Filter Results By:
Products
Applications
Manufacturers
Biconic Antennas
attenna conductors are flared into two cones diametrically opposed, sharing a common axis and vertex.
- LBA Group, Inc
product
Manpack MW Antenna
TGR-50 class
The TGR-50 class of rapidly deployable AM antennas is designed for easy transport and erection by limited personnel. No tower climbing or sophisticated lifting equipment are required for installation by a crew of three or four persons. Weight and packaging, according to model, typically permits transport by bearers, light vehicle, small boat, or helicopter. Disassembly and relocation is similarly convenient.
-
product
Biconic Logarithmic Periodic Antennas (Hybrid)
It combines the electrical properties of two antenna (biconical and Log ).
-
product
Biconic Logarithmic Periodic Antennas
Stacked LPDA
The stacked Logarithmic Periodic Dipole Antenna consists of two ordinary Log.-Per. structures. The excellent characteristics (flat gain over a large bandwidth, low SWR) of the ordinary Log.-Per. designs could be maintained using the stacked LP design. The stacked design helps to focus the directional pattern of the H-plane somewhat, resulting in a typical gain improvement of ca. 2-3 dB compared to an ordinary LPDA. This is especially important for immunity testing, where a maximum fieldstrength and a good field uniformity is required. The beamwidth in the E-plane and the H-plane are nearly identical, providing an optimised illumination of the EuT with minimised ground reflection influence. Further the STLP 9128 C has an excellent cross-polar rejection.
-
product
Antennas
Double Ridge Horn 1-18GHz RH-118. BI-LOG 30-3600MHz. Biconica 30-300MHz. LOG 200-1000MHz. TRIPLE LOOP 10KHz-30MHz.
-
product
Weather Antennas
Kratos Defense & Security Solutions, Inc.
The S- band and C- band weather radar systems are a family of advanced weather radar antenna/pedestal systems. The family of systems meets ISO 9001 specifications and consists of a number of different diameter antennas and pedestals operating in S- band or C- band frequencies. This includes the antenna system used for the NEXRAD program.
-
product
Microwave Antennas
We are engaged as leading Microwave Antenna manufacturers andexporter of a wide range of Microwave Waveguide Antenna, Waveguide Antenna, Parabolic Microwave Antenna, Conical Microwave Antenna and Pyramidal Microwave Antenna.
-
product
Bluetooth Antennas
Our portfolio of Bluetooth antennas includes products for internal/embedded mounting within IoT devices as well as externally mounted antennas for access points, gateways, and larger fixed infrastructure applications. Many of our internal/embedded Bluetooth antennas have an adhesive mounting retention type. Externally mounted antennas come in a variety of mounting styles, including direct mount to pole and mast mount options. Multiple connector and cable options are available for our customers to make the best choice for their applications Custom antenna developments are regularly undertaken to meet specific customer requirements. Our Bluetooth antenna portfolio includes products manufactured by TE Connectivity, Laird Connectivity External Antennas, and Hirschmann Car Communications.Read Less
-
product
Antennas
Is a specialized transducer that converts electric current into electromagnetic (EM) waves or vice versa.
-
-
product
Active Antennas
Is an antenna that contains active electronic components such as transistors, as opposed to most antennas which only consist of passive components such as metal rods, capacitors and inductors.
-
product
Antenna Rotator
PRO.SIS.TEL
This manual cover installation on a mounting plate inside a tower or a rotator cage with a thrust bearing. The rotator consists of a rotator and a control box unit.
-
product
Reference Antennas
Type NRD
Reference antennas are precision dipole antennas that offer a fixed 2.15 dB of gain over an isotropic antenna along the major lobe axis at specified frequencies (2.15 dBi). They are intended to be used for antenna field pattern and gain measurements, or general RF sensing in the laboratory.
-
product
Specialty Antennas
*Application and industry specific designs*Stealth radomes available on select models*Customization available
-
product
FLAT Antennas
CTG recently developed a new paradigm in linearly-polarized antennas called the Flat Lens Antenna Technology or ‘FLAT’. These antennas have directivities similar to conventional dual-ridge antennas, but in a much lighter and “flatter” package. They can be used as a direct replacement for conventional horns for a wide variety of applications. They are made using composites technology so are also rugged and are ideal for both indoor and out-door applications.
-
product
Horn Antenna
ZLB7-SJ12-40G-1015
Dual Polarized Horn Antenna, Frequency 12~40GHz, Gain 12dBi,Iso 25dB Typ., 2.92mm Female connectors, Small Size 55*55*82mm, 5G Mesurement.
-
product
Troposcatter Antennas
Kratos Defense & Security Solutions, Inc.
Troposcatter antennas consist of a reflector structure, feed assembly, and support. Reflectors are precision-formed by aluminum spinning to maintain extremely accurate contour and high performance. Back structures are hot-dip galvanized structural steel. All aluminum parts are corrosion coated and painted.
-
product
Probe Antennas
Probe antennas are offered as both standard and custom models with a rectangular waveguide interface. Probe antennas can only support linear polarization. These antennas are often used to measure the gain of other antennas by comparing the signal levels of the probe antenna and antenna under testing. The standard models operate across the full waveguide band and offer 6.5 dB nominal gain and 115 and 60 degrees half power beamwidth at center frequency. The below standard offering covers the frequency range of 8.2 to 170 GHz.
-
product
Antennas
Dual polarized 6 dBi omni-directional antenna. Included with each antenna is a unique mounting bracket that allows the Ubiquiti® RocketM2 radio to be attached directly to the antenna. Also included are a pair of 195-series low-loss cable assemblies to connect the RocketM2 to the antenna. Customers can enjoy the cost saving of these kits compared to purchasing an Ubiquiti® antenna to use with the RocketM2 radio.
-
-
product
Loop Antennas
A loop antenna is a radio antenna consisting of a loop or coil of wire, tubing, or other electrical conductor, that for transmitting is usually fed by a balanced power source or for receiving feeds a balanced load.
-
product
Antenna Switch
SixPak
The SixPak has two components: a relay matrix and a control box, there are several options for the controller.The relay matrix allows the selection of any 6 antennas by 2 radios or feedlines. Its lockout circuitry prevents both radios from selecting the same antenna. (The 6x1 type of SixPak is now replaced by our RatPak remote 6 way antenna switch.)The usual set-up has one SixPak dual rotary control box, which is manually operated from the radios positions. The control box for the 6x2 contains two rotary switches and 12 LEDs, so the operator can see which antennas are selected.
-
-
product
Antenna, Biconical
EM-6912A | 30 Mhz – 300 MHz
A balun, feedline, and element cage give the Electro-Metrics EM-6912A response curves that are almost linear, making it ideal for swept measurements. An added benefit is that the EM-6912A has an improved BALUN design, which makes it insensitive to changes of orientation while vertically polarized. Readings obtained will be the same no matter which element is closest to the ground plane, eliminating a potential source of measurement error.
-
-
product
Three Loop Antenna
VVLA-30M
The three loop antenna VVLA-30M is a standard measurement antenna according to CISPR15-2005/GB17743-2007 standard
, it can work with LISUN EMI-9KA / EMI- 9KB EMI Receiver System for EUT magnetic field radiation measurement between X, Y and Z planes. The antenna measurement is accurate, switch conveniently and it can completely replace imported products. -
product
Antenna, Biconica-log
EM-6917C-1 | 26 MHz – 1 GHz
The EM-6917C-1, a hybrid combination of the industry standard biconical and log periodic antennas, delivers an unmatched combination of frequency coverage and high power handling capability. Featuring exceptionally broad frequency coverage of 26 MHz to 1 GHz, the EM-6917C-1 eliminates the need for adjustments or switching antennas in most test applications up to 1 GHz, and it does so without compromising power handling capability for transmit applications.
-
product
Radar Antenna Positioners
CAES is a leading designer and manufacturer of custom radar antenna positioners for military airborne, ground, and naval applications.
-
product
Antenna, Wideband Discone
EM-6115 | 10 KHz – 2 GHz
The EM-6115 is a broad band collinear array allowing very wide Omni-Directional frequency coverage in a single package. Below approximately 100 MHz, the EM-6115 acts as an active vertical rod which offers 10 to 12 dB Greater unsaturated instantaneous dynamic range than competitive antennas (overload field strength: 2 V/meter) which greatly reduces intermodulation generated signals in a typical read world RF environment. In the congested spectrum above 100 MHz the antenna is passive and contributes no intermodulation products so the overload point is determined solely by the receiving instrument. This immunity to overload can often make the difference between useful signal output and an indecipherable jumble of spurious products and is accomplished without compromising sensitivity. The antenna collapses for convenient storage and transport.
-
product
Multi-Sector Antennas
*Up to 10 or more beams*Increase site capacity & data throughput*Ideal for demanding venues such as sports arenas*Provide near one-to-one ratio of capacity increase for each beam
-
product
Sector Antennas
A sector antenna is a type of directional microwave antenna with a sector-shaped radiation pattern. The word "sector" is used in the geometric sense; some portion of the circumference of a circle measured in degrees of arc. 60°, 90° and 120° designs are typical, often with a few degrees 'extra' to ensure overlap and mounted in multiples when wider or full-circle coverage is required (see photos below). The largest use of these antennas is as antennas for cell phone base-station sites. They are also used for other types of mobile communications, for example in Wi-Fi networks. They are used for limited-range distances of around 4 to 5 km.
-
product
Antenna
Beijing KeHuan Century EMC Technology Co,.LTD
Antenna is adjusted using the receiver, use, testing, measurement, etc.
