VME Chassis
-
Product
2U Rackmount Chassis
ACP-2010
Chassis
2U Rackmount Chassis for ATX/ MicroATX Motherboard with Low-Profile Rear Bracket Option
-
Product
Mounting Flange Kit, G40x Slide Mount, for NI PXI-1085 Chassis
310113688
Mounting Kit
Mounting Flange Kit, G40x Slide Mount, for NI PXI-1085 Chassis
-
Product
Diesel Fleet Maintenance Chassis Dynamometer
MD-7500
-
At the heart of the MD-7500 is a set of three air-cooled eddy current power absorbers. Each absorber, or brake, can hold up to 600-hp (total power of 1,800-hp) more than enough to simulate a fully loaded transit bus. As the systems PAU''s (brakes) are air-cooled, no water is required to or from the device eliminating the high cost of water consumption and/or the cost of an expensive water recovery system which can sometimes exceed the cost of the dynamometer system itself. Mustang is the only company that offers a Universal Fleet Test Bed without water supply requirements.
-
Product
VPX Chassis 4U/50HP 5 Slots
-
This 5 slot Hartmann VPX 4U system chassis provides an intelligent, practical packaging solution for high-performance processors. The 50HP wide, rack-mountable enclosure for vertical mounting of boards is outfitted with a 300W ATX power supply and a 1U removable, bottom mount fan tray.
-
Product
1U Rackmount Chassis For ATX Motherboard
AX61135TM
-
*Supports 12" x 9.6"standard ATX MB*Two 4 cm system fans*Supports 1U Flex ATX power supply*Internal 2 x 3.5" HDD or internal 2 x 2.5" HDD
-
Product
Chassis Mount / Enclosed AC-DC Power Supplies
-
Chassis Mount / Enclosed AC-DC Power Supplies
-
Product
3U PCIe Gen2 ATR Style Chassis
Crosswind 600
-
PCI-Systems innovative 1-2-3 system. 1: Lab unit 2: Configure unit 3: Deploy unit! All our chassis and prototype systems can be deployed without needing to change out the chassis. Add Front and rear custom covers and full sealing and you are ready to go to qualification!
-
Product
Module for VME & VXI Systems
EXC-4000VME/xx / EXC-4000VXI/xx
-
The EXC-4000VME/xx and EXC-4000VXI/xx cards for VME & VXI systems supports up to eight dual redundant MIL-STD-1760 channels using the M4K1553Px(S)-1760 module and is compatible with all common variations of MIL-STD-1760 (A, B). Each channel can operate simultaneously as a Bus Controller and up to 32 Remote Terminals and as a Triggerable Monitor. In addition, Checksum, SRQ bit and Header Words are supported on each channel.
-
Product
6 Channel 6 kV/1 mA VME HV Power Supply
V6534
-
The V6534 is a 1-unit wide VME 6U module housing 6 High Voltage Power Supply Channels 6kV, 1mA. The board is available with either positive or negative output polarity; mixed version with 3 positive and 3 negative channels is also available.
-
Product
14-slot CH-14 PXIe-PC Chassis
-
The new CH-14 PC PXIe-PC chassis with an embedded PC allows the creation of high-performance multifunctional systems for collecting and processing large flows of information, as well as systems for monitoring and adjusting radio-electronic equipment.
-
Product
COTS VME Board Tester
-
*Developed for support of Virginia Class Submarine at the COATS Integration Facility.*Provides Stimulus and Measurement Subsystem (SMS) to control, monitor, and evaluate VME assets used in the Non-Propulsion Electronic System (NPES) of the submarine.*Provides Native Environment Subsystem (NES) that simulates the operational configuration of typical NPES installations, and permits the test and evaluation of several types of VME assets.
-
Product
Chassis For 3.5" SBC
ACK-5000
-
3.5" SBC chassis supports front & side I/O interfacesFan-based design with optional wall-mount & DIN rail bracketBottom door design for easy access on M.2 devices on 3.5" SBCFlexible cutouts I/O in the front & right-hand side: up to 7x D-SUB for COM/ GPIO/CANBus, 2x USB 2.0, 2x Audio JackEasy assembly and maintenance with standard 3.5" SBC without customizationsSupports Standard 3.5" SBC: MIO-5152, MIO-5377/R, MIO-5154, MIO-5354, MIO-5355
-
-
Product
16-Channel VME Multi-Range Digitizer
V490
-
The V490 includes 16 independent acquisition channels, each with a programmable-gain differential amplifier, analog anti-aliasing filter, 16-bit analog-to-digital converter, and digital post-processing. With a dedicated A/D converter per channel, the V490 provides true simultaneous sampling, which can be extended across multiple V490s or triggered from an external TTL signal.
-
Product
Mounting Flange Kit, G20/G20X, f/ NI PXI-1095 and PXIe-1084 Chassis
310113760
Mounting Kit
Mounting Flange Kit, G20/G20X Slide Mount, 6.75" Series Adapters, for NI PXI-1095 Chassis and NI PXIe-1084 Chassis
-
Product
Cable Kit For Synchronizing Two M9018A PXIe Chassis
Y1244A
Cable Clamp Kit
The Y1244A Cable Kit is used with M9381A PXIe vector signal generator and M9391A PXIe vector signal analyzer to synchronize two M9018A PXIe chassis.
-
Product
1U Storage Chassis For MicroATX/ATX Serverboard With 4 Hot-Swap Drive Bays For Scalable Storage Solutions.
HPC-8104
-
1U rackmount chassis support ATX/uATX motherboard4-bay hot-swappable 3.5"/2.5" SATA/SAS/SSD drive bays with ultra slim ODD bayAnti-vibration FAN designTwo front USB3.0 ports
-
Product
VME Module
VME-4SIP
-
The new VME-4SIP Module provides a 6U high performance flexible I/O scheme, that supports industry standard Industry Packs. Choose from over a 100 different Industry Packs from Alphi Tech and others.
-
Product
12-24V DC To DC Power Module MI/O-Chassis Compliant
MIOe-PWR1
-
12-24V DC to DC Power Module MI/O-Chassis compliant
-
Product
Chassis - Built as 60 or 75 ohm Matrix Configuration Switch Modules for High Bandpass
CXG Matrix
Chassis
These Chassis are built as 50 or 75 ohm matrix configurations of 4x8 or 8x8 using tree switch configuration switch modules for high bandpass. The internal matrix block is wired out to BNC, SMA or other 50 or 75 ohm connectors. LEDs on the front panel show switch and power status. Add a Control Module to complete the system.
-
Product
VME Display And Bus Analyzer Module
VM-DBA
-
VM-DBA is a new test and diagnostic module for VME-bus systems which visualizes activities on all VME bus lines on the set of front-panel LEDs, but also allows one to digitize individual waveforms of all these lines into 2kBit -long storage memories, for a subsequent readout via VME or USB interfaces.
-
Product
OpenVPX Chassis Platforms
-
With options for VITA 46/VITA 48 compliant specifications for VPX (with VITA 65 OpenVPX compliant backplanes), Pixus offers complete systems with power supply unit and backplane, fully assembled, pre-wired and tested. With a modular design approach, Pixus can offer virtually unlimited VPX chassis configurations for 3U and 6U boards. The VPX enclosures come in 1U-4U horizontal-mount (for 6U boards), 4U-5U vertical-mount (for 3U cards), and 7U, 9U, and higher chassis (for 6U OpenVPX boards).
-
Product
10U cPCI Chassis
DP-cPCI-8010
-
DP-cPCI-8010 is a Compact high performance, high reliablity 10U cPCI chassis. The DP-cPCI-8010 provides user the right platform options to meet the system integration needs. The chassis is complied with the features defined by the Compact PCI specifications, including rugged features, modular construction, integrated cooling and EMI-EMC protection. The DP-cPCI-8010 is available with high performance 4 - 21 cPCI slot backplane and with various power supply configurations.
-
Product
Rack Mount Osprey Chassis 4-Slot Unibus
0249-U
-
10.5" high by 19" wide by 20" deep (267 x 483 x 508 mm), this chassis is FCC certifiable**. AT style motherboard, 3 x 5-1/4" bays, 2 x 3-1/2" bays. Cooling fans and space are included for user's hex-height, 4-slot DD-11 Unibus backplane, PC motherboard, diskette and hard drives (one hidden and four visible half-height bays).
-
Product
VME Analog Input Module
DP-VME-1427
-
The DP-VME-1427 is a standard 6U VME based general purpose 32 channel Analog to Digital Convertor (ADC) module. The module is a slave VME 64x interface, that responds to A24/D16 standard VME address cycle. On-board auto-conversion circuitry performs all the task related to multiplexing, sampling and converting of analog input signals to the digital outputs.
-
Product
6 Channel 500 V/3 mA VME HV Power Supply
V6519
-
The V6519 is a 1-unit wide VME 6U module housing 6 High Voltage Power Supply Channels 500V, 3mA. The board is available with either positive or negative output polarity; mixed version with 3 positive and 3 negative channels is also available.
-
Product
VME Generic Carrier Card For Conduction Cooled PMC(PCIbus Mezzanine Card) Modules
AVC-2-CC
-
VME64x (6U) generic carrier card for conduction cooled PMC (PCIbus mezzanine card) with 2 PMC slots. Modular solution combines any AIM conduction cooled PMC module for ARINC429, MIL-STD-1553 or any conduction cooled 3rd party PMC module.
-
-
Product
6U VME D/S, S/D, I/O & Comm Board
64CS4
Multifunction I/O
NAI’s 64CS4 is a 6U VME multifunction I/O board designed for applications requiring Digital-to-Synchro/Resolver (D/S) stimulus output, as well as I/O and communication functions. This board contains five intelligent, function module slots. The board can be configured for 10 D/S channels, or for D/S in combination with I/O and communication modules. Additional enhancements include FIFO data buffering for select modules. Using multiple DSPs, the enhanced motherboard enables higher processing power and dedicated pre-processing control for each module.
-
Product
VME Radar Processing System
-
Signal Processor is Standard 19' rack mount chassis. 400 Hz, 3-phase, 115VAC aircraft power is available. Typical system can handle 200 MB/s (minimum) input data (also output data since we record the input data). Options include 10 GigE, Infiniband, FibreChannel or Serial FPDP. Optional 1GigEthernet for output products, parameter data, control messages, etc.
