-
Product
Miniature Quartz Force Sensors
-
Often the test engineer will try to take low level measurements with a sensors not rated for these low levels. Due to insufficient sensitivity the resulting data may be noisy, hard to analyze or unusable. Using the appropriately sized and ranged PCB Miniature Quartz Force Sensor solves the problem and gives reliable data at a Low Amplitude level. The miniature sensor configuration permits low-amplitude, dynamic compression, tension, and impact force measurements.
-
Product
Liquid Level Sensors
-
Panasonic Industrial Devices Sales Company of America
Liquid Level Sensors
-
Product
CCD and Imaging Front Ends
-
Analog Devices is the premier supplier of high performance analog front-end devices in CCD/CIS imaging and time-of-flight applications. Many leading manufacturers of security cameras, machine vision cameras, high-resolution scanners, and other imaging systems depend on ADI’s products to deliver the highest performance with the lowest power dissipation in the market.
-
Product
Inductive Sensors
-
Wide operating temperature range. High protection rating for the requirements of harsh industrial environments. Reliable detection due to low sensor tolerances. Reduced inventory due to wide range of applications.
-
Product
RTD Sensors
-
Are sensors used to measure temperature. Many RTD elements consist of a length of fine wire wrapped around a ceramic or glass core but other constructions are also used. The RTD wire is a pure material, typically platinum, nickel, or copper.
-
Product
Space & Science Imaging
-
Teledyne e2v has been trusted to design and deliver CCD and CMOS imaging sensors and sub-systems for over 150 space missions by the world's largest space agencies, including NASA, ESA, JAXA, CNSA and most recently for the Russian-led World Space Observatory.We offer space imaging solutions, including space qualified imaging sensors, arrays and sub-systems for space science, ground astronomy and Earth observation; helping solve the mysteries of the Universe and understand climate change on Earth.
-
Product
Cryogenic Temperature Sensors
Interchangeable Rox™
-
Ruthenium oxide temperature sensors are thick-film resistors, with most models suitable for use in magnetic field applications. These composite sensors consist of bismuth ruthenate, ruthenium oxides, binders, and other compounds that allow them to obtain the necessary temperature and resistance characteristics. Each Lake Shore Rox™ model adheres to a single resistance versus temperature curve.
-
Product
PSI5 Sensor Interface Card
SET-1640
Interface Card
PSI5 is an open standard based on existing sensor interfaces for peripheral airbag sensors and has already proven itself in millions of airbag systems.
-
Product
Guided Wave Radar Sensors
LVRD10 Series
-
The LVRD10 Series guided wave radar transmitters provide continuous level measurement with a 4 to 20 mA signal output. Offered in single rod, coaxial, or weight & cable probes in 3 or 6 foot lengths
-
Product
Nano-Position Sensors
-
ZYGO nano-position sensors are widely used in closed-loop motion control systems like photolithography and semiconductor inspection tool stages, as well as for deformable optical systems. We have pioneered innovations in the displacement and position sensors for over 30 years, and we work closely with applications requiring the highest precision and reliability. Our team of applications experts is ready and able to help you tackle your position metrology needs.
-
Product
Sensor Conditioner
Trig-TekTM 368A
-
Accept inputs from ICP-type sensors with quad outputs proportional from 4 to 20 mA
-
Product
Sensor Solutions for IoT
-
Imec is a reference in the design of ultra-low power electronics, low-power algorithms to increase intelligence and data security, and in all aspects of data science. Our multi-sensor environmental monitoring platform features sensors for temperature, relative humidity, NO2, CO2, VOC (volatile organic compounds), particle matter, ambient light, sound, vibrations and presence detection. Our test platform is suitable for indoor and outdoor air quality monitoring and control, and can be used in smart buildings, smart cities and more.
-
Product
In Vivo Signal Detection & Intelligent Image Analysis Software
VISQUE®
-
Patented algorithms for kinetic analysis of molecular diffusion phenomenon- Tmax, Tarrival, Imax, Iarrival, Trising, 1st Peak, FluAngio, DyAngio, etc.Kinetics visualization with feature mapsTime-series kinetics graphs
-
Product
IO-Link Position Sensors
-
*Capacitive sensors for position detection or level monitoring*Distance sensors with very long range and background suppression*Ultrasonic sensors for non-contact detection of objects*Photoelectric sensors for specific applications*With switching output, analog signal and IO-Link
-
Product
Force Sensors
-
Piezoelectric force sensors, respectively piezoelectric force transducers or load cells, are perfectly suited for the precise measurement of compressive and tensile forces, both in highly dynamic applications and in quasi-static processes. In universities and industry, for basic research or quality assurance: exact data is always essential in order to measure force characteristics and make processes more cost-effective. Thanks to their rugged design, piezoelectric force sensors from Kistler keep precise track of quasi-static and highly dynamic force processes, even when conditions are difficult. Our force sensors can also handle simultaneous measurements of multiple orthogonal force components.
-
Product
Ultra Lightweight Multi-Spectral Imager
Recon® V Ultra Lite
-
Fully operational at less than three pounds, the breakthrough Recon V Ultra Lite provides mid-range target detection, recognition, recording and geo-location with an HD color camera and high sensitivity thermal channels. Powered by commercially available AA batteries, the unit has a run time greater than two and a half hours with smart power management. Combining with a highly accurate laser range finder, GPS, digital magnetic compass and intuitive user interface, targets can be quickly located 24/7.
-
Product
ESD Voltmeters And Sensors
-
Achieve High Accuracy Without Fixed Spacing Requirements. We offer diagnostic tools for ESD in-line sensing and hand-held electrostatic voltmeters that are ideal for use in ESD-sensitive environments. Accurately measures surface voltage or charge build-up over a wide range of spacings.
-
Product
Car Oxygen Sensor
KS60044
-
Konstar Electric Industrial Co., Ltd
An oxygen sensor, also known as a lambda sensor, continually detects the oxygen content in the exhaust gases of an engine. The oxygen sensor output signal informs the vehicle's ECU (Electronic Control Unit) whether the AFR (Air-Fuel Ratio) is lean or rich. Based on this, the ECU adjusts the amount of fuel injected into the engine to achieve an optimal AFR.
-
Product
Hall Effect Sensors
906
-
Features • NPN open collector, square-wave output • Zero speed operation with no signal loss • Non-contact, large gap distance sensing • Signal transmits up to 1,500 ft • Simple to install and set up • Powered by 5-24 VDC • Bi-directional option 906B
-
Product
Sensors
-
A speed and angle sensor using a black/white tape which is glued on a rotating part. The reflection is converted into a TTL signal, bandwidth 100 kHz. The sensor consists of a tiny electronics part and a 5 m fiber optic cable terminated with a M6 screw. Thus areas where space is very limited still can be reached conveniently.
-
Product
Bearing And Surface Temperature Sensors
-
Can be used to monitor temperature on a wide range of industrial machinery including conveyors, bucket elevators, motors, gearboxes, pumps, turbines, fans, curing ovens, centrifuges, agitators and hammer mills.
-
Product
DC current Sensors
CTH
-
The CTH sensors convert dc current to an isolated voltage output, the CTHR sensors convert ac current to a dc output signal proportional to the Arms. All popular process control voltage and current loop outputs are available. Through hole or split core options mean that connection is non-intrusive and straightforward. The available input range of the CTH sensors is any value from 5A to 6000Adc.
-
Product
Wireless sensors for humidity
-
The wireless transmitters in the EE240 series combine state-of-the-art sensor technology with excellent transmission reliability. Installing the wireless measurement system is very easy and one network can contain up to 500 transmitters. Wireless transmitters EE244 and EE245 are ideally suited for wireless, high-quality measurement of humidity and temperature.
-
Product
Photoelectric Sensors
-
Panasonic Industrial Devices Sales Company of America
The advanced optical system of the PX-2 Series reduces the null zones in front of an automatic guided vehicle (AGV). The null zones on the sides are further minimized if auxiliary Sensors, which can be easily mounted with a Connector, are used.
-
Product
Zirconia Oxygen Sensors
-
PST offer a range of zirconia oxygen sensors that use a unique closed loop measurement system.The sensing technology and stainless-steel construction allow Zirconia oxygen sensors to be used in environments where extreme pressure, temperature and high humidity are present.
-
Product
Robotic Finger Sensor V2
-
Does your robot crush objects with its hulkishly strong grip? Give your robotic hand or claw a better sense of touch with the Robotic Finger Sensor. This new version adds pressure sensing so now you can know how hard you're gripping!
-
Product
Position / Distance / Proximity Sensors
-
Panasonic Industrial Devices Sales Company of America
Easy-to-use Inductive Proximity Sensors provide stable detection for automation, with Sensors for standard to high speed, high performance solutions. These Inductive Proximity Sensors detect the presence and position of ferrous and non-ferrous metal objects and come in a range of IP Ratings (IP50 / 67 / 68 / 68g). The IP68g enclosure allows usage in very harsh environments. For high speed, high accuracy measurement, Laser Measurement Sensors are ideal for the precise measurement of thickness, diameter and height. Panasonic’s HG-C Series CMOS Type Micro Laser Distance Sensors deliver high repeatability for measurement distances (center) of 30mm, 50mm, 100mm, 200mm and 400mm. Ideal to measure insertion depths or thickness, these Sensors can also be used to detect warping, overlaps and presence helpful for preventative maintenance and remote monitoring. Select models are IO-Link compatible for ease of use.
-
Product
AMR Switch Sensors
-
MultiDimension Technology Co.,Ltd.
A 360-degree digital omnipolar magnetic switch that integrates anisotropic magnetoresistance (AMR) and CMOS technology in order to provide a magnetically triggered digital switch with high sensitivity, high accuracy, and low power consumption.
-
-
Product
Adaptive Infrared Imaging Spectroradiometer
AIRIS
-
The Adaptive Infrared Imaging Spectroradiometer (AIRIS) has been developed for real-time standoff detection of chemical vapors and biological aerosols as well liquids and solids (such as chemical agents and trace explosive residues) on surfaces.
