Optical Network
A system of interconnected elements that route light signals.
-
Product
Isolated Controller Area Network (CAN)
-
ADI isolated controller area network (CAN) transceivers provide the differential physical layer interface between the data layer link, hardware protocol (for example, embedded in some of ADI's Blackfin® processors), and the physical wiring of the CAN bus. ADI's portfolio includes transceivers with integrated iCoupler® and isoPower® isolation, providing, fully isolated off-the-shelf CAN PHY's.
-
Product
Optical Sensor
-
Sendot develops and produces optical sensors that measure with light. Our optics are unique, our intelligent electronics direct the measurements and convert them into measurement results.
-
Product
Optical Light Sources
-
Wuhan Sunma Technology Co., Ltd.
Fiber Optic Light Sources are a necessity for performing fiber optic network testing to measure the fiber optical loss for both single mode fiber cable and multimode fiber cables. They are designed to cover a variety of wavelength ranges to suit all optical testing needs and usually the optical light sources are used with the fiber optic power meter to test the fiber system loss. Light sources are offered in a variety of types including LED, halogen and laser. Usually the optical light source is used with the fiber optic power meters, they act as an economic and efficient solution for the fiber optic network works. SunmaFiber offers handheld fiber optical light source and laser light source.
-
Product
Optical Fiber Identifier
BD-IF400D
-
Shanghai Baudcom Communication Device Co.,Ltd.
BD-IF400DOptical Fiber Identifier is an important tool for optical maintenance, which isused for nondestructive fiber identification project. Meanwhile it also hasVisual Fault Locator module with fault location function. Useingthe macro bending technology on line for nondestructive testing, BD-IF400DOptical Fiber Identifier can measure the signal direction and power and avoidmisoperation resulting in interrupted lines.
-
Product
Network Analyzer, Tester, RJ45/BNC, LED
72-9940
-
The 72-9940 is a RJ45 Cable Tester with LED meter display. The tester easily tests RJ45 and BNC network cables. It features remote testing which allows to test cables that are terminated at separate locations.
-
Product
Network, Port ID And Cable Tester
One for All PH-400
-
The One For All is an all-in-one network tester, tone generator, cable tester, and port ID finder. It comes with a remote unit, allowing pin-by-pin tests of installed cables in addition to patch cables. The office ID feature allows the user to check the ID number of up to 100 networks or patch panel outlets without labeling the cables manually, and the tone generator traces cable using a tone detectable by any market tone probe. The network tester blinks the network hub or NIC port light for the cable being tested, allowing easy cable and outlet identification; and it identifies network speed (10 Mbps vs. 10/100 Mbps vs. 10/100/1000 Mbps) and activity. Line tester included for detect live circuits and preventing damage to the tester.
-
Product
Optical Hand Clinometer
NECLI
-
F. W. Breithaupt & Sohn GmbH & Co.KG
*Quick determination of slope and height of objects*Robust design*Vertical circle oscillating in precision ball bearings with four different graduations (360°, 400gon, %, reduction scale)*Simultaneous reading of two out of four scales direct in scope*Quick reading because of liquid damping*Reading 0,1°*Made in Germany
-
Product
Rack Type Optical Switch
JW8402
-
Shanghai Joinwit Optoelectronic Tech,co.,Ltd
JW8402 rack type switch is mainly used in optical switching devices and systems to achieve routing, wavelength selection and self-healing protection functions.It can be configured as 1 * 2 / 1 * 4/ 1 * 8 channels and other customized channels according to customer requirements.
-
Product
Optical Distributed Sensor Interrogator
ODiSI 6000 Series
-
The ODiSI 6000 Series is a powerful measurement system specifically designed to address the modern test challenges of advanced materials and systems. The ODiSI system delivers the highest definition distributed sensing of strain and temperature available, giving you maximum insight and visibility into your component or process.
-
Product
Network Analyser And Diagnostics
Module Analyser
-
Module Analyser is a 5 in 1 easy to use CAN bus analyser with the following advantages:■ CAN and LIN monitoring via DBC/LDF/Fibex files ■ Automotive OBD ISO15765 Scan tool and UDS ISO14229■ J1939■ Integrated ODX/MDX editor■ Data acquisition and logging
-
Product
Optical Time Domain Reflectometer
OTDR II
-
The OTDR II (Optical Time Domain Reflectometer) excels in fault finding on fibre cabling with industry-leading specifications and performance levels on both single-mode and multimode fibre networks. Not only does OTDR II deliver accurate test data and pass/fail results, it also offers automated fault-finding capabilities that help to minimise network downtime.
-
Product
FTTH Optical Node
SR202AF
-
Hangzhou Softel Optic Co., Ltd.
SR202AF Optical Receiver has high performance, lower receiver optical power and lower cost for CATV operators providing high quality and excellent FTTH network solution. Product schematic diagram as below:
-
Product
Fiber Optic Terminus
ARINC 801
-
The ARINC 801 fiber optic terminus is the next generation of high density, butt joint interconnect technology. With its standard 1.25 mm ferrule and sleeve, the ARINC 801 terminus is designed for both multimode and single-mode applications. For the pull-proof design, the cable jacket is crimped on an external body and a floating mechanism avoids any loss of performance when pulling on the cable. This feature allows for the use of the connector without a backshell. Standard connector formats include MIL-DTL-38999 type, MIL-DTL-83527 type, ARINC 600 and ARINC 781.
-
Product
Optical Spectrum Analyzer
-
A precision instrument that measures and displays the power distribution of light across a specific wavelength range, plotting power (vertical axis) against wavelength (horizontal axis).
-
Product
Optics Test Systems
WAS 160: Wedge Angle Sensor
-
Optik Elektronik Gerätetechnik GmbH
Portable measuring head for wedge errors and radius of curvature, eg of car windshields, airplanes and helicopters. It can be used for any other glass panes.
-
Product
Fiber Optic Network Test
-
Test and characterize fiber optic cables, assemblies and network with unmatched speed, precision and spatial resolution. Luna’s OBR reflectometers can analyze loss with a spatial resolution and sensitivity unmatched in the industry.
-
Product
LED/CCD Optical Micrometer
LS-7000 Series
-
Breakthrough technology intelligent optical micrometer with 0.01-micron high resolution, 2400 samples/second high speed. Maintenance - free LED emitter and design (no laser diode or motor). High performance controller with statistical analysis. Controller with target viewer available for easy setup
-
Product
Fiber optic thermometer systems
TS Series
-
Micronor now offers a complete range of fiber optic temperature sensors, probes and interfaces for temperature measurement in challenging environments. TS series fiber optic temperature probes offer immunity to RF and microwave radiation along with wide temperature range, intrinsic safety and non-invasive use. The fiber optic temperature probes can operate over -200°C to +300°C (-328°F to +572°C), and withstand harsh and corrosive environments. Typical fiber optic temperature monitoring applications include:
-
Product
Optical Modules
-
VI Systems GmbH introduces the fiber coupled 850nm vertical cavity surface emitting laser (VCSEL) transmitter module VM64-850M for data rates of up to 80 Gbit/s. The transmitter module features a V-connector for the electrical input signal and for the optical output a 50/125 multi mode fiber which is terminated with a standard FC/PC connector. The left picture below shows the module. The picture on the right shows an optical eye diagram at 32 Gbaud (64 Gbit/s) in a back-to-back test configuration as tested by partners at the Heinrich Hertz Institute in Berlin.
-
Product
Multiplex Optical Maintenance Meter
LS280
-
LS280 is used to measure optical maintenance factor for high power LEDs, LED module, LED bulb or other LED luminaries. It is the important measuring equipment for performing the reliability of illuminants. • Freely set the time interval and time extent for automatic measurement • LCD Display, connect with PC via RS232 and English version software. • The test results can export Excel or PDF format and easy to compare. It can be saved by LS280 software or by USB directly. • The engineer can do LED life analysis based on the LS280 test results. • LS280 worked with High Power LED Aging Test (LS600), Multiplex LED Temperature Test (TMP-8/TMP-16) and High and Low Temperature & Humidity Chamber (GDJS-*B), it can do Flux VS Temperature VS Time, which is a perfect instrument system to meet LM-80 request.
-
Product
Optics Test Systems
F Number Meter
-
Optik Elektronik Gerätetechnik GmbH
The f-number of a camera lens is defined as the quotient of the focal length f' and the diameter of the entrance pupil. The f-number measuring device is a simple structure for the automatic, software-controlled measurement of the f-number of optical systems.
-
Product
RF And Others Network Mezzanine Card
-
a specialized, compact daughterboard designed to attach parallel to a host board (such as an FPGA carrier card, blade server, or embedded system) to provide high-speed Radio Frequency (RF) and network connectivity, such as software-defined radio (SDR) or data conversion (ADC/DAC)
-
Product
2U Rackmount Network Appliances
-
High performance network appliances with rich mezzanine cards and IPMI management, used for Gi-LAN, UTM, SeGW, DPI or load balancing applications.
-
Product
Software-Defined Networking
-
Schweitzer Engineering Laboratories, Inc.
SEL SDN is an Ethernet switch solution optimized for operational technology (OT) LANs.
-
Product
Wireless Network Penetration Testing
-
LGMS wireless network penetration testing uses automated and manual penetration techniques to locate and map authorized and unauthorized wireless access points, review corporate access point configuration and then discover weaknesses that could allow an attacker to penetrate those networks. Potential internal and external threats are documented, and a recommended action plan is developed to address any security risks.
-
Product
Fixed Network Thermal Cameras
FLIR FC-Series R (Automation)
-
The FC-Series R features on-board, non-contact temperature measurement capabilities for fire detection, safety, and thermal monitoring of substations, waste disposal, and valuable equipment. FC-Series R combines state-of-the-art image detail and on-board video analytics to provide reliable detection. Flexible alarming options include email, web and mobile apps, edge image storage, digital outputs, or VMS event notifications.
-
Product
Outdoor AGC Optical Node
SR814WA
-
Hangzhou Softel Optic Co., Ltd.
*SR814WA series of 1310nm optical relay station is a two-way optical connector with HFC network engineering experience and equipment development experience accumulate for many years by ourselves only for HFC two-way Broadband Network. This product is designed with full consideration of network topological structure.The building block system modularized structure is adopted in SR814 Series *Field Optical Work station. It has flexible configuration and convenient debugging, and solves engineering and technical problems of collecting noise with two-way return path network. And it meets the requirements of modern CATV business network security transmission with high reliability of FTTB (Fiber to the Building).*SR814WA and SR814WB Optical Workstation are four way independent output models; WR-8604HB and WR-7504HB Optical Workstation are two way independent output models.*SR814WA Optical Workstation is our latest flagship product. Advanced optical AGC control circuit adds to the part of optical receiving to ensure the input optical power as low as -9dBm.
-
Product
Streamline Vector Network Analyzer, 9 KHz To 6.5 GHz, 4 Or 6-port
P5021B
Vector Network Analyzer
Compact, faceless, vector network analyzer (VNA). Flexible four or six-port VNA dramatically reduces your size of test. Up to 6.5 GHz.
-
Product
Power Networks Test
TX8000
-
The TX8000 is a 6 Km range Time Domain Reflectometer housed in a rugged over moulded case being water proof to IP67 and drop resistant, designed for outdoor use, but sufficiently small and light weight for general use and may be operated using one hand. Using a 3.5-inch QVGA colour display information is clearly displayed; an illuminated keypad makes the TX8000 ideal for use in poorly lit areas.
-
Product
ENA Vector Network Analyzer
E5080A
Vector Network Analyzer
9 kHz to 4.5/6.5/9 GHz, 2- or 4- port, 50 ohmWide dynamic range 152 dB (typical)Fast measurement speed 3 ms (401 points)Low trace noise 0.0005 dBrms (typical)High temperature stability 0.005 dB/CWide source power range 90 to +15 dBm (spec)Intuitive touch-based GUI on large, high-resolution 12.1" screenE5071C/8753 code compatibility Every spec verified, adjustments included Lock in support & peak performance from the start
