Filter Results By:
Products
Applications
Manufacturers
- Valhalla Scientific Inc.
product
Air Force
Alpha 4314 AF
4314AF introduces an added safety feature that prevents the possibility of having the charging adapter connected while using the instrument for measurements. A 6-pin Mil-Spec circular connector on the front panel of the 4314AF replaces the four-terminal banana jacks and the battery charger jack. Four of the front panel connector pins are used to mate with the measurement adapter cable and the other two pins are for the battery charging cable adapter. By using separate adapter cables for measurements and charging of the batteries, it ensures that the charge circuit cannot be activated at the same time as measurements are being made.
-
product
Compressed Air Temperature and Humidity Regulator
H3061P-4
Relative humidity, temperature probe on a cable. Measured values are also converted to other humidity interpretation: dew point temperature, absolute humidity, specific humidity, mixing ratio, specific enthalpy.
-
product
Fabric Pneumatic Bursting Tester
TF142C
TESTEX Testing Equipment Systems Ltd.
Fabric Pneumatic Bursting Tester, to determine the bursting pressure of fabrics uses pneumatic test method, including knits, woven fabric, non-woven fabric, laminated fabric and other craft-made fabric.A test specimen is clamped over an expansive diaphragm by a circular clamping ring, increasing compressed air pressure is applied to the underside of the diaphragm, causing distension of the fabric until the test specimen bursts, the bursting strength and distension are determined.
-
product
Water Leakage Test Bench For Complete Gas Meter
Bofa Instrument & Equipment Co., Ltd
This device is for checking leakage of complete gas meter by charging compressed air to gas meter inside water, then observe whether there is air bladder coming from gas meter. It consist of operation desk, clip, aquarium, pressure adjuster, etc. It is an ideal testing equipment for gas meter factory and R&D institute.
-
product
Pressure Regulators
General purpose pressure regulators for compressed air lines, regulators for use in Norgren's Excelon® modular systems, high-precision pressure regulators, and more.
-
product
Dual Vapor Gravimetric Sorption Analyzer
DVS Resolution
DVS Resolution’s key feature is the combined ability to precisely control and measure temperature and relative humidity while recording the highest resolution changes in mass. DVS Resolution uses a dry carrier gas typically nitrogen or compressed air for its operation. Digital mass flow controllers regulate flows of dry and saturated gases. Relative humidity is generated by precisely mixing dry and saturated gas flows in desired flow ratios which produce expected relative humidity. In a typical experiment a known concentration of water vapor is delivered over a sample placed inside the sample pan connected to the Surface Measurement Systems Ultrabalance™ measuring realtime mass changes caused by sorption or desorption of water molecules. Prior to sorption measurements, the sample can be in-situ preheated/dried at temperatures of up to 300oC.
-
product
Compact Ultrasonic Testing Device
SONAPHONE® Pocket
With the SONAPHONE Pocket you identify problems even before they arise and create value at all levels of your company. Just by detecting and eliminating leaks you can reduce the energy costs for your compressed air system up to 30 percent. This also has positive effects on your operational safety and system productivity through early warning of bearing failure and evidence of partial electrical discharges.
-
product
DP Monitor for Compressed Air Systems
Com.Air
The Com.Air dew point monitor has been designed by Edgetech Instruments to offer the highest level of reliability and accuracy available in compressed air system dew point measurement.
-
product
Air Amplifiers
Nex Flow® Air amplifiers are compact, low cost air flow “movers” that are virtually maintenance free. Applications include the venting of fumes and smoke, conveying of low weight materials, and entraining a high volume of air to cool, blow off, and dry. Air Amplfiiers use the “Coanda effect” to draw in the surrounding atmosphereic air while consuming only aminimal amount of compressed air. These products can amplify airflow up to 17 times (depending on the size) resulting in dramatcally reduced levels of noise. Air Amplifiers (also called Air Movers) draw in atmospheric air from the back of the unit as well as having downstream entrainment further amplifying the flow. They are used for cooling and venting. While the force produced for blow off decreases as the amplifier outlet diameter increases, these Air Movers are ideal for cooling because of the high velocity outlet fow and and are much more effective for cooling compaed to air nozzles.
-
product
Flowmeters for Compressed Air and Specialty Gases
Type SD
*Measurement to ISO 2533 and DIN 1343*For compressed air in industrial use as well as argon (Ar), carbon dioxide (CO2), nitrogen (N2)*Large measuring range up to 700 Nm³/h*Fast response time and high response sensitivity*With volumetric flow quantity, total quantity and temperature indication
-
product
Airborne Ultrasound Sensors
Find compressed air, gas and vacuum leaks in noisy environments. Increase your inspections distance and reach hard to access areas.
-
product
Thermo-Hygrometer
C3121P-4
Thermometer, hygrometer is designed for direct measurement of temperature, relative humidity for compressed air up to 25 bars with 4 meters cable. Audio and optical alarm of measured values. Memory of minimum and maximum measured values. Function Hold - manual storing of actual values for later displaying.
-
product
Ultrasonic Leak Detection Camera
Leakshooter LKS 1000-V.2
1st ultrasonic compressed air, gaz and vacuum leak detector with camera. Specialy dedicated to visualize the spots where compressed air is leaking, the LEAKSHOOTER LKS 1000 – V.2 has many other applications such as : steam trap monitoring, bearing monitoring, electrical applications like partial discharge, corona effects, punctured isolators, electrical tracking detection.
-
product
Digital Ultrasonic Testing Device
SONAPHONE
The ultrasonic leak detector SONAPHONE is designed for a quick and precise location of leaks in compressed air, inert gas and vacuum systems. System leaks can easily be detected. The variety of devices in the range and the extensive accessories available enable this range of devices to be used for a multitude of various applications. With the help of the ultrasound testing device SONAPHONE, it is easy to pinpoint leaks.
-
product
Gas Filters
WITT gas filters enable the finest filtering of impurities in technical gases such as acetylene, argon., oxygen, hydrogen, methane, carbon dioxide, helium, compressed air and ethylene. They thus protect downstream equipment and systems. Some gas filters are also referred to as gas cleaners.
-
product
Compressed Air RH+T+Tdp Sensor
T3111P
Relative humidity, temperature sensors at probe on the cable. Measured values are also converted to other humidity interpretation: dew point temperature, absolute humidity, specific humidity, mixing ratio, specific enthalpy.
-
product
Measurement of Dew Point in Compressed Air Systems
HP480 – HP481
Compressed air is used for several purposes, many of which require compressed air with a low humidity level, and so comes the need to know the dew point (DP) of water vapour in the compressed air that circulates in the system.
-
product
Thermo-Hygrometer
D3121P-2
Thermometer, hygrometer is designed for measurement and datalogging of temperature, relative humidity for compressed air up to 25 bars with 2 meters cable into the internal non-volatile memory.
-
product
Test Adapter / Pneumatic Adapter
GPS testing technology offers a wide range of pneumatic adapters. The support with compressed air results in increased ease of use and larger pressures can be built up easily and thus more test needles can be contacted.
-
product
LVDT With Pneumatic Function
INELTA Sensorsysteme GmbH & Co. KG
2-3 bar compressed air moves the strings out the integrated return spring pulls the output back into the housing
-
product
Air Tightness Detector
FQ
Fuzhou Fuguang Electronics Co., Ltd.
FQ series air tightness tester is the latest high-precision non-destructive testing equipment developed by Fuguang Electronics. The equipment mainly uses compressed air as the medium to apply a certain pressure to the inner cavity or surface of the product to be tested, and then uses a high-sensitivity sensor to detect changes in pressure to determine the tightness of the product to be tested.
-
product
Compressed Air Temperature and Humidity Regulator
H3021P
Humidity, temperature probe on a cable. Measured values are also converted to other humidity interpretation: dew point temperature, absolute humidity, specific humidity, mixing ratio, specific enthalpy.
-
product
BenchMate Active Air Vibration Control
2212 Series
BenchMate Vibration-Free Platforms enhance the performance of precision tabletop equipment.The 2212 Series is an Active-Air design that requires a source of compressed air (not included). It is a self-leveling unit and recommended for regular use.
-
product
Thermo-Hygrometer
D3121P
Thermometer, hygrometer is designed for measurement and datalogging of temperature, relative humidity for compressed air up to 25 bars with 1m cable into the internal non-volatile memory.
-
product
Leak Detection
Compressed air is an expensive energy 20-40% are lost in leaks. The systematization of hunting leaks allows significant energy savings. Shoot, view and photograph the precise location of compressed air leaks , steam, gas pressure and vacuum through LEAKSHOOTER LKS1000 V.2.
-
product
Compressed Air RH+T+Tdp Sensor
T0211P-2
Humidity, temperature probe on a cable. Measured values are also converted to other humidity interpretation: dew point temperature, absolute humidity, specific humidity, mixing ratio, specific enthalpy.
-
product
HPPlife for Keeping Mice
HPP750life
In a Memmert constant climate chamber HPP750life mice can be kept in a "specific pathogen free" (SPF) state. Ideally the climate chamber is located in a clean room. In order to guarantee the recommended humidity of between 45 and 65 % rh for the humane keeping of mice even at low temperatures, Memmert integrated a compressed air drying unit. For simulation of the day and night rhythm, the LED illumination can be programmed using the AtmoCONTROL software.
-
product
Compressed Air Monitor and Alarm
SENTRY
The Edgetech Instruments Model SENTRY detects upset conditions in compressed air systems by constantly monitoring dew point and pressure at the system header or dryer output. The SENTRY alarms when a loss in pressure or high dew point is detected. This information is valuable in detecting compressor failures, system leaks, or drops in dryer performance. A pulsing audible alarm and strobe lamp provide quick notification of upset conditions. The SENTRY also provides a local display of pressure, dew point and system status as well as 4-20mA analog output and alarm relay contacts.
-
product
Flow Sensor For Compressed Air (FLUEREX With Integrated Display)
PF/PFU
This is a flow sensor for compressed air for medium and large flow rates, which is useful for grasping the current state of energy consumption and confirming the effect.
-
product
Thermo-Hygrometer
D3121P-4
Thermometer, hygrometer is designed for measurement and datalogging of temperature, relative humidity for compressed air up to 25 bars with 4 meters cable into the internal non-volatile memory.
-
product
Miniature Flow Sensor For Gas Lapiflow (R)
FSM
Ultra-compact flow sensor for compressed air and nitrogen gas.Since it is lightweight and responds quickly, it is ideal for confirming the adsorption of electronic parts.
