating material.
-
product
Salt Spray Test Chambers
Labodam salt spray test chambers are reliable instruments for testing the corrosion resistivity of products with painted, organic, or inorganic film surface.
-
-
product
Water Detectors
No home should be without a Zircon Leak Alert™ electronic water detector. Place it near sinks, water heaters, sump pumps, and washing machines and find out about leaks before they cause major water damage.
-
product
Composite Salt Spray Test Chamber
YWX/Q-010X
Composite Salt Spray Test Chamber stimulate the actual natural conditions to do accelerated corrosion test, all the testing are based on common states on the natural environmental: such as combine with salt spray, hot air drying, humidity, low temperature and so on. The test samples are widely used on the intense changes in the environment, like automobile parts, aviation equipment, building materials, coating, electric and electrical machinery so on. YWX/Q-150X series is full compliance with ASTM D4728I, EC 60068-2-1, IEC 60068-2-14 and EIA/JEDEC JESD22-110-B standard requirements etc.
-
product
Water Detect Click
MIKROE-2786
Water Detect click is used for detecting water and other electroconductive liquids. If the detection area is wet the output of Microchip's MCP606 CMOS op-amp will go positive, signaling the presence of liquid. You could use it on one of our clicker 2 development boards, with GSM 4 click, or any other from the wireless range, and create a home flood alarm. Any time Water Detect click detects water it will send you an SMS.
-
product
Spray Equipment
Engineered for the most demanding automotive and industrial refinishing bodyshops through to the smallest independent workshop - whatever your spraying requirements, Sagola has the gun you need.
-
product
Water Accumulation Unit
WXU
An integrated unit that integrates the flow sensor and valve of the circulation circuit of the cooling water.The complicated piping design around water and the number of man-hours for piping work are greatly reduced, and the footprint is reduced by 80% to save space in the system.
-
product
Water Iron Analysis
Aztec AW633
The Aztec 600 colorimetric iron analyzer provides reliable and accurate measurement of iron concentrations to improve drinking water quality and optimize chemical usage.
