Product

BP-1 PROBE

BP-1

-

Tinker & Rasor

BP-1 - Tinker & Rasor

Rugged ConstructionWater ResistantUnaffected by Surface CoverEasy to InstallZinc Plated Clamp (included in kit)

Product

Near Field Probes 30 MHz up to 3 GHz

RF2 set

-

Langer EMV-Technik GmbH

RF2 set - Langer EMV-Technik GmbH

The RF2 near field probe set consists of 4 passive near field probes for measurements in the development phase of the magnetic field in the range from 30 MHz to 3 GHz on electronic assemblies. The probe heads of the RF2 set allow the step by step localization of interference sources of the RF magnetic field on assemblies. From greater distances the electromagnetic interference can be detected by RF-R 400-1 and RF-R 50-1 probes. The RF-B 3-2 and RF-U 5-2 probes with their higher resolution can more precisely detect the interference sources. Field orientation and field distribution on an electronic assembly can be detected through a trained special use of the near field probe. The near field probes are small and handy. They have a sheath current attenuation and are electrically shielded. They can be connected to a spectrum analyzer or an oscilloscope with a 50 Ω input. They do not have an internal terminating resistance.

Product

Sanitary Probes

-

Omega Engineering, Inc

Omega Engineering, Inc

Used in the food, beverage, dairy, and pharmaceutical industries, these hygienic/sanitary probes carry 3-A certification, which is required in these sanitary, wash down, & clean-in-place applications.

Product

Micro probes 1 MHz up to 6 GHz

MFA 01 set

-

Langer EMV-Technik GmbH

MFA 01 set - Langer EMV-Technik GmbH

The micro probes are used to measure magnetic fields and they have a high resolution. They measure magnetic fields up to 6 GHz, e.g. at signal conductors (150µm), SMD components (0603-0201) or IC pins. The MFA micro probes are guided by hand. An amplifier stage is integrated into the probe head. The amplifier stage (9V, 100mA) is powered via the Bias tee BT 706. It has an impedance of 50 Ohm. The micro probes are connected via the Bias tee BT 706 to a spectrum analyzer or an oscilloscope. Langer EMV-Technik GmbH includes correction lines in the delivery. With the help of the correction lines the probe output voltage is converted either into the respective magnetic field or to the current which is running through the conductor.

Product

Wide Measurement Range Model Of Semi-automatic 4 Point Probe Sheet Resistance/resistivity Measurement

RT-3000/RG-2000 (RG-3000)

-

NAPSON Corp.

RT-3000/RG-2000 (RG-3000) - NAPSON Corp.

*User programable measurement pattern & programmable measuring pattern*Tester self-test function, wide measuring range*Thickness, edge, temperature correction for silicon wafer*Film thickness conversion function from sheet resistance*2 types measuring tester (S version: Standard type, H version: High range resistivity measurement type)

Product

Current Probe

DCFlex

-

Power Electronic Measurments Ltd

DCFlex - Power Electronic Measurments Ltd

The DCflex is an easy to use, low cost, thin and clip-around DC current probe. It is suitable for measuring large DC currents of >2kA. The DCflex takes a single shot measurement of the DC current with a typical accuracy of ±1%. It is important to understand that the DCflex does not provide a continuous measurement of DC current.

Product

Acute High Voltage Differential Probe, 10x/100x, 100MHz, 700V

ADP1100

-

TEAM SOLUTIONS, INC.

ADP1100 - TEAM SOLUTIONS, INC.

*USB Powered (or Power Bank)*Bandwidth up to 10 MHz*Overrange Indicator*Audible Overrange Alarm*Bandwidth Limit : 5 MHz / Full*Can be used by any DSO which has the USB port(s).*EC Declaration: EN 61010-031:2002 +A1:2008*Double-layer wire for power insulation

Product

Controlled Environment Probe Station

CG-196

-

EverBeing Int'l Corp

CG-196 - EverBeing Int'l Corp

Everbeing controlled environment probe station allows vacuum and cryogenic probing down to 77K with liquid nitrogen or high temperature probing up to 1273K. Efficient in characterizing your devices at extreme temperatures, vacuum, specific gas, etc.

Product

Transversal-Hall-Probe

-

MAGMESS Magnet-Messtechnik

MAGMESS Magnet-Messtechnik

For the Gaussmeters are several transverse Probes with different dimensionsand sensitivity available.

Product

Probe Antennas

-

ERAVANT

ERAVANT

Probe antennas are offered as both standard and custom models with a rectangular waveguide interface. Probe antennas can only support linear polarization. These antennas are often used to measure the gain of other antennas by comparing the signal levels of the probe antenna and antenna under testing. The standard models operate across the full waveguide band and offer 6.5 dB nominal gain and 115 and 60 degrees half power beamwidth at center frequency. The below standard offering covers the frequency range of 8.2 to 170 GHz.

Product

Combined RH and Temperature probe

HP3217R

-

Senseca

HP3217R - Senseca

Combined temperature and relative humidity probe. Capacitive RH sensor, Pt100 temperature sensor.

Product

External Temperature for PT100 Probe

TGP-4104

-

Gemini Data Loggers Ltd.

TGP-4104 - Gemini Data Loggers Ltd.

This data logger uses an external PT100 probe to record high temperatures. Probes are available to measure up to 300 and 600C. These are listed in the 'You will also need' section. The PT100 probes are of 3-wire construction and use class A elements, making them more accurate than their 2-wire predecessors.

Product

Wireless In-Circuit Test Fixtures

-

Circuit Check, Inc.

Circuit Check, Inc.

Higher density more complex circuit boards complicate testing requirements while smaller more tightly spaced test pads create a wiring challenge for the fixture fabricators, test engineers and maintenance personnel. Wireless fixtures solve the challenges associated with the nest of wires found in standard long wire fixtures. Wireless fixtures replace the “nest” of wires with copper traces on a multilayered printed circuit board called a Translator Board or T-Board®. Circuit Check’s wireless fixture technologies reduce test program debug and maintenance times while easing the ECO process. Thus allowing for the higher level of test performance, the ability to probe smaller denser targets and achieve ultra-high node counts.

Product

Precision Coating Thickness Gauge Probe Range

Elcometer 355

-

Elcometer Limited

Elcometer 355 - Elcometer Limited

Unique probe modules allow the Elcometer 355 Coating Thickness Gauge to be versatile and flexible for any coating thickness measurement application.

Product

RealProbe RF Probes

-

Vectria Technologies Ltd.

Vectria Technologies Ltd.

Unmatched performance In-Circuit RF Probes covering up to 18GHz. These are must tools for any in-circuit RF and Microwave testing and troubleshooting.

Product

Wireless Pressure Probe

Si-RM1

-

Sauermann Group

Si-RM1 - Sauermann Group

This Si-RM1 wireless pressure probe accurately measures high side and low side pressure.It measures relative pressure range from -1 to 60 bar and -14 to 870 psi and comes with wireless connection low energy.

Product

Temperature, Humidity, Bar. Pressure Transmitter

T7311

-

COMET SYSTEM, s.r.o.

T7311 - COMET SYSTEM, s.r.o.

Humidity, temperature probe on a cable. Measured values are also converted to other humidity interpretation: dew point temperature, absolute humidity, specific humidity, mixing ratio, specific enthalpy. Built-in pressure sensor.

Product

Mini Cryogen Free Systems

mCFMS

-

Cryogenic Ltd.

mCFMS - Cryogenic Ltd.

Cryogenic offers cryogen free measurement systems, which include a cryocooler, cryostat with superconducting magnet (3, 5, 7 or 9 Tesla), variable temperature sample space, a selection of special probes for measurements of different physical properties, as well as electronics, computer and measurement software.

Product

Stack Probing Sensor

L722

-

Wagner Electronics

L722 - Wagner Electronics

The Model L722 Stack Probing Sensor coupled with the L612 Digital Recording Moisture Meter makes it easy to reach deep into stickered units of lumber and take accurate moisture readings without the danger of broken pins. Wagner''s electromagnetic wave technology makes it possible to take multiple readings throughout an entire stack in just minutes.

Product

Temperature Calibration

-

Calmet Ltd.

Calmet Ltd.

In our temperature lab we have the capability calibrate a wide range of temperature products such as catering food probes from deli to restaurant, industrial systems for manufacturing and quality checks using thermocouples surface probes or insertion probes we also calibrate IR (Infrared) thermometers.