Elcometer Limited
For more than seventy years Elcometer has been a world leader in the design, manufacture and supply of inspection equipment to the coatings, concrete and NDT industry.
- +1 248 650 0500
- +1 248 650 0501
- sales@elcometer.com
- 6900 MIller Drive
Warren, Michigan 48092
United States of America
Categories
-
product
Scrub Test Panels
4695
In a typical scrub test, the coating is applied to the Leneta Scrub Test Panel at a specified film thickness, allowed to dry and then subjected to scrubbing with a straight-line scrub tester.
-
product
Surface Profile
Surface profile: The degree of profile on the surface affects a coating’s overall performance and determines aspects such as adhesion, coverage and overall volume of coatings used. If the profile is too large the amount of coating required increases, otherwise there is a danger that the peaks remain uncoated - allowing rust spots to occur. If the profile is too small there may be an insufficient key for adequate adhesion.
-
product
Half-Cell Meter
331HM
These easy to use Elcometer 331 Half-Cell Meters measure the condition and potential corrosion of rebars and steel structures within concrete.
-
product
Shell Viscosity Dip Cups
2310
The Elcometer 2310 Shell Viscosity Dip Cups are stainless steel cups for quick measurements on-site or during production.
-
product
DIN Viscosity Flow Cups
2350
The Elcometer 2350 DIN Viscosity Flow Cups are very easy to use instruments made of anodized aluminium with a stainless steel orifice, for measuring the consistency of paints, varnishes and similar products.
-
product
Thickness Gauge
124
The Elcometer 124 Thickness Gauge is used to measure the peak-to-valley height of a surface profile moulded in the Elcometer 122 Testex® Replica Tape.
-
product
Covermeter
331B
The easy to use Elcometer 331B Covermeter quickly and accurately locates/orientates reinforcement bars in concrete and measures the depth of cover over the rebar.
-
product
DC Holiday Detector
Elcometer 236
The Elcometer 236 Holiday Detector provides high voltage porosity testing to detect pits, flaws, holes, etc. in a wide variety of non-metallic coatings.
-
product
Paint Inspection Gauge
141
The Paint Inspection Gauge is ideal for use on metallic & non-metallic substrates such as wood, glass and plastics.Large easy grip handle - makes cutting thick or hard coatings easyInternal cutter storage compartmentx50 magnification microscope
-
product
Chloride Ion Test Kit for Abrasives
134A
Contamination can build up, particularly if the blast media is recycled several times. Using the Elcometer 134A Chloride Ion Test in the field will accurately identify contamination and prevent costly surface-related failures.
-
product
Push Off Adhesion Tester
508
Hand-held, ergonomic and fully portable - ideal for on-site adhesion testingQuick connect coupling for easy connection to the dollyMeasurement range up to 25MPa (3630psi) with a full scale accuracy of ±1.5%Rotating crank handle applies smooth loading from 0 up to 25MPa (3630psi)
-
product
Conical Mandrel Bend Tester
1510
The Elcometer 1510 Conical Mandrel Bend Tester is used to determine the effects of bending on the elasticity, adhesion and elongation properties of cured coatings on sheet metal.
