Product

Multi-Band Dual-Channel Receiver/Combiner, 4U Rack Mount System with Integral Tracking Receivers and Bit Syncs

LS-28-DRS Series

-

Lumistar Inc.

LS-28-DRS Series - Lumistar Inc.

Lumistar offers the LS-28 series of high performance multi-band multi-mode RF Receiver/Combiners in several different versions including rack mount, portable and modular formats. Complete solutions from RF to bits and/or RF to UDP data broadcast in Chapter 10 format are available. Available at any frequency range from 215 MHz to 6000 MHz, data rates to 50 Mbps.

Product

G20x - 28 Module Pull-Thru, Scalable Receiver

-

Virginia Panel Corporation

Virginia Panel Corporation

G20x offers the features of the G20 system, and adds an additional 8 modules in an extended tier for higher I/O needs. This solution uses 6.75" Series Pull-Thru Adapters.

Product

EMI Test Receivers

-

Rohde & Schwarz GmbH & Co. KG

Rohde & Schwarz GmbH & Co. KG

EMI test receivers; extremely accurate instruments designed to detect electromagnetic emissions rigorously, to ensure all emissions conform to the Standard being tested to. Configured to set up running the required tests for parameters defined by the Standards as simply as possible, including automated test routines. R&S EMI test receivers can be much more too, with a full signal and spectrum analyzer in the same instrument.

Product

950~2400MHz DVB-S 4 ways SAT-IF DWDM Optical Transmitter & Receiver

HDBS-4000DW

-

Hangzhou Huatai Optic Tech. Co., Ltd.

HDBS-4000DW - Hangzhou Huatai Optic Tech. Co., Ltd.

Huatai HDBS-4000DW series, combine 4 pieces C-Band, 100GHz, ITU standard wavelength SAT-If optical transmitter, or optical receiver to one chassis, through DWDM, Make 4 ways optical MUX (TX) or DEMUX (RX), through one fiber, used in transmitting 4 ways different polarization SAT-IF signal of one satellite VL, VH, HL, HH with high performance. Installation flexibility.

Product

GEOPHYSICS, SEISMIC, and ATMOSPHERICS RESEARCH RECEIVER

Type RAS-1

-

National RF, Inc

Type RAS-1 - National RF, Inc

Called the RAS-1, the receiver is designed for ultra low and very low frequency scientific research work, including the exploration of low frequency emissions due to seismic and earth-quake activity, study of atmospheric phenomenon such as "whistlers", and low frequency Sudden Ionospheric Disturbance (SID) and electromagnetics phenomenon. The RAS-1 will receive signals from under 200 Hz. To over 250 KHz in both narrow bandwidth modes as well as broad badnwidth reception.

Product

G40x - 48 Module Pull-Thru, Scalable Receiver

-

Virginia Panel Corporation

Virginia Panel Corporation

G40x is a two tier, 48 module system that enables pull-thru removal of 40 VPC modules, pull-thru adapters and test instrumentation in one piece. It offers 8 standard/90 Series discrete-wire module slots, plus space for 2 iCon modules, as needed. This solution uses 6.75" Series Pull-Thru Adapters.

Product

Alert Receiver Software

SafAlert

-

ComTekk Engineering, LLC.

SafAlert - ComTekk Engineering, LLC.

SafAlert is an autonomous alert decoder triggered by any programmable single, dual, or sequential tone signal, such as EAS, NOAA, or 2-tone fire alarm page. User-programmable visual, audible and email alerting

Product

2-18GHz Digitising Receiver

DR068-M1

-

Teledyne Defence & Space

DR068-M1 - Teledyne Defence & Space

Teledyne Defence & Space (TDS) DR068-M1 Digitising Receiver combines a state of the art broadband frequency measurement receiver with a high dynamic range successive detection log video amplifier to realise a high probability of intercept receiver. Digital signal processing techniques are utitlised to derive pulse parameters which are packaged into a PDW and transferred via a low latency Gigabit Ethernet interface. The DR068-M1 enables new and existing systems to incorporate a wideband high POI pulse detection capability with minimal integrating effort.

Product

Perseus SDR HF Receiver

-

Hoka Electronic B.V.

Hoka Electronic B.V.

PERSEUS is a VLF-LF-HF receiver made by Microtelecom is based on a outstanding direct sampling digital architecture. It features a 14 bit 80 Ms/s analog-to-digital converter with an exceptional 76 dB SNR (BW = 40 MHz), an high-performance configurable FPGA digital down-converter with an up to 1 MS/s output sampling rate and a 480 MBit/s, high-speed USB 2.0 PC interface. Unlike in lower class direct sampling receivers, the PERSEUS RF analog front-end has been carefully designed for the most demanding users and includes a 0-30 dB, 10 dB steps attenuator, a low-loss 10 bands pass-band RF preselector filters bank, and an high dynamic preamplifier with a top-class input third-order Intercept Point of more than 30 dBm. The resulting third-order dynamic range is 103 dB for SSB signals (2.4 KHz BW) and 107 dB for CW signals (500 Hz BW).

Product

EMI Receiver

KH3939

-

Beijing KeHuan Century EMC Technology Co,.LTD

KH3939 - Beijing KeHuan Century EMC Technology Co,.LTD

KH3939 type EMI test receiver interference test receiver is fully automatic, is EMI major tool for testing. The frequency range of the KH3939 receiver is from 9kHz to 300MHz , which satisfies the power line disturbance power test. After configuring the artificial power network, the power terminal disturbance voltage test can be carried out. The machine has fast test speed, strong maneuverability, stable performance, Advantages such as convenient test data processing. The KH3939 receiver uses a USB interface for data transmission, and supports USBinterface peripheral devices such as printers, mice, keyboards, etc. The machine is equipped with a high-speed and large-capacity hard disk, which stores a variety of external device data, and supports plug and play. External test equipment. The software is self-developed by our company, using windows as the carrier, users who are familiar with the operation of windows can quickly get started. The machine can independently carry out test work without additional control equipment for control operations, which fundamentally solves the problem of interference sources. The measurement results can be input to the hard disk in the receiver or stored in a floppy disk through a floppy drive or printed out directly or savedusing a USB storage device. The detailed measurement report can be printed directly according to user needs without additional editing.

Product

Scanning Receivers

-

PCTEL, Inc

PCTEL, Inc

PCTEL® scanning receivers are precision network testing tools. Designed for drive testing, walk testing, troubleshooting, and monitoring of cellular, WiFi, IoT, and critical communications networks worldwide, they provide the insights you need to improve coverage and quality of service throughout the wireless network lifecycle.