Filter Results By:
Products
Applications
Manufacturers
-
product
4U 5-Slot CompactPCI® Chassis with Redundant Power Supplies
cPCIS-6400U Series
The cPCIS-6400U/6400X Series subsystems are designed for 6U cPCI boards with 80mm RTMs. The chassis is 4U in height and standard 19" rack mount width.
-
product
3U CompactPCI Serial 2-slot SSR w/o RTM w/ Ethernet
1CPCIS-302-R200
3U CompactPCI Serial Backplane with 2 CompactPCI S.0 slots, system slot right, without rear IO : 1x CompactPCI S.0 CPU slot, 1x CompactPCI S.0 peripheral slots, without connectors for RTMs, Ethernet full mesh.
-
product
CompactPCI Interface Card
CPCIC-1553/PXI
The CPCIC-1553/PXI Interface Card and AltaAPI Represent the Latest MIL-STD-1553 32-bit FPGA Protocol Engine Technology with Multi-Layer Software. Our Card and Software Packages are Designed for Fast, Portable Integrations. The CPCIC-1553 is the Only Commercial Off the Shelf (COTS) Card that Passes and Executes the SAE AS4111/4112 Protocol Tests.
-
product
CompactPCI Serial 8 Slot 9U
The CompactPCI® Serial backplane is designed to be used with CompactPCI Serial 9 Slot 4U chassis.
-
product
PICMG® 2.11 47-Pin Hot-Swap Redundant 3U CompactPCI® 8HP 250 W Power Module
cPS-H325/24
- PICMG® 2.11 CompactPCI® Power Interface compliant- 3U CompactPCI® 8HP form factor- PICMG® 2.11 47-pin CompactPCI® in-rack power module interface- 250 W DC output
-
product
3U CompactPCI Serial Intel® Xeon® W Processor Blade
cPCI-A3535 Series
- Intel® Xeon® W-11555MRE 6-Core processor- Max. 64GB DDR4-3200 by 2x SODIMMs- 80GB 3D Nand flash SSD in SLC mode- USB 3.2, USB-C and RJ-45 iAMT front panel service ports- 2x M12 2.5GbE front panel ports for on train use
-
product
6U CompactPCI Processor Blades
A comprehensive line of 6 U CompactPCI computers to the embedded board market.
-
product
15-Slot 32-Bit 3U I/O with 6U System CompactPCI Backplane
cBP-6515R
- PICMG:2.0 R3.0, 2.1 R2.0, 2.7 R1.0- Dimension:202.5 x 262.05 (mm, WxH, vertical insertion view)- Segment:One- cPCI Bus:32-bit/33MHz- System Slot:Right-hand side- System Slot Rear I/O:P3, P4 and P5 rear I/O with AB-type shroud- Peripheral Slot:14 (Bus A: 7 slots, Bus B: 7 *slots)Note- Peripheral Slot Rear I/O:P2 rear I/O with AB-type shroud
-
product
CompactPCI 3U 8 slot 64 bit right justified, P1s P2s
102CPCI308-21XX
CompactPCI 3U 8 slot 64 bit low profile with system slot right, fully compliant to the PICMG basic specification 2.0 R3.0 and Hot Swap specification 2.1 R1.0.
-
product
8-Slot 64-Bit 6U CompactPCI Backplane
cBP-6408R
- PICMG 2.0 CompactPCI Specification R3.0 Compliant- PICMG 2.1 CompactPCI Hot Swap Specification R2.0 Compliant- PICMG 2.5 H.110 Computer Telephony Specification R1.0 Compliant- Design for 64-bit/33MHz CompactPCI computer system application- One system slot with seven expansion slots, system on right hand side
-
product
CompactPCI Boards
*CompactPCI (cPCI) boards are 3U or 6U boards connected via a passive PCI (Peripheral Component Interconnect). Up to 8 boards can be connected together in a segment. Segments can be connected through bridges. *They are grouped into four categories: CPU, Communication, Input/Output, PMC carrier.
-
product
CompactPCI 6U 64 bit ATX 3 slot, P1s, P2-5l
102CPCI603-4057
CompactPCI 6U 3 slot 64 bit low Easycable, system slot left, with ATX connector. It is fully compliant to the PICMG basic specification 2.0 R3.0 and Hot Swap specification 2.1 R1.0.
-
product
3U cPCI 8 Channel ARINC 429 Module
DP-cPCI-4296
DP-cPCI-4296 board features cPCI based eight channels ARINC429 protocol interface. As part of the cPCI family, the DP-cPCI-4296 board is fully compliant with compactPCI® specification 2.0 R3.0. and CompactPCI® Hot Swap Specification 2.1 R1.0.
-
product
CompactPCI Serial Backplanes
CompactPCI Serial (PICMG CPCI-S.0) supports high-speed serial data transmission of up to 12 GB/s. This means excellent computing power in your applications and incredible precision for automated work processes.
-
product
6U CompactPCI 6th/7th Gen Intel® Xeon® E3 and Core™ i3/i7 Processor Blade
cPCI-6636(KL) Series
The ADLINK cPCI-6636 Series is a 6U CompactPCI® processor blade based on the 6th/7th Generation Intel® Xeon® E3 and Intel® Core™ i3/i7 Processors with Intel® HM170 or CM236 Chipsets. The cPCI-6636 supports up to 16GB onboard DDR4-2133 memory and 16GB DDR4-2133 via SODIMM. Total memory capacity is up to 32GB of DDR4-2133. The cPCI-6636 is a highly integrated processor blade fit for mission critical applications in industries ranging from automation to defence.
-
product
Stackable Single Slot Test Fixture
Stackable Single Slot Test Fixture: Testing, Development, and Validation. The VITA 48.2-compliant Single Slot Test Fixture can be used for development, validation, and environmental testing. It is available in VPX, VME, CompactPCI, or custom form factors and can be vertically or horizontally mounted.
-
product
CompactPCI 3U 8 slot right justified, P1-2s, P3-5l, 1 x P47
103CPCR308-31XX
CompactPCI 3U 8 slot 64 bit Easyplug with P47 power connector, system slot right, fully compliant to the PICMG basic specification 2.0 R3.0 and Hot Swap specification 2.1 R1.0.
-
product
CompactPCI 6U 64 bit ATX 6 slot, P1s P2l, RoHS
102CPCI606-40X0R
CompactPCI 6U 6 slot 64 bit low Easycable, system slot left, with ATX connector. It is fully compliant to the PICMG basic specification 2.0 R3.0 and Hot Swap specification 2.1 R1.0.
-
product
3U CompactPCI 32-Bit Backplanes with Optional Rear I/O
cBP-3208/3206/3204[R]
- PICMG 2.0 CompactPCI Specification Rev. 2.1 compliant- Numbers of slot: 8/6/4 slots (incl. system slot)- Width: cBP-3208R: 36HP (9-slot) cBP-3206R: 28HP (7-slot) cBP-3204R: 20HP (5-slot)- Right one slot is system slot and others are peripheral slots- 10-layer PCB for accurate impedance control and electr
-
product
Stepper Motor Controller for CompactPCI
CPCI321
The CPCI321 Intelligent Stepper Motor Controller with amplifiers is an ideal solution for all applications where stepper motors must be controlled with a maximum of flexibility and a minimum of overhead.
-
product
ATR Enclosures
Elma Air Transport Rack (ATR) enclosures offer a standardized, cost effective solution for VME, VME64x, CompactPCI, VXS, VPX and Small Form Factor (SFF) based applications.
-
product
3U CompactPCI Serial Front Removable SATA Carrier for SSDs
SD8-STEEL
The SD8-STEEL is a peripheral slot card for CompactPCI® Serial systems. It includes a shuttle for 1.8 or 2.5” SSD or HDD drives. Signal integrity is optimized with 6Gbps SATA drivers. A push button ejection of the drive enables easy swap removal.
-
product
20 x GB ETH Switch
SL4-TUBA
SL4-TUBA is a peripheral slot card for CompactPCI® Serial systems. The board is equipped with a modular Gigabit Ethernet switch fabric up to 20 ports.
-
product
3U CPCI 32-bit Test Extender
Measurement and testing of CompactPCI® assemblies in the 3U Euro-board form factor is greatly facilitated by the use of this test adapter. Easy access to the DUT is guaranteed because the adapter has plug-in connections on 3 sides. The Modern BRIDGE design permits up to 3 CompactPCI® cards and one standard PCI® card to be inserted in one CompactPCI® slot. This allows system developers to implement a large number of tests with little effort and enables you to achieve vital time to market.
-
product
6U CompactPCI Rear Transition Module with Ruggedized M12 Connectors
cPCI-RMPSA
- Dual display with DVI-I and DVI-D- Ruggedized USB 2.0, GbE M12 ports- Dual serial ports and optional USB 3.0- Compatible CPU boards: cPCI-6530/cPCI-6520/cPCI-6940
-
product
ARINC-429 Controller for CompactPCI
CPCI302
The CPCI302 provides four ARINC-429 compatible channels (2x receive and 2x transmit) at any rate between 12.5 and 100kbps. Because the CPCI302 is built upon a flexible platform, the user functions can be implemented almost without restriction, making this product flexible and user-friendly.
-
product
Quad M Module Carrier
DP-cPCI-5112
DP-cPCI-5112 provides a compact high performance cPCI bus gateway to four ANSI approved M-Module Interfaces. This is a non-intelligent 6U form factor M-Module Carrier board. The DP-cPCI-5112 allows a flexible I/O solutions to be implemented in the carrier board. The M-Module carrier board occupies single slot in a CompactPCI system. Different mix and match of various I/O solutions will simplify the job for system integrators.
-
product
14-Slot 32-Bit 6U CompactPCI H.110 Bus Backplane
cBP-6014R
- PICMG 2.0 CompactPCI Specification R3.0 Compliant- PICMG 2.1 CompactPCI Hot Swap Specification R2.0 Compliant- PICMG 2.5 H.110 Computer Telephony Specification R1.0 Compliant- PICMG 2.7 Dual system Bus specificationR1.0 compliant- One system slot with 13 expansion slots, system on the middle slot of the backplane
-
product
3U CompactPCI Single Board
CP32104
LinkedHope Intelligent Technologies Co.,Ltd.
CP32104 is a 3U CompactPCI single board, low power, small size, high integration, high reliability embedded computer module compliant with PICMG® CompactPCI specifications.CP32104 offers a variety of processor options enabling customers to choose such as D2550、N2600 and N2800. The onboard memory, flash and SATA make sure CP32104 with good anti-shock and vibration performance.The design and production of CP32104 are controlled by full life-cycle management, so CP32104 can be long time available, as ensures maximum support for the maintenance of long life programs.Benefit from its high performance/power ratio, CP32104 works stably in extended temperature range, and is an ideal selection for high reliability and high availability required applications, like harsh environment communication, network security, video/image processing and can also be an ideal control unit in variant devices and equipment.
-
product
CompactPCI Card
IIB-429-CPCI
The IIB-429-CPCI provides from ARINC-429 compatible channels (2 receive and 2 transmit) at any rate between 12.5 and 100 kbps. Because the IIB-429-CPCI is built upon a flexible platform, user function can be implemented almost without restriction, making this product flexible and user-friendly. This CompactPCI card has a 3U form factor. This unit is also available in a 6U form factor (IIB-429-CPCI-4C) with four times the functionality
