Dark Field
-
Product
PCB Transmission Line Field Solver
Si9000e
-
With its fast, accurate, frequency-dependent transmission line modelling, the new Si9000e is designed to model transmission line loss, impedance at given frequencies and extract full transmission line parameters over a wide range of popular PCB transmission lines (over 90 structures).
-
Product
Near Field Probes 30 MHz - 6 GHz
XF Family
-
The XF family consists of 4 passive magnetic field probes and 3 passive E field probes designed for measuring magnetic and E-fields in ranges from 30 MHz to 6 GHz during the development phase. Due to their integrated impendance matching the probes are less sensitive in the lower frequency range than the RF type probes.
-
Product
Field thermal needle system for thermal resistivity / conductivity measurement
FTN01
-
Hukseflux Thermal Sensors B.V.
The FTN01 Field Thermal Needle System allows performing fast, on-site measurements of the thermal resistivity or conductivity of soils, in particular around the typical depth of burial of high voltage cables. FTN01 is designed with a focus on robustness and saving time, while still offering sufficient accuracy for typical field measurements. The sensor is a Non-Steady-State Probe (NSSP), TP09, which is mounted at the tip of the Lance LN01. The system is operated using a hand-held Control and Readout Unit CRU01.
-
Product
Impulse Magnetic Field Immunity Tester
IMF61000-9
-
IMF61000-9 impulse magnetic field immunity tester is high performance test instrument which special designed for to do impulse magnetic field immunity test and fully meet IEC61000-4-9, EN61000-4-9 and GB/T17626.9 standards, also it come with high intelligent, high stable performance and easy operation characteristics.
-
Product
Hand-hold Field Intensity Meter
LM870-N
-
Sichuan Jiuzhou Electronic Technology Co.,Ltd
* Trunk-line AC voltage, V/A, C/N and TILT measurable* Automatic over-voltage shut-off protection* AC/DC optional (Ni-H/Li storage battery inside)* Full-digital key-board operation, direct freq. & channel input* Automatic scanning, Automatic channel-filtering, Automatic error-operation amending* All standard channels and subjoin channels pre-set inside* New channel-table setting according to user's special requirement* Spectrum displaying* English/Chinese operation interface* Audio output (speaker set-in)
-
-
Product
Magnetic Field Meter
-
Measurement for the magnetic field generated from Direct Current (DC, with display by N/S Magnetic polarity) or Alternating Current (AC in 40-500Hz).
-
Product
Static Field Meters and Ionization Test Kits
-
Portable Meter for Testing of Electrostatic FieldsMeasures surface voltage and polarity on objects up to 19.99 kV at a distance of 1 inch.Durable Dissipative Housing Design with Membrane Switches (NEW)Protects meter from physical damage and minimizes wear.LED Range FinderRed ranging lights help
-
Product
Cryogenic Low Noise Magnetic Field Transducer
K3A
-
The SENIS K3A cryogenic low noise magnetic field transducer is engineered to deliver highly accurate measurements of the amplitude and direction of magnetic fields at extreme cryogenic temperatures, extending down to approximately 1 K. This innovative instrument features a compact sensor head boasting dimensions of just 4.5 x 4.5 x 9 mm, integrating a robust 3-axis Hall sensor that guarantees precision in magnetic field readings. Notably, it incorporates the world’s smallest field-sensitive volume, measuring less than 0.6 mm³, making it a premier choice for applications requiring compact and efficient magnetic field measurements.Equipped with cutting-edge electronics, the K3A transducer provides exceptionally low drift and ultra-high resolution in its measurements. The device outputs an analog voltage for each magnetic field direction (Bx, By, Bz), facilitating accurate assessment of magnetic fields. Optional high precision calibrations are available, achieving an impressive accuracy of 0.25% and accommodating magnetic fields up to ±9 T, even at cryogenic temperatures as low as 4 K. This instrument is ideal for researchers and engineers needing reliable and precise magnetic field measurements in challenging environments.
-
Product
Near Field Probes 30 MHz up to 3 GHz
RF2 set
-
The RF2 near field probe set consists of 4 passive near field probes for measurements in the development phase of the magnetic field in the range from 30 MHz to 3 GHz on electronic assemblies. The probe heads of the RF2 set allow the step by step localization of interference sources of the RF magnetic field on assemblies. From greater distances the electromagnetic interference can be detected by RF-R 400-1 and RF-R 50-1 probes. The RF-B 3-2 and RF-U 5-2 probes with their higher resolution can more precisely detect the interference sources. Field orientation and field distribution on an electronic assembly can be detected through a trained special use of the near field probe. The near field probes are small and handy. They have a sheath current attenuation and are electrically shielded. They can be connected to a spectrum analyzer or an oscilloscope with a 50 Ω input. They do not have an internal terminating resistance.
-
Product
Field Current Regulator
-
We are counted amongst the leading names in the industry, offering wide range of Field Current Regulator. Our entire product line ensures easy operations and is performance based. Field Current Regulator are quality tested and are delivered in standard configurations. Our entire product range has high strength and is delivered at most affordable rates.
-
Product
3-axis Magnetic field Sensor
FLC3-70
-
Compact, low-power, 3-axis fluxgate magnetometer for the measurement of weak magnetic field down to nanoteslas. Due to its rugged design and extended operating temperature range suited for automotive and aerospace applications and for deep drilling tools.
-
Product
Magnetic Field Logger Sensor
NUL-214
-
This is a very sensitive magnetic fields sensor. It can measure a very low level of magnetic fields such as the magnetic field of Earth.The logger sensor measures the magnetic fields in milli Tesla (mT).
-
Product
TestTools for Lab & Field
-
Analyzer designed to be used on the field to generate maps including measurements of the field quality of service, enabling identification of reception issues and efficient troubleshooting.
-
Product
Magnetic Field Meter / Gaussmeter
MP-4000
-
The MP-4000 gaussmeter features a graphic LCD touch panel with an innovative user interface and a resolution of 320x480 pixels. An outstanding feature of the new probe electronics is the fast digitization of the measured values with a frequency of up to 200 kHz. This makes it possible to display waveforms with a duration of only 0.1 milliseconds.
-
Product
Search Coils And Field Measuring Coils
-
Designed to measure the magnetic flux on magnets or in the airgap of magnet systems.
-
Product
3D/2.5D Time-Domain Electromagnetic Field Solver Software
EM-CORE ®
-
3D/2.5D Time-Domain Electromagnetic Field Solver Software for Planar-Circuit and Antenna Simulation. 3D & 2D Radiation Patterns Modeling, Spiral Inductors Modeling, 3D EM Modeling of Filters, Intuitive Geometry Build, and more!
-
Product
Magnetic Field Generator
-
The Com-Power APF-5060 magnetic field generator is specifically geared towards generating magnetic fields for immunity testing. The APF-5060 with its corresponding loop antennas provide a standalone solution for magnetic field immunity testing as per IEC/EN 61000-4-8 and all the derived product standards.
-
Product
Power Monitor, AC-Powered, Field Adjustable
YMA/YQA
Power Monitor
NAI's YMA and YQA Power Monitors are used to monitor voltage, frequency, and phase characteristics of single- or three-phase power lines. This allows normal operation of system loads when the power-line characteristics are within predetermined limits.High and low voltage and frequency limits, and "pick-up" and "drop-out" time delay are field-adjustable using potentiometers. These power monitors are ideally suited for rugged defense and industrial applications.
-
Product
New Generation Analyzer for IPTV Field Servic
NetProbe 2000 IPTV
-
New Generation Analyzer for IPTV Field Service The NetProbe 2000 IPTV is the newest, state-of-the-art handheld analyzer on the market for field testing of IPTV customer services. It can monitor up to 40mbps of IPTV traffic and emulate a Set-top box.
-
Product
Field Testing
-
When Laserline delivers a customer-specific solution, it makes sure that it fulfills every demand in the practical field. And that is because every newly designed customer solution is extensively tested in our own application laboratory and has passed comprehensive stress tests. These tests are made in close consultation with our customer as well. In this way, it is guaranteed that the demands are correctly identified and addressed with respect to practice.
-
Product
Field Strength Measuring Instruments and Sensors
-
MAGNET-PHYSIK Dr. Steingroever GmbH
Field strength measuring devices are measuring devices for measuring the magnetic flux density B (formerly also called induction) and the magnetic field strength H of direct and alternating fields. They are also called Gaussmeters or Teslameters.
-
Product
Field Portable Wire Analyzer
Model 2635
-
The perfect tester for field use is rugged, mobile, and lightweight, without sacrificing the functionality and power of a larger system. That tester is found in the Model 2635. Weighing 32 pounds (14.5 kg), this wiring analyzer handles up to 400 test points of Series 10 switching per unit. The 2635 can be powered from any AC source 100-240 VAC or 28 VDC so you can use it anywhere in the world.
-
Product
Digital TV Field Strength Meter
TM981 Series
-
TM981 digital/analog signal measurement. can measure digital average powe.
-
Product
MAGNETIC FIELD CAMERA SEN-3D-CAM
SENCAM
-
Introducing the **SENCAM – MAGNETIC FIELD CAMERA SEN-3D-CAM**, the world's first true 3D magnetic field camera designed for unparalleled precision and speed. Engineered with the cutting-edge Senis proprietary 3D Hall technology, this remarkable camera captures all three magnetic field components—Bx, By, and Bz—simultaneously. The compact, lightweight design allows it to easily fit into tight workspaces, making it the ideal choice for applications in magnetic systems development, quality assurance, and production line inspections. With a world-class spatial resolution of 100 µm and a sensitive volume of just 27µm x 9µm x 4µm at each pixel, users can expect highly accurate representations of magnetic fields, even in complex scenarios where field gradients are significant.SENCAM operates at an impressive image acquisition rate of up to 7 images per second, allowing for real-time tracking and analysis of magnetic fields. The camera boasts 16,000 pixels across its imaging surface, solidifying its status as a leader in high-speed magnetic imaging technology. Coupled with USB-C connectivity, data transmission is streamlined for immediate analysis and visualization. Additionally, with the optional Senis 2D Vision Commander Software, users can perform advanced magnetic image analyses, enabling sophisticated interpretation of magnetic data. Whether used in laboratories or industrial settings, the SENCAM is transforming the landscape of magnetic field measurement.
-
Product
Near Field Probes 30 MHz up to 3 GHz
RF1 set
-
The RF1 near field probe set consists of 4 passive near field probes for making measurements in the development phase of E-field and magnetic field in the ranges of 30 MHz to 3 GHz on electronic assemblies. The probe heads of the RF1 set allow for measurements close to the electronic assemblies, e.g. on single IC pins, conducting paths, components and their connectors in order to localize interference sources. Field orientation and field distribution on an electronic assembly can be detected through a trained special use of the near field probe. The near field probes are small and handy. They have a sheath current attenuation and are electrically shielded. They can be connected to a spectrum analyzer or an oscilloscope with a 50 Ω input. They do not have an internal terminating resistance.
-
Product
Field Strength Meter
FIM-72A UHF
-
The Model FIM-72A is a portable, laboratory quality Field Strength Meter designed for rigorous field applications. Combining a calibrated half-wave dipole antenna and a highly accurate tuned voltmeter with a range of 140 dB, the FIM-72A is suitable for practically all types of RF emission measurements in the 450 MHz to 960 MHz spectrum. The operator can switch select wide or narrow bandwidth, peak or average value of TV or pulse modulated signals, AM or FM demodulation, and meter dynamic range of either 20 dB or 60 dB. A dc analog voltage, proportional to meter indication, is provided for driving a chart recorder or similar device. A leveled output from the calibrating generator is available for measuring cable insertion loss, filter response, amplifier gain, VSWR, and other signal ratio measurements. The 4-1/2 inch, taut band, mirrored scale meter is calibrated in volts and dB for precise measurements in field or laboratory environments.
-
Product
On-Site Field Testing & Evaluation
-
MET is a highly-regarded resource for electrical inspection agencies within the United States and Canada to assure compliance of unlabeled equipment in the field. Field evaluations are performed by MET Laboratories on unlisted equipment to support the Authority Having Jurisdiction.
-
Product
Magnetic Field Meter / Gaussmeter
MP-810
-
The small, compact List-Magnetik MP-810 operates with the same precision as larger magnetic field meters. It is easy to use and accurately measures direct current (DC) and alternating current (AC) fields, as well as maximum values for pulse fields.
-
Product
Magnetic Field Testing
-
Response Dynamics Vibration Engineering, Inc.
As magnetic field consultants, we have been working with magnetic field issues for sensitive tools for many decades from cutting edge development of scanning electron microscopes (SEMs) to active cancellation systems for MRI tools, to site surveys for specification compliance, debugging, and tool Magnetic Field Sensitivity Testing.
