Product

3 Way GPS / GNSS Signal Splitter Passive, 1-2 GHz, SMA, DC Block+200Ω Load 3 Ports

GPS312

-

INSTOCK Wireless Components, Inc

GPS312 - INSTOCK Wireless Components, Inc

GPS L1 - L5, GLONASS, Galileo splitterLow Insertion Loss (0.3 dB avg)High Port to Port Isolation (30 dB avg)Excellent VSWR (1.10 : 1 avg)15 VDC & 75 mA max on DC block portsTri Alloy SMA Female (Jack) 50 Ohm

Product

Mini Receiver

FB7-NX

-

National RF, Inc

FB7-NX - National RF, Inc

In about 1935, the National Radio Company of Malden, Mass., brought out a “hot” high frequency receiver, called the FB7, and the subsequent FB-7X. It featured a super-hetrodyne design with plug-in coils that gave it a broad frequency range. The “X” model also incorporated a crystal filter in the intermediate frequency section, thus giving it additional selectivity. The receiver was viewed by radio amateurs as a technological breakthrough, and it was also used commercially for point to point high frequency communications. As the receiver did not have an internal RF amplifier section, a separately tunable RF amplifier was later provided in a separate enclosure for additional performance capabilities. Now, National RF, Inc., is resurrecting the fabled receiver name with an all solid-state, hot mini receiver, which also utilizes plug-in coils to cover the HF spectrum. The mini-receiver is designed for use by radio amateurs as well as serious short-wave listeners, and allows reception of AM, CW, and SSB signals. It incorporates a super-hetrodyne design with a dual gate FET built-in RF preamplifier and a ceramic filter for selectivity, often required when used in a crowded amateur radio band. In addition, the receiver has a buffered rear panel output of the high frequency oscillator for use with either a frequency counter for exact receive frequency display, or for interface with an outboard transmitter. A rear panel jack is also provided for muting the receiver when a transmitter is placed into the transmit mode. And, the receiver is small enough to fit into carry-on luggage and taken on trips when it is desired to “keep an ear” on amateur radio or other high frequency activity. The receiver utilizes rear panel plug-in coil assemblies which contain the RF amplifier, mixer, and oscillator tuned circuits. Each plug-in coil assembly also comes with a separate dial scale, which is inserted onto the front panel for displaying the tuned frequency. A very smooth 6 to 1 planetary drive is used for tuning the receiver. Other front panel controls include RF preamplifier peak, volume control, Beat Frequency Oscillator adjustment, and RF gain control. Other switches include filter bandwidth, AM/CW/SSB selection, Power, and a general coverage/band spread control for certain plug-in assemblies. The receiver is intended to drive head-phones via a rear panel jack, but has sufficient output to drive a small external speaker.

Product

Multi-function GPS/GLONASS Research Receiver

R100

-

AACE Industries

R100 - AACE Industries

The Multi-function GPS/GLONASS Research Receiver sets the standard in precision and versatility for GPS/GLONASS research. It provides highly accurate navigation, ionospheric measurement, time transfer, satellite monitoring and differential reference station capabilities. When combined with the temperature stabilized antenna it eliminates delay variations due to outside temperature, affording even greater accuracy.

Product

47~862MHz FTTP High Output CATV Optical Receiver

P9134

-

Hangzhou Huatai Optic Tech. Co., Ltd.

P9134 - Hangzhou Huatai Optic Tech. Co., Ltd.

Huatai P9134, operating bandwidth of 47 ~ 862MHz, regardless of the aircraft used for analog TV or digital TV, both with high receiver sensitivity and excellent intermodulation distortion indicators. At high optical power receiver can adjust the level by PAD, played limiting output, so P9134 at +2 dBm ~-20dBm received optical power of large dynamic the range, have excellent properties:

Product

GPS, GLONASS, Galileo Splitter 6 Way, TNC, 1000 - 2000 MHz, 50 Ohm, Passive

GPS620

-

INSTOCK Wireless Components, Inc

GPS620 - INSTOCK Wireless Components, Inc

GPS L1 - L5, GLONASS, Galileo splitterLow Insertion Loss (0.3 dB avg)High Port to Port Isolation (30 dB avg)Excellent VSWR (1.15 : 1 avg)15 VDC & 75 mA max on DC block portsTri Alloy TNC Female (Jack) 50 Ohm

Product

Standard In-door Forward Optical Receiver

HR8636

-

Hangzhou Huatai Optic Tech. Co., Ltd.

HR8636 - Hangzhou Huatai Optic Tech. Co., Ltd.

HR8636 with standard configuration is a type of high index and universal in-door forward optical receiver. It adopts Philip optical receiving module. End-grade adopts power-doubling module. Optical connectors and RF connector can be installed at the front panel or back panel.

Product

​Coaxial Receiver Protector

-

Teledyne Lincoln Microwave

Teledyne Lincoln Microwave

Where size, weight and power handling are the principle constraints, a TLM air-spaced coaxial limiter range provides an excellent compromise between waveguide and microstrip limiters. These devices are able to withstand higher power levels than microstrip solutions but still retaining a relatively compact package, Teledyne’s designs offer a low insertion loss and incorporate the same wide range of features as our waveguide limiters. Suitable for continuous operation at peak power levels of several kW's and mean power levels of 100's watts with sub- microsecond recovery time - over 10% bandwidth in <100mm length (at S-Band).

Product

ALC (AGC) FTTB Optical Receiver

BG9244x-LD

-

Hangzhou Huatai Optic Tech. Co., Ltd.

BG9244x-LD - Hangzhou Huatai Optic Tech. Co., Ltd.

Huatai BG9244x-LD product series have the bandwidth of 47~862MHz,with ALC（AGC）function, two outputs, the output level Vo=104dBμV （Pin:-7~+2dBm, APD=8dB）. The device has built-level gain and equalization adjustment, visual display about optical power, and can choose 1way or 2 ways high level output by illustration. It applies to FTTB optical access to network, is an ONU optical receiver unit of RFTV radio network with low power, high performance, high cost- effective.

Product

L Series Receiver

LR

-

Lectrosonics, Inc.

LR - Lectrosonics, Inc.

Excellent performance in a small package for ENG and DSLR video production is the purpose and intent of the LR receiver design. Tracking front-end filters block interference from high powered RF signals on nearby channels to preserve the extended operating range. RF spectrum scanning displays accurate results on the LCD to make finding clear spectrum quick and easy.

Product

136-Pin Signal Block | Receiver Side

-

ATX Hardware GmbH

ATX Hardware GmbH

Receiver pylon block 136-pin Signal block: Pyramid small (Pk) / Dagger (D)Material: 6mm EGS619Spring contact - head shape = pyramid small / daggerSleeve aligned with WireWrapNeedle projection = 4.3mm (Pk) / Needle projection = 7.2mm (D)Recommended working stroke: 2.6mmGrid dimension = 2.54mmMax. Rated current 1A

Product

High Speed Block | Receiver Side

585127

-

ATX Hardware GmbH

585127 - ATX Hardware GmbH

VGRCB-76D High-Speed Data Block receiver side- 1x HDMI connection- 1x USB 2.0 connection- 1x RJ45 connection- Screw hole diameter 2.8mm

Product

G20x - 28 Module Pull-Thru, Scalable Receiver

-

VPC

VPC

G20x offers the features of the G20 system, and adds an additional 8 modules in an extended tier for higher I/O needs. This solution uses 6.75" Series Pull-Thru Adapters.

Product

700-800 kHz and 0.25 Degree Receiver Beamwidth Multibeam Echosounder

SeaBat T51-ASV

-

Teledyne Marine RESON B.V.

SeaBat T51-ASV - Teledyne Marine RESON B.V.

​The SeaBat T51-ASV is built around the popular SeaBat® T51 and maintains the incredible SeaBat® data quality in a smaller form factor. Optimized power requirements ensure extended and crucial mission time on battery-powered vehicles. With full swath width at 700-800 kHz and 0.25° receiver beamwidth, there is no compromise between resolution and efficiency.

Product

Airborne Receivers & Bit Synchronizers

-

Lumistar Inc.

Lumistar Inc.

The Lumistar LS-28-DRSM Series Multi-Mode Multi-Band Receiver/Combiner/TM Processing Unit is designed using ruggedized packaging to survive severe airborne conditions. The LS-28-DRSM is available in several configurations: 1) Airborne receiver only (RF to bits), 2) Airborne bit synchronizer only, 3) RF to TM Processing and Display (RF to bits to UDP decom to LAN Client Displays). Models with receivers are available in any band form 200 MHz to 7 GHz with S, lower L and C bands as standards. Other RF bands are available, please consult the factory for details. This unit can be mated with other Lumistar products to provide a complete air-to-ground re-transmission system.

Product

4 Way GPS / GNSS Signal Splitter IP67 Outdoor, N Type, 1-2 GHz, 50 Ohm, Passive

GPS401

-

INSTOCK Wireless Components, Inc

GPS401 - INSTOCK Wireless Components, Inc

GPS L1 - L5, GLONASS, Galileo SplitterLow Insertion Loss (0.4 dB avg)High Port to Port Isolation (30 dB avg)Excellent VSWR (1.10 : 1 avg)15 VDC & 75 mA max on DC block portsTri Alloy N Type Female (Jack) 50 Ohm

Product

100G/200G/400G Coherent Optical Receivers

-

Discovery Semiconductors, Inc.

Discovery Semiconductors, Inc.

Discovery's Coherent Optical Receivers are designed for 100 Gb and upcoming 200 Gb and 400 Gb fiber optic communication systems. Optical Dual Polarization QPSK (DP-QPSK) and 16 QAM modulation formats are detected and converted to electrical signals that can be fed to a digital storage scope, or even a sampling scope. Our Coherent Lab Buddy is a user friendly lab instrument, which allows our customers to start doing their valuable experiments in a very short period of time.