Electromagnetic Interference Receiver
measure radiated emissions for compliance to EMC standards.
-
Product
VTAC, Patchcord, Receiver, 72", VTAC, DVI-D, to DVI-D Male
7-142706735-072
VTAC Patchcord
VTAC, Patchcord, Receiver, 72", VTAC, DVI-D, to DVI-D Male.
-
Product
Cable Assembly, Receiver, TriPaddle, 36", 37-Pin Female D-Sub
540016010201
Cable Assembly
Cable Assembly, Receiver, TriPaddle, 36", 37-Pin Female D-Sub
-
Product
Cable Assembly, Receiver, QuadraPaddle, 36", 8 20-Pin Ribbon Cable Connectors
540160010240
Cable Assembly
Cable Assembly, Receiver, QuadraPaddle, 36", 8 20-Pin Ribbon Cable Connectors
-
Product
Full-function Top-class Self-heal Circle AGC Optical Receiver
HR9236, HR9253
-
Hangzhou Huatai Optic Tech. Co., Ltd.
Guangtai HR9236, HR9253 builds in two ways optical receiving. When one way is out of work, it will automatically switch into the other way that is heat backup circle design. This series products adopt full-function and top-class designation, so it is suitable for high-end subscribers.
-
Product
Cable Assembly, Receiver, QuadraPaddle, 20", 100-Pin Male SCSI
540009010140
Cable Assembly
Cable Assembly, Receiver, QuadraPaddle, 20", 100-Pin Male SCSI
-
Product
Electrical Receiver Conformance Test Application for IEEE 802.3bs/ cd
M8091BSCA
-
IEEE 802.3bs receiver test application for 200GAUI-4 and 400GAUI-8, covering chip-to-module, chip-to-chip, backplane, and copper cable interconnects.
-
Product
Cable Assembly, Receiver, TriPaddle/Coax, 20", 68-PIN Male VHDCI, 4 SMA Plugs, 2 SMB Plugs
540170010143
Cable Assembly
Cable Assembly, Receiver, TriPaddle/Coax, 20", 68-PIN Male VHDCI, 4 SMA Plugs, 2 SMB Plugs.
-
Product
Airborne Receiver
MS 2015
-
Receiver shall receive the telemetry signal transmitted by the airborne TGS unit. This unit is a single conversion super heterodyne FM receiver operating at 1486.5MHz. This unit has four connectors. They are RF input connector (J1), Power connector (J2), Signal connector (J3) for AGC signal and a Video output connector (J4). This unit operates at 28V DC and consumes a typical power of 5.6 watts.
-
Product
PCIe Clocks: Time Signal Receiver For The PCI Express Bus
-
Meinberg Funkuhren GmbH & Co. KG
Although the PCI Express bus is software-compatible with other PCI implementations, the hardware of these PCIe plug-in cards is based on a different concept.Fewer lines are used for data transmission than, for example, with PCI plug-in cards - a high transmission rate is achieved by using a fast serial protocol.
-
Product
PCI Express 5 Base Specification Receiver Test Automation
N5991PB5A
-
The N5991PB5A is the receiver test automation software for bit error ratio testers, allowing you to test and characterize PCI Express 5.0 ASICs
-
Product
Cable Assembly, Receiver, 20", QuadraPaddle to 2 x 78-Pin Female D-Sub Connectors
540112050140
Cable Assembly
Cable Assembly, Receiver, 20", QuadraPaddle to 2 x 78-Pin Female D-Sub Connectors
-
Product
Receiver, S6, 6 Module
310122100
Receiver
The S6 Receiver is designed to mount to a rack or directly to a tabletop. The 1U high unit features positive-latching mechanisms and integrated guide pins to create a highly reliable engagement system. The S6 Receiver is very versatile and has module positions screened on the top for ease of module placement.
-
Product
Cable Assembly, Receiver, 20", Mini Power, 19 Pin to 4 Banana Plugs
540067010108
Cable Assembly
Cable Assembly, Receiver, 20", Mini Power, 19 Pin to 4 Banana Plugs.
-
Product
Strain Relief Stand-off Kit, ICon, Receiver
310113582
Strain Relief
Strain Relief Stand-off Kit, iCon, Receiver.
-
Product
Cable Assembly, Receiver, Mini Coax, 20", 9 SMB Plugs
540062010107
Cable Assembly
Cable Assembly, Receiver, Mini Coax, 20", 9 SMB Plugs
-
Product
VTAC, Patchcord, Receiver, 36", VTAC, DACAR 535, Double Ended
7-142702142-036
VTAC Patchcord
VTAC, Patchcord, Receiver, 36", VTAC, DACAR 535, Double Ended
-
Product
Cable Assembly, Receiver, TriPaddle, 48", 78-Pin Female D-Sub
540034010603
Cable Assembly
Cable Assembly, Receiver, TriPaddle, 48", 78-Pin Female D-Sub
-
Product
Twelve-Channel Cable/Terrestrial Receiver for PCIe
DTA-2139C
-
Twelve (!) receivers on one card, supporting a mix of terrestrial (ATSC 3.0, ATSC 1.0, DVB-T/T2, ISDB-T) and cable (DVB-C/C2, ITU J.83) signals. All twelve channels are demodulated simultaneously, allowing you to monitor a complete network in real time.
-
Product
VTAC, Patchcord, Receiver, 36", VTAC, HDMI, to ITA, HDMI
7-142891693-036
VTAC Patchcord
VTAC, Patchcord, Receiver, 36", VTAC, HDMI, to ITA, HDMI.
-
Product
AGC, SNMP, RFoG FTTB Optical receiver
RFoG4002, RFoG4004
-
Hangzhou Huatai Optic Tech. Co., Ltd.
Huatai RFoG4002 ( two-port ), RFoG4004 ( four-port ), is a type of high-grade AGC, Network management, RFoG FTTB outdoor optical receiver. Various operating parameters of machine are microprocessor-controlled, LED display. Through the keys of machine can adjust and set EQ、ATT. Optional network transponder, implement remote network management. Large dynamic range of optical AGC characteristics, RFoG4002 ( two-port ), RFoG4004 ( four-port ) high output ,for FTTC, FTTN fiber access network. As a unit of CATV network RX, is a high performance, highly flexible, cost-effective CATV optical receiver.
-
Product
Telephone Wire Cable Tester For Testing Continuity With Sender And Receiver
PHCT55
-
The PHCT55 is a two-piece item that tests telephone wire continuity. Play a test tone on one end and listen on the other, judge continuity, and diagnose break points.
-
Product
Receivers
-
Designed to demodulate IRIG destruct tones, this receiver uses an up-converting superheterodyne configuration for high dynamic range and image rejection and has a receive sensitivity of better than -107 dBm. Originally developed to monitor/verify Range Safety Command Destruct Transmitters, it is a compact rugged design usable wherever a high tolerance to shock, vibration and temperature is required.
-
Product
Cable Assembly, Receiver, QuadraPaddle, 20", 2 50-Pin Female D-Subs
540111040140
Cable Assembly
Cable Assembly, Receiver, QuadraPaddle, 20", 2 50-Pin Female D-Subs.
-
Product
Cable Assembly, Receiver, QuadraPaddle, 60", 100-Pin Male SCSI
540009010640
Cable Assembly
Cable Assembly, Receiver, QuadraPaddle, 60", 100-Pin Male SCSI
-
Product
Power, Patchcord, Receiver, 36", Mini Power, 16 AWG White, Single Ended ( 19 Amps)
7-234916000-036
Power Patchcord
Power, Patchcord, Receiver, 36", Mini Power, 16 AWG White, Single Ended ( 19 Amps).
-
Product
Low Cost Microwave Wideband APD Preamp Receivers
MR11 (40KHz~18GHz)
-
Hangzhou Huatai Optic Tech. Co., Ltd.
MR11 series microwave wideband optical receiver, adopts high Sensitivity APD diode and Low Noise Preamplifier IC, within bandwidth of 40KHz~18GHz, they are featured with excellent linearity, high responsibility and superior flatness of the RF response in both, power and phase. They provide an outstanding linearity fiber optical communication for analogue wideband microwave application. Due to avoidance of using expensive coaxial cable or wave-guide, there will be no limitation in transmission distance, which improves the signal quality and reliability of the microwave communication. They can be widely applied in microwave communication system such as remote wireless, timing and reference signal distribution, telemetry, measurement and delay line etc as well as 10Gb/s high speed communication system.
-
-
Product
VTAC, Patchcord, Receiver, 36", VTAC, Twinax, Double Ended
7-142186142-036
VTAC Patchcord
Please note: The density/ thickness of DACAR 535 wire may require a module loading pattern that includes extra slot spacing to prevent wire bend and pressure. See the VTAC User Manual for more information.
-
Product
Cable Assembly, Receiver, TriPaddle, 36", 10 Position Combicon and 4 Position Omnimate
540295010201
Cable Assembly
Cable Assembly, Receiver, TriPaddle, 36", 10 Position Combicon and 4 Position Omnimate
-
Product
IRIG Time Code Receiver & Generator for Computers (PCI Express)
TCR180PEX
-
Meinberg Funkuhren GmbH & Co. KG
The TCR180PEX receives IRIG-A/B/G, IEEE 1344, IEEE C37.118 or AFNOR NF S87-500 time codes and can be used for synchronizing the system time of its host PC. The IRIG output of this card can generate an IRIG signal for other IRIG time code readers. The output format is independent from the incoming IRIG signal - a perfect solution to your IRIG conversion requirements. It is used in applications like data acquisition, standalone computer time synchronization (for systems without a network connection or higher accuracy requirements) or as an IRIG converter device.
