Filter Results By:
Products
Applications
Manufacturers
Dataloggers
record electrical or physcial events.
See Also: Loggers, Pressure Loggers, Current Loggers, Humidity Loggers, Temperature Humidity Loggers, Temperature Loggers, Voltage Loggers, Wireless Data Loggers, Wireless Loggers, Data Loggers
-
product
Datalogger Support Software
Datalogger support software packages help enable datalogger programming, communication between dataloggers and PCs, and, to varying capabilities, real-time and historical data monitoring. These software packages provide support for a single station or an entire datalogger network.
-
product
Air Temperature Sensors
Campbell Scientific offers a variety of sensors for measuring air temperature. The electrical signals transmitted from the sensors to our dataloggers can be converted to different units of measurement, including °C , °F, and °K. Our dataloggers are also capable of measuring most commercially available air temperature sensors.
-
product
Datalogger
iLOGPlus
Infinite Industrial Informatics Lt
iLOGPlus RTU/Data Loggers are internet enabled devices, specially suited for remote data acquisition, distributed telemetry and remote control. The units act as master devices and send alerts and data files on their own via FTP, email and SMS. All types carry a built-in TCP/IP webserver with live webpages that can be accessed by any Internet browser application. They accept and serve TCP and SMS commands for interactive operation in a SCADA system.Analog inputs and digital I/O are expandable by means of I/O expansion modules, plugging on a serial I/O expansion bus.
-
product
Current Shunt Module
CURS100
The CURS100 converts a current signal output by a sensor or output device (e.g., 4 to 20 mA) to a voltage that can be measured by a datalogger. The 100 ohm resistor used for the current shunt allows currents up to 25 mA to be read on a 2500 mV range (CR10, CR10X, CR510, CR500) and currents up to 50 mA to be read on a 5000 mV range (CR23X, 21X, CR7, CR5000, CR9000, CR9000X).
-
product
Temperature and Humidity Data Logger
U3121M
The Datalogger is designed to record temperature and humidity from expternal probe. In case of exceeded set limits, SMS and JSON messages can be sent via GPRS data connection. It is possible to set the regular sending of JSON messages to Comet Database, the sending interval is adjustable.The recording is performed in a non-volatile electronic memory. The data can be transferred to a PC via USB-C.
-
product
Software
Data acquisition software is used for a variety of purposes: to support datalogger programming, enable communication between dataloggers and computers or mobile devices, manage data files, and display data in graphical formats. More advanced users can add custom capabilities or interfaces with our software development kits.
-
product
Dataloggers and Multichannel Recorders
SA analog data acquisition system 32 is designed to measure, treat, monitor and record the parameters from analog sensors of 32 channels in 2 son and 8 channels in 4 son.
-
product
Spectroradiometer Data Logger
HD30.1
The HD30.1 spectroradiometer datalogger is designed for the spectral analysis of light in the visible range and ultraviolet.
-
product
Temperature And Humidity Data Loggers
These dataloggers are used to monitor and record temperature and/or humidity. Available in either single or multi channel inputs for thermocouple, RTD, thermistor, & infrared temperature sensors.
-
product
Dataloggers
Ultra fast data acquisition module (7680 Hz / channel) with 20 synchronous analog channels (1 / D converter per channel) and 20 inputs / TTL outputs.
-
product
Sound Level Datalogger
DSL 331
Auto Ranging Measurement 30dB to 130dB. Work with Window Software. 32,000 Records Data Logger. Bar graph Indication with Back Light. RS-232 Real Time Display Software for Window 95/98/2000
-
product
DataLogger
OBDII
DataLogger is an IoT gadget that securely collects and transmits vehicle and sensor data to your platform via a cellular or Bluetooth™ connection.
-
product
Modular System Power Supplies
N6700 Series
The N6705A is 4-slot mainframe that accepts 1 to 4 modules in any combination. Modules are ordered separately. Maximum output power is 600W. The DC Power Analyzer is designed for bench testing in R&D. It is a highly integrated instrument that combines up to four advanced DC power supplies, DMM, oscilloscope, arbitrary waveform generator and datalogger. It provides an easy-to-use interface, with all sourcing and measuring functions available from the front panel.
-
product
LiDAR Remote Sensing Payload Instrument
RESEPI™
Engineered for partners and resellers in the remote sensing industry, the Remote Sensing Payload Instrument, or RESEPI™, is a combined Dual Antenna GNSS-Aided Inertial Navigation System, datalogger, LiDAR, camera, and communications system that allows for the real-time and post-processed generation of point cloud solutions. The processing platform contains a WiFi interface, an embedded cellular modem to support RTCM corrections, data logging software, and gigabit ethernet. RESEPI™ can be used with commercially available LiDARs like Velodyne, Quanergy, Ouster, RIEGL, LIVOX, and Hesai. The device was built with the purpose of white labeling.
-
product
Multilogger
M1440
Universal datalogger with 4 hardware inputs and external CO2 probe. Multilogger can be installed permanently to Ethernet network or work as portable device. Included is traceable calibration certificate in accordance with EN ISO/IEC17025.
-
product
Multilogger
M1300
Universal datalogger with 4 universal hardware inputs. Multilogger can be installed permanently to Ethernet network or work as portable device. Included is traceable calibration certificate in accordance with EN ISO/IEC17025
-
product
Digital Sensors
PMA-Series
Solar Light’s NIST-Traceable PMA-Series Digital Sensors represent the pinnacle of accuracy, durability, and selection on the market today. Our sensors measure discrete bands of the electromagnetic spectrum from the UVA, UVB, UVA+B, UVC, Visible Light, and Infrared regions. Both narrow and broad bands are available to fit any application, including germicidal requirements, environmental probes, and sensors for biologically weighted spectra (such as the erythema and CIE action spectra.) Over 135 different sensors are available in a variety of packages to fit any environment, from indoor clean rooms to harsh locations outdoors to 100 meters under water. Please note that Solar Light offers both Digital Sensors and Analog Sensors in the PMA-Series lineup. Select these Digital Sensors if you prefer to plug into our PMA-Series Radiometers to read the output of the sensor on the meter’s display. Digital models are typically used as discrete sensors that are portable and located to provide short term information. (By contrast, please select Analog Sensors if you don’t need a digital display output of the reading, if you will be connecting to your own datalogger, or if you plan to use a voltage source to provide excitation voltage to the sensor and a digital volt or amp meter to read and convert the results. Analog Sensors are typically used as process sensors that are permanently installed to provide ongoing information.)
-
product
Humidity & Temperature Loggers
Out of clusters of humidity and temperature instruments,this low power consumption data-logger combines the functions of signal-sampling,display,storage and analysis,widely be applied in the industries of medics,food,agriculture,laboratory,electronics,air-conditioning, weather service,archives management,archaeology study,fibre manufacturing and cold chain logistics,because this device can provide just-in-time solution of environment-monitoring,alerting and recording.
-
product
DC Power Analyzers
DC Power Analyzer provides unrivaled productivity gains when sourcing and measuring DC voltage and current into a DUT. The Keysight N6705C DC Power Analyzer is a highly integrated instrument that combines up to four advanced DC power supplies, DMM, oscilloscope, arbitrary waveform generator and datalogger. It provides an easy-to-use interface, with all sourcing and measuring functions available from the front panel. The N6705C makes these tasks easy:
-
product
Double Way Datalogger
VA602-A1-R161
Shanghai Yi Hua V&A Instrument Co., Ltd. CO.,LTD
Multi-function record meter is a new record meter designed for the actual demand of various industrial site, which integr.
-
product
Electrostatic Field Meter Kit
PFK-100B
- Measure range & polarity of electrostatic fields in 1 volt or 10 volts increments- Charges from zero to over 1000 volts in less than 5 seconds- Balance Ionizers per ANSI/ESD SP3.3 Periodic Verification- Measure Ionizer Decay time as per ANSI/ESD S3.1 and ANSI/ESD SP3.3.- Measure Body Voltage Generation and Decay- Use with a datalogger to record measurements & create reports- Compatible with the Autoanalysis System- Accuracy of ± 5%- Battery Operated
-
product
Dataloggers
High Accurancy Measuremetn up to 1%RH. Light weight, pocket-sized design. Take accurate measurement for humidity, temperature, wet bulb and dew point.
-
product
Voltage Datalogger
S5021
Data logger is designed for record of voltage. Values are stored to a non volatile electronic memory. Data transfer to the personal computer for further analysis is performed via USB, RS232, GSM or Ethernet interface by means of a proper adapter.
-
product
Temperature and Humidity Datalogger
VA600-N1/VA600-N/VA600-NH8
Shanghai Yi Hua V&A Instrument Co., Ltd. CO.,LTD
Data logger temperature humidity with USB, widely used in cold -chain transportation field HVAC refrigerator field.
-
product
Opto-Isolated Current Loop Signal
4029
SPECTEC Innovative Sensor Solutions
SPECTEC's Model 4029 digital opto-isolated current loop signal conditioner prevents ground loops and interrupts any galvanic signals riding on magnetic speed sensor's output signal.. This signal conditioner converts magnetic, variable reluctance and inductive sensors' sinusoidal signals into a 4-20 mA output suitable for interfacing with process control units, dataloggers, flow controllers, and computers.
-
product
Hand-Held Readouts & Dataloggers
HPM4000 (SR / ID)
The HPM4000 series is a highly versatile entry-level portable hydraulic data logger, ideal for pre-dispatch inspection, preventative maintenance and simple diagnostic fault-finding. There are two models, Sensor Recognition (SR) & Intelligent Digital (ID).
-
product
Data-logger
11250
Comes loaded with M. C. Miller's Test Site Survey application• Integrates with ProActive, M. C. Miller's corrosion control data management application• Data-types are customizable for each of your test sites and each test site can be GPS position stamped • High-resolution date/time stamped photos can be taken at your test sites during a route and recorded images are posted directly to the ProActive database • Sub-meter GPS position resolution
-
product
Multilogger
M1320
Universal datalogger with 4 hardware inputs. Multilogger can be installed permanently to Ethernet network or work as portable device. Included is traceable calibration certificate in accordance with EN ISO/IEC17025.s portable device.
-
product
External Double Way Temperature Datalogger
VA602-TK-TJ
Shanghai Yi Hua V&A Instrument Co., Ltd. CO.,LTD
Two tunnel data logger with voltage current temperature (thermocouple) K.J.PT type, with USB, up to 16000 data record point.
-
product
Voltage Datalogger
S5011
Data logger is designed for record of voltage. Values are stored to a non volatile electronic memory. Data transfer to the personal computer for further analysis is performed via USB, RS232, GSM or Ethernet interface by means of a proper adapter.
