Product

High Frequency Current Transformer

HFCT Ø 140mm

-

Techimp HQ S.r.L

HFCT Ø 140mm - Techimp HQ S.r.L

Techimp Clamp High Frequency Current Transformer model 140 is an inductive sensor for partial discharge measurements. It is suitable for online /off line PD tests on : large diameter cables ; grounding rod bar ; etc. A TNC termination is available to connect the Clamp HFCT 140 to the TechImp PD analyzer : PDCheck , PDBase etc. The arrow indicates the requested input current (Iin) direction to get coherent output voltage (Vout) polarity respect to ground. When the sensor is installed with the arrow directed to ground, the detected voltage signal (Vout) has the same phase of the input current (Iin).

Product

2GHz programmable frequency dividerValon

3010a

-

Valon Technology, LLC

3010a - Valon Technology, LLC

The Valon 3010a accepts a wide range of input frequencies and provides three independent, user-selectable, divided outputs. The 3010a is useful for extending the low-frequency range of any signal source down to 5MHz as a 50Ω output or down to 0Hz as a TTL output.

Product

AC Power Sources, Frequency Converter

MAC-01, -02, -03

-

Compact Power Company

MAC-01, -02, -03 - Compact Power Company

For reliability, all models of the Titan AC Power Sources/Frequency Converters are fully current limit protected against either continuous or transient short circuit or overload conditions. When an overcurrent condition exists, the internal current control loop overrides the voltage control loop and scales back the sinewave drive until it sees a safe output current level.

Product

Standard Loggers

-

RBR Ltd.

RBR Ltd.

Our standard loggers can measure up to 13 parameters. Numerous configuration options allow for maximum customization for your measurement needs. In addition to our conductivity, temperature and depth sensors, many others, including third-party sensors, can be used with our recorders. Measure salinity. Measure tide and waves. Altitude & Attitude Logger.

Product

High Frequency Spring Probes

-

KITA Manufacturing Co.,Ltd.

KITA Manufacturing Co.,Ltd.

We have spring probes for high frequency for 0.5 and 0.8mm pitch. We provide spring probe with low insertion loss by shorten the total length to 1.5mm (use length 1.1mm).

Product

Dual Frequency 900 kHz & 2250 kHz 2D Imaging Sonar

BlueView M900-2250-S 130/45-Mk2

-

Teledyne Marine BlueView

BlueView M900-2250-S 130/45-Mk2 - Teledyne Marine BlueView

​The dual frequency M900/2250-S 130/45-Mk2 is a new configuration of the leading BlueView M900/2250 optimized for superb image quality in challenging shallow water environments. The 900 kHz offers high-resolution long range navigation, object detection, and obstacle avoidance, while the 2250 kHz provides ultra-high resolution at close range. ROV navigation, diver hand held, hull inspections, structure inspections, diver monitoring, and search and recovery are a few applications that benefit from the dual-frequency’s imaging capabilities. All M Series sonar operate while in motion or from a stationary position delivering real-time imagery and data.

Product

Digital Instantaneous Frequency Measurement Receivers

DIFM

-

Mercury Systems, Inc.

DIFM - Mercury Systems, Inc.

Mercury Systems offers a range of standard high-performance broadband Digital Instantaneous Frequency Measurement (DIFM) receivers and Digital Frequency Discrimination (DFD), which act as functional building blocks in many military electronic warfare systems. Examples include electronic counter measures (ECM) systems, electronic surveillance measures (ESM) systems and radar warning receivers (RWR).

Product

Portable Three-Phase Energy Standard

PEWM-3C

-

EMSYST Ltd

PEWM-3C - EMSYST Ltd

The three-phase energy standard PEWM-3C is used for quick on-site tests of all types of electricity meters – for active, reactive or apparent energy, two-, three- or four-wire connection. Three voltages and three currents are measured at the same time. The current can be measured either via direct connection up to 10A (class 0.1), or with three current clamps (CC) to 120A, 150A or 1000A (class 0.2).

Product

Standard Panel & Display Products

-

Teledyne Defense Electronics

Teledyne Defense Electronics

Standard Panel & Display Products by Teledyne Defense & Electronics

Product

Additional Products: Standard Voltage 9 Pin D-Type Cables - Connector to Unterminated

-

Pickering Interfaces Inc.

Pickering Interfaces Inc.

The connector to unterminated cable assemblies below are not compatible with Pickering products, however, are offered for developing a connection solution for use with other products.

Product

Radio Frequency (RF) Generators

-

ViaSat, Inc.

ViaSat, Inc.

Find and fix design problems during developmental testing. Viasat’s RF signal environment generation surpasses ordinary simulation and computer modeling techniques to deliver a true-to-life, dense avionics environment for the most accurate analysis of RF communication system performance.

Product

Radio Frequency Scoring Tool

RFST

-

Textron Systems

RFST - Textron Systems

The Radio Frequency (RF) Scoring Tool (RFST) takes the guess work out of RF environment simulation. During RF environment simulation, the RFST provides clear persistent scoring and recording of the RF simulator’s performance. The RFST digitizes all RF signals in the form of digital Pulse Descriptor Words (PDWs) and associated In-phase/Quadrature (I-Q) data. This massive data stream is recorded for later (Post-Scenario) Analysis. Additionally, the RFST provides a real-time visual display of the accuracy of the RF output, easily visible through straight forward real-time indicators. The post analysis tool set allows an unlimited number of users to simultaneously assess previous RF simulator performance with compelling visual representations. The RFST is a perfect complement to our A2PATS product line offering everything you need for comprehensive environment simulation and analysis.

Product

Impedance Analyser Frequency Response Analyser

C60

-

Cypher Instruments

C60 - Cypher Instruments

The C60 investigates the opaque world of analog networks. The unit operates in two test modes. It can measure the frequency response of a two port system producing a gain/loss and phase graph. It can also measure the reactive response of a two terminal network producing an impedance/admittance and phase graph. Electronic, electrical, electro-acoustic and other networks can be tested with sine wave excitation and the results displayed on a PC.

Product

Solution Standard Reference Materials

-

NCS Testing Technology Co., Ltd.

NCS Testing Technology Co., Ltd.

Solution Standard Reference Materials by NCS

Product

Digital Attenuator Operating Frequency of 1 to 20 GHz

LDA Series

-

Vaunix Technology Corporation

LDA Series - Vaunix Technology Corporation

The LDA series of Lab Brick® RF and Microwave Programmable Digital Attenuators includes 50 Ohm and 75 Ohm bidirectional RF step attenuators with calibrated operation up to 20 GHz. These USB powered and controlled units require no additional DC supply voltage. They are easily programmable for fixed attenuation or swept attenuation ramps directly from the included GUI. Lab Brick Digital Attenuator API DLL, Linux drivers and LabVIEW-compatible drivers are also available for custom programming applications.

Product

Standard Voltage 50 Pin D-Type Connectors for Pickering

-

Pickering Interfaces Inc.

Pickering Interfaces Inc.

The connectors below are suitable to use with Pickering cards and modules that utilize a standard voltage 50-pin D-type connector.