-
product
Low Noise Amplifier
The COMM-connect Low Noise Amplifier can be used to amplify signals in a wide range of bands. The amplifier comes equipped with a SMA connectors, for easy installation. Mechanical mounting is made easy by mounting flaps protruding the casing.
-
product
Millimeter-wave Operation With Frequency Extenders For P50xxA Streamline VNA
S97560B
Configure an affordable millimeter-wave banded VNA using P50xxA Streamline USB VNAs with this software
-
product
3 Port Devices
Teledyne Lincoln Microwave supplies 3 port circulators and isolators that operate from UHF to V Band. They are available in a range of different packages; planar microstrip, coaxial and waveguide.
-
product
Noise Suppression Products / EMI Suppression Filters / TVS Diodes (ESD Protection Devices)
Murata noise suppression products include compact EMI suppression filters that efficiently eliminate noise, L Cancel Transformers (LCTs) that greatly suppress noise in high-frequency bands by reducing the ESL generated inside capacitors and in boards, and TVS Diodes that guard semiconductor devices against electrostatic discharge from external sources. Murata supplies products that support a variety of approaches to suppressing noise.
-
product
THREE WAY BACK PRESSURE KIT
TU24APB
*Allows quicker and more accurate testing of exhaust blockages in catalytic converters, mufflers, etc*2-1/2" gauge features two multi-colored bands - idle and 2,500 RPM - with pressures shown in PSI and bar*Includes 6' of hose, enough length to test from driver's seat
-
product
USRP-2901, 70 MHz to 6 GHz, 2-Channel USRP Software Defined Radio Device
784040-01
70 MHz to 6 GHz, 2-Channel USRP Software Defined Radio Device - The USRP‑2901 is a tunable RF transceiver with full-duplex, MIMO operation. It offers bus-powered connectivity with USB 3.0 or USB 2.0. You can also use the NI USRP‑2901 for the following communications applications: white space; broadcast FM; public safety; land-mobile, low-power unlicensed device (ISM) bands; sensor networks; amateur radio; or GPS.
-
product
160MHz Test System
IQxel-MW 7G
Platform solution for 802.11 a/b/g/n/ 802.11ac, 802.11ax, and 802.11be testing in the 2.4 and 5 GHz and 6 GHz bands and the most popular wireless connectivity standards (Bluetooth®, Bluetooth® 5, Bluetooth® 5.1, Bluetooth® 5.2, Zigbee, Z-Wave) as well as LPWAN technologies (Sigfox, LoRa).
-
product
6 Channel Digital Receiver Module
DP-VME-5826
DP-VME-5826 is a VME64x Six Channel Digital IF Receiver module. It samples and down converts analog IF signals into the digital base band data.The digital base band I/O samples generated from these IF samples are pulse compressed. Down converted I/Q data is sent to the signal processor through 2 channels of 2.5 Gbps speed SFPDP link.The digital waveform generator block of digital receiver unit generates programmable polyphase coded digital pulse coded expander output.
-
product
Switches-DPDT
Macom Technology Solutions Holdings Inc.
At MACOM we offer an extensive collection of switches covering multiple commercial and aerospace and defense markets. Our product portfolio has a broad frequency spectrum from DC to 70 GHz. Our silicon Heterolithic Microwave Integrated Circuit (HMIC) PIN diode process is ideal for high power and broadband switches operating from 50 MHz to 26 GHz. Our AlGaAs PIN diode process can extend the upper frequency range of our switch die beyond 70 GHz and is ideal for instrumentation and radar applications. Our GaAs pHEMT and MESFET technology is ideal for fast switching and low control voltage switches optimized for both narrow band and broadband applications. Our 75 Ohm absorptive switches are designed specifically for demanding CATV, FTTx and DBS Infrastructure and CPE applications.
-
product
Modems
Radio modems provide reliable, long-range wireless communication for a variety of industrial and commercial applications. Designed to transmit data over radio frequencies, these devices enable seamless communication between remote systems, equipment, or control centers without the need for physical cabling. Whether you're operating in challenging environments or across vast distances, radio modems ensure robust and secure data transmission, making them ideal for industries like transportation, utilities, agriculture, and mining. Available in various frequency bands, power outputs, and configurations, radio modems support multiple protocols and are built to withstand harsh conditions. Explore our range of high-performance radio modems to enhance your wireless network capabilities today.
-
product
Frequency Extender
DC100
The DC100 system can be installed in the HP8568B(see H96 option below) without compromising the performance of the original instrument. The spectral purity and power accuracy of the primary band ( 100hz to 1.5Ghz) are insured from corruption by careful design of the DC100 system. Additional protection of the primary band is guaranteed as the DC100 system is automatically switched off (all power removed) when in primary band operation.
-
product
Spectrum Analyzer
S3531
Saluki S3531 series RF spectrum analyzer is designed based on the concept “Smaller, lighter, easier” . S3531 series takes a small desktop space and easy to carry. Most of nowaday RF applications are in this band, like mobile communication (GSM, CDMA, LTE even low frequency 5G), WIFI (2.4GHz), remote control etc, so S3531 series is a good tool for the test, maintenance, R&D of these applications.
-
product
Planar-Doped Barrier Diode Detector, 0.01 to 50 GHz
8474E
The Keysight 8474E is a high-performance detector using a gallium arsenide, planar-doped barrier detecting element. It features extremely flat frequency response over its entire band of operation and very good frequency response stability versus temperature. The Keysight 8474E is also very rugged with high resistance to ESD damage. The Keysight 8474E detector is available with a 2.4-mm (0.01 to 50 GHz) connector. This detector offers the options for optimal square-law loads (Option 102) and for positive polarity output (Option 103). Because the unit-to-unit frequency response tracking of this device is typically better than plus or minus 0.3 dB, no matched response option is offered.
-
product
CWDM Mux/Demux in LGX Box(4,8,16,18-Channel)
Flyin Optronics’ Coarse wavelength division multiplexer (CWDM Mux/Demux) utilizes thin film coating technology and proprietary design of non-flux metal bonding micro optics packaging. It provides low insertion loss, high channel isolation, wide pass band, low temperature sensitivity and epoxy free optical path.
-
product
Module Type Amplifiers
Optical amplifier Gain Blocks are compact in size and suitable for built-in use. FiberLabs provides a wide wavelength range of optical amplifier Gain-Blocks over the O-, S-, C- and L-bands. These Gain Blocks can be used for B-PON system using three wavelengths of 1.31 μm, 1.49 μm, and 1.55 μm (ITU-T [compliant with G.983.3]), DWDM system and 100 GbE (IEEE 802.3ba) using the 1.3 μm band.
-
product
Narrow Band Filters (Single Octave)
NANO-POLE® Series
The NANO-POLE® is designed for optimal size, DC consumption, RF power handling, insertion loss, signal purity and linearity. The NANO-POLE® provides a minimum center frequency step size of 10 MHz typically but can be modified based upon request. The NANO-POLE® requires a +3.0 V supply that typically draws 5 mA when not hopping. The supply voltage should be adequately filtered as noise present on this pin will influence the RF signal purity. The NANO-POLE® uses SPI control interface.
-
product
Dual Polarized Scalar Feed Horn Antenna, 24 to 42 GHz, 15 dBi
SAF-2434231535-358-S1-280-DP
Model SAF-2434231535-358-S1-280-DP is a dual polarized, WR-28 scalar feed horn antenna assembly that coversseveral popular 5G bands in the frequency range of 24 to 42 GHz. The antenna features an integrated orthomode transducer (OMT) that provides high port isolation and cross-polarization cancellation and a broad band scalar horn that provides low side lobe levels.
-
product
Gateway
CODA-4782
Hitron Americas Technologies Inc.
The CODA-4782 has the capability to receive 5Gbps based on 2 x OFDM + 32 QAM over its DOCSIS 3.1 interface. The integrated Wi-Fi 3×3 2.4 GHz 802.11n and 4×4 5 GHz 802.11ac Wave 2 dual band MU-MIMO Access Point significantly improves customer experience extending range and coverage with blazing speeds. For wired clients, the four Gigabit Ethernet ports offer ultra-fast connections. MoCA 2.0 bonding provides a near-Gigabit wired backbone in the customer’s home for Wi-Fi extension. Its switchable upstream (5~85/5~204MHz)offers the possibility of flexible integration to existing networks.
-
product
Network Packet Brokers
Vision E40 / E100
Keysight Network Applications and Security
These new cost-effective and scalable solutions help IT teams supporting hyperscale and microscale data centers, resolve application performance bottlenecks, trouble shoot problems, and improve data center automation, as well as better utilize network analysis and security tools. Today’s hyperscale data centers, which are designed for expansion, as well as micro data centers, which often sit on the network edge closer to end users for an improved experience, can create significant challenges for IT organizations. These challenges range from poor network performance due to increasing size and complexity, to security issues resulting from insufficient visibility into incident detection and resolution. Many IT organizations use multiple network monitoring tools, and need to efficiently transport network traffic from thousands of network locations. Ixia’s solutions for highly scalable and expanding data centers. Ixia’s Vision portfolio of NPBs provides intelligent, sophisticated, and programmable network flow optimization, delivering comprehensive visibility and security coverage. The new Vision Edge 40 and Vision Edge 100 offer real-time visibility, insight, and security into high density hyperscale and microscale data centers, even as they expand. Each is capable of inline and out-of-band deployments, and delivers control, coverage, and performance to protect and improve crucial networking, data center, and cloud business assets.
-
product
Copper Network TAPs
Network test access points (TAPs) are a hardware tool that allows you to monitor your network. Garland Technology offers copper network TAPs in network speeds of 10/100M or 10M/100M/1000M (1G). Copper TAPs are purpose-built hardware devices used for out-of-band monitoring tools and make a 100% copy of your networks data allowing your monitoring tools to see every bit, byte and packet.®
-
product
Coaxial Waveguide Adapter, 1.85 mm (f), 50 to 67 GHz
V281A
The Keysight V281A adapter transforms waveguide transmission line into 50-ohm coaxial line. Power can transmitted in either direction, and each adapter covers the full frequency range of its waveguide band with SWR less than 1.3.
-
product
SparkFun RFM69 Breakout
(915MHz)
This is the SparkFun RFM69 Breakout, a small piece of tech that breaks out all the pins available on the RFM69HCW module as well as making the transceiver easy to use. The RFM69HCW is an inexpensive and versatile radio module that operates in the unlicensed ISM (Industry, Science and Medicine) radio band. It's perfect for building inexpensive short-range wireless networks of sensors and actuators for home automation, citizen science and more.
-
product
New Line of Frequency Synthesizers (Insight FS) from 36 to 1250 GHz
In the millimeter wave range, each synthesizer covers a full waveguide band (Q, U, V, E, W, F, D, G, Y, J). Insight FS provides several options for frequency and amplitude modulation (analog FM/AM modulation, frequency manipulation, pulses modulation). Insight FS are compact in size and controlled by IEEE, analog input, or manually.
-
product
Pyrometers
ROBUST Series
Nagman Instruments & Electronics Pvt. Ltd
ROBUST Series of single-color pyrometers measure the temperature of object by receiving the sum of the energy it emits in a narrow band. It adopts advanced software and hardware design, with super wide dynamic range and high stability.
-
product
High Power Noise Sources
NS-7001
The NS-7001 is high-power noise source specifically designed to operate in the 2.11-2.17 GHz UMTS band. It features flat output power that is regulated over a wide temperature range with high rejection outside the operating band of interest. Logic control is provided to enable/disable the noise source and an internal BIT function continuously monitors the output power. Other frequency bands and power levels are available.
-
product
infrared cameras
MS-IR
The MS-IR infrared cameras allow to split the scene signal into eight different spectral bands rather than only one Broadband image hereby allowing spectral analysis.
-
product
Amplitude Detectors with Isolators
Full band waveguide detectors are GaAs beam lead Schottky diode-based detectors that are specially designed for millimeterwave network analyzer applications. With a proprietary circuitry design and careful diode selection, these zero-biased detectors exhibit high sensitivity and extremely flat output characteristics. The below standard offering covers the frequency range of 18 to 170 GHz and offers a 1 MHz video bandwidth and 1 MΩ video output impedance. The standard models also have the capacity to handle a maximum RF input power of up to +17 dBm. The RF interface of these detectors is a standard waveguide with an integrated Faraday isolator to improve the port VSWR. The output voltage polarity is negative and the connector type is a female SMA. Other configurations are offered as custom models.
-
product
Spectroradiometer
SpectroCAL MKII
Cambridge Research Systems Ltd
High-performance spectroradiometer with NIST traceable calibration makes extremely accurate colorimetric measurements over the entire visible spectrum, even of narrow band sources.
-
product
Flare Test Radiometer
PRS-2000
Infrared Systems Development Corp.
The PRS-2000 Dual Pyro-Radiometer Measures Energy in Two Spectral bands simultaneously. Its applications include Counter-Measure Flare Analysis, and Radiant Intensity Measurements. Custom Radiant Intensity Profile Software is Included. Testing in Watts/Steradian. The PRS-2000 is a rugged, field portable instrument that accurately measures IR emissions from a variety of targets.
-
product
Wireless Network Adapter
BR-310AC
BR-310AC is a high-performance wireless network adapter which enables any Ethernet device to become an 802.11a/b/g/n/ac dual band wireless network device, giving the freedom to place it anywhere in your facility.
